Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie (Montreal)
AirGreen installed a Sharp Eco Inverter wall-mounted heat pump on a Rosemont–La Petite-Patrie plex, offering the client 4-season comfort, reduced consumption and discreet integration into the typical Montreal brick facade.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
In Rosemont–La Petite-Patrie, brick plexes often need a comfort upgrade without compromising the facade's aesthetics. This is precisely the challenge we tackled on this project: installing aSharp wall-mounted heat pump in a typical residential building in the neighbourhood, with brick walls on the upper floors and stucco on the basement level.
Context: a need for 4-season comfort in Rosemont
The client lives in an apartment in a typical Montreal apartment building, with a semi-basement and low windows overlooking a green courtyard. His priorities were clear:
-
Staying comfortable during both the heatwaves of July and the biting cold of January.
-
Reduce your electricity bill thanks to energy-efficient inverter technology.
-
Preserve the clean appearance of the building's side facade.
-
Minimize vibrations and noise for him… and for his neighbors.
We recommended a Sharp Eco Inverter wall-mounted heat pump , a reliable and efficient single-split system, perfectly suited to a Montreal-style plex.
Choosing a Sharp wall-mounted heat pump
The Sharp brand is known for its efficient and durable wall-mounted systems. For this project, we opted for a Sharp Eco Inverter model from their wall-mounted range , a device designed to:
-
Offering excellent energy efficiency thanks to inverter technology.
-
Ensure stable and quiet operation, even under partial load.
-
Providing comfort in both air conditioning and supplementary heating during the off-season.
-
To integrate seamlessly with a discreet wall-mounted indoor unit in the home.
Sharp's combination of inverter technology and compact design allows occupants to maintain a stable temperature without sudden variations, while limiting energy consumption.
Site analysis and preparation
The outdoor unit was installed on the stucco-covered facade at garden level, beneath a red brick wall typical of Rosemont. Before anchoring anything, we:
-
Checked the wall structure to ensure secure anchoring of the supports.
-
Calculated the necessary clearances around the unit for good air circulation.
-
Planned the routing of refrigerant lines and power supply while maintaining an aesthetic focus (discreet covers and conduits).
-
The distance from the basement window and other wall-mounted equipment has been verified to comply with proper installation practices.
This planning stage is crucial: it helps to avoid problems such as amplified noise, lack of air circulation, or snow accumulation in winter.
Installation of the outdoor unit: stability, clearance and protection
The photo clearly shows that the Sharp outdoor unit is:
-
Mounted on sturdy metal wall brackets , securely anchored to the wall.
-
Raised off the ground , which protects it:
-
accumulations of snow and ice,
-
splashes of water and dirt,
-
vegetation on the ground.
-
-
Positioned with enough space at the rear and sides to allow for good air circulation and easy maintenance.
The refrigerant lines and electrical wiring are neatly routed along the wall, in dedicated conduits and covers, to maintain a clean and professional installation. The nearby electrical box is also visible, allowing for quick shutdown in case of maintenance or servicing.
A drainage pipe is positioned to carry condensation away from the wall and foundations, limiting the risk of dampness and stains on the plaster.
Integration into the building environment
The building features a mix of red brick in the upper section and stucco at the base of the facade , with a basement window and greenery at the foot of the wall. Our objective was to:
-
Keep the outdoor unit at a discreet height , without obstructing the view or hindering movement in the yard.
-
Respect the building lines: the heat pump is neatly aligned with other wall elements (boxes, air outlets).
-
Preserve the planting areas below by avoiding blowing directly onto the vegetation.
The result: a clean, straight installation, without any dangling visible cables, and perfectly integrated into the architecture of a Rosemont plex.
Comfort and performance in summer as well as winter
With its Eco Inverter technology , the Sharp wall-mounted heat pump offers several concrete advantages for a Montreal home:
-
In summer :
-
Rapid refresh of main rooms.
-
Variable compressor speed, which reduces temperature variations and limits noisy on/off cycles.
-
Better energy efficiency than a traditional air conditioner.
-
-
During the off-season and at the beginning/end of winter :
-
Comfortable supplementary heating, ideal for postponing the use of the main heating system.
-
More even heat distribution thanks to the internal wall-mounted head.
-
Combined with good insulation, this type of Sharp wall-mounted heat pump helps reduce energy costs while increasing comfort and temperature control.
Benefits for the customer
Following this installation in Rosemont–La Petite-Patrie, the client now benefits from:
-
Four-season comfort in your home, with a stable and pleasant temperature.
-
An optimized electricity bill , thanks to an energy-efficient heat pump.
-
An aesthetically pleasing outdoor installation that blends well with the facade.
-
A reliable system, installed according to best practices, facilitating future maintenance.
For us at AirGreen, the success of a project is not just about the choice of equipment, but about the overall quality of the installation: anchors, clearances, snow protection, drainage management and duct finishing are all equally important.
Why choose AirGreen for your Sharp heat pump in Montreal?
As a company specializing in residential HVAC in Greater Montreal , we:
-
We advise our clients on the correct sizing and choice of model according to the type of housing.
-
We plan each construction site taking into account the architecture of the building, the aesthetics and the constraints of the neighborhood.
-
Let's install the systems safely, sustainably and carefully , with great attention to the details visible on the facades.
-
We offer after-sales service and follow-up for long-term maintenance and performance.
Whether you live in Rosemont–La Petite-Patrie, the Plateau, Hochelaga, Verdun, Laval or on the South Shore , we can assist you in choosing and installing a Sharp wall-mounted heat pump or another system adapted to your situation.
Conclusion
This Sharp wall-mounted heat pump installation in Rosemont–La Petite-Patrie perfectly illustrates what we do on a daily basis: bringing more comfort and energy efficiency to residences in Greater Montreal, while respecting the aesthetics of the buildings and good technical practices.
If you are considering adding a wall-mounted heat pump to your home, or replacing an old air conditioner, we would be happy to advise you and offer a customized solution designed for our Quebec climate.
How it goes, from the first call to the end
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
And at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Which type of equipment for your project?
Pick what looks like your need.
Four mistakes we do not make
Flip each card to see what we do instead.
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
Useful pages for what comes next
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Tell us about your house. We come and see it for free.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).