Project

Installation of a Sharp wall-mounted heat pump in Outremont: four-season comfort in a single-family home

In Outremont, AirGreen installed a Sharp ZHU1 18,000 BTU wall-mounted heat pump on the exterior wall of a house surrounded by greenery. Mounted on wall brackets, with enclosed connections and clearance maintained despite the vegetation, this installation provides year-round comfort, reduced energy consumption, and seamless aesthetic integration into the property's garden.

By AirGreen Climatisation & Chauffage Admin5 min read
Installation of a Sharp wall-mounted heat pump in Outremont: four-season comfort in a single-family home
Installation of a Sharp wall-mounted heat pump in Outremont: four-season comfort in a single-family home
Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

In this charming Outremont home, surrounded by greenery and large, mature trees, the owners wanted to replace their aging air conditioning system with a modern, quiet, and above all, efficient heating solution for Montreal winters. Our AirGreen team recommended the installation of aSharp wall-mounted heat pump , model Sharp ZHU1 18,000 BTU , perfectly suited to a single-family home with living areas on the ground floor and bedrooms upstairs.


A green… and demanding residential environment

The house, typical of Outremont, is covered in pale stucco with large wooden windows overlooking a well-landscaped garden. This verdant setting offers two important features for a heat pump system:

  • Heavy vegetation near the exterior walls, which can impair ventilation if the unit is poorly positioned;

  • A facade exposed to climatic variations : sun in summer, snow and cold winds in winter.

The challenge was therefore to install the outdoor unit discreetly , efficiently and sustainably , while preserving the aesthetics of the house and the health of the garden plants.


The chosen solution: Sharp ZHU1 18,000 BTU wall-mounted heat pump

We directed the owners towards a Sharp ZHU1 18,000 BTU wall-mounted heat pump , a new generation unit operating on R-32 refrigerant , known for its excellent energy efficiency and reduced environmental impact.

This Sharp model offers:

  • A power of 18,000 BTU , ideal for covering a main living area (living room, dining room, open kitchen) as well as part of the upper floor;

  • Four-season operation , capable of efficiently heating during the coldest weather while providing comfortable air conditioning during heat waves;

  • Inverter technology that continuously adjusts power, reducing temperature variations and energy consumption;

  • A reduced noise level , appreciated both inside the house and in the garden.


Details of the outdoor installation: performance and discretion

The photo shows the Sharp outdoor unit securely fixed to wall brackets on the plastered wall, slightly raised above the floor. This positioning is not accidental: it meets several technical and practical requirements.

1. Clearance from the ground and snow

By placing it at an appropriate height, we protect the unit:

  • Accumulations of snow in winter;

  • Plant debris and stagnant moisture on the ground;

  • Risk of accidental impacts (lawnmower, garden tools, etc.).

This helps to extend the life of the compressor and ensures good air circulation around the device.

2. Management of refrigeration and electrical connections

The refrigerant lines and power cable are neatly enclosed in a vertical and horizontal white conduit , perfectly aligned with the facade's style. This enclosure:

  • Protects the tubing from weathering and UV rays;

  • Improves the aesthetics of the facade by avoiding visible cables;

  • Facilitates potential service interventions.

The connection is made close to the electricity meter , which simplifies the installation of the dedicated line and the external disconnect device, in accordance with Quebec electrical standards.

3. Vegetation Management

The unit is integrated into the existing vegetation, but with calculated clearance at the front and sides to allow air to circulate freely. We advised the owners:

  • To regularly prune the shrubs and plants around the heat pump;

  • Maintain a free space of at least 30 to 60 cm all around the device;

  • Clear the area before service or cleaning periods.

Thus, the garden retains its natural charm, while ensuring maximum performance from the Sharp heat pump.


Indoor comfort: a warm house in winter, cool in summer

Inside, the Sharp wall-mounted heat pump primarily serves:

  • The living room and dining room on the ground floor, often combined in an open area;

  • Part of the upstairs corridor , facilitating the transfer of heat or coolness to the bedrooms.

The benefits for the occupants:

  • Gentle and even warmth in winter, without dry air and without sudden fluctuations;

  • Rapid air conditioning on hot days, even in direct sunlight;

  • Better humidity control , which is very welcome in a house surrounded by vegetation;

  • A significant reduction in electricity bills , especially for those who previously used inefficient electric baseboard heaters or portable devices.


An installation that meets standards and is designed for longevity

At AirGreen, we place particular importance on:

  • Regarding electrical compliance (dedicated line, circuit breaker rating, outdoor disconnect box);

  • Sizing the power according to the surface area and insulation of the house;

  • In compliance with the recommendations of the manufacturer Sharp (clearances, fixings, condensate drainage);

  • The quality of the wall supports and anchors in the masonry or plaster.

Every detail counts to ensure that the Sharp ZHU1 wall-mounted heat pump operates reliably for many years, with minimal maintenance (filter cleaning, annual inspection, clearance checks).


AirGreen, your Sharp specialist in Outremont and Greater Montreal

Whether you live in Outremont , Montreal , Laval , the North Shore or the South Shore , our team is here to:

  • Assess your heating and air conditioning needs;

  • We can offer you the Sharp wall-mounted heat pump model best suited to your home;

  • To create a clean, discreet and secure installation ;

  • We will assist you with maintenance and after-sales service.

Our mission: to offer every family four-season comfort while reducing energy consumption and environmental footprint.

The steps

How it goes, from the first call to the end

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

And at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    And at your place?

    Which type of equipment for your project?

    Pick what looks like your need.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.
    Going further

    Useful pages for what comes next

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Tell us about your house. We come and see it for free.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment