Installation of a Sharp ZU1 Mini Split in Montreal
Transform your home with AirGreen’s Sharp ZU1 Mini Split—top-tier comfort, advanced purification, and smart technology, all tailored for you.
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Elevating Comfort and Efficiency with Sharp's Innovative Technology
In the bustling city of Montreal, where the climate ranges from icy winters to warm summers, the need for reliable and efficient heating and cooling solutions is paramount. AirGreen, a trusted HVAC company in Montréal, has recently completed a noteworthy installation of two Sharp ZU1 Mini Split systems, each boasting a robust 24,000 BTU capacity, capable of delivering exceptional comfort year-round. This installation not only emphasizes our commitment to superior technology and efficiency but also highlights our dedication to customer satisfaction and environmental responsibility.
Innovative Features of the Sharp ZU1 Mini Split
The Sharp ZU1 Mini Split systems are a perfect blend of modern design, advanced technology, and eco-friendliness, designed to meet the diverse needs of Montreal homeowners. Key features include:
- Superior Heating and Cooling: With a capacity to operate efficiently at temperatures as low as -27°C and a cooling capacity of 24,000 BTU, these systems ensure comfort in all seasons.
- Advanced Air Purification: Equipped with Plasmacluster technology, these units excel in air purification, effectively neutralizing airborne bacteria, viruses, and allergens, and removing odors and mold.
- Coanda Airflow Control: This technology enhances airflow distribution, ensuring even temperatures throughout every room without direct drafts, utilizing natural air patterns to maximize comfort.
- Energy Efficiency: Rated at 22.0 SEER with Inverter technology, the systems optimize energy use, reducing operational costs and contributing to a smaller carbon footprint.
- Smart Connectivity: With built-in WiFi, homeowners can control their indoor climate remotely, adjusting settings via a smartphone for ultimate convenience.
Project Insight and Installation Process
The recent installation in Montreal involved meticulous planning and execution by AirGreen’s certified technicians. The project site was a residential area where our team installed two Sharp ZU1 units to provide balanced heating and cooling solutions. The installation was strategically planned to leverage the existing structures for optimal unit placement, ensuring maximum efficiency and minimal aesthetic disruption.
Challenges Overcome
During the installation, our team faced the challenge of integrating the new units with the home's existing HVAC system. However, thanks to our expertise and the adaptable design of the Sharp ZU1 Mini Splits, the integration was seamless. We ensured that the indoor units were aesthetically pleasing and the outdoor units were positioned to minimize noise and maximize performance.
Client Satisfaction and Future Comfort
Post-installation feedback from the homeowner was overwhelmingly positive, noting significant improvements in air quality and comfort within their home. The addition of the Sharp ZU1 Mini Splits has not only enhanced their living environment but also reduced their energy bills, thanks to the high-efficiency rating and smart technology of these units.
Environmental Impact and Energy Savings
This installation was also notable for its environmental benefits. The Sharp ZU1 Mini Splits use R-32 Freon, a more eco-friendly refrigerant that offers lower global warming potential than traditional refrigerants. This aligns with Montreal’s environmental goals and upcoming 2025 energy regulations, making it a forward-thinking choice for eco-conscious homeowners.
Financial Benefits and Grants
The homeowner benefited financially from this installation as well, qualifying for a $2,688 LogisVert Grant by Hydro-Québec and a substantial federal grant, which significantly offset the initial costs and provided a quicker return on investment.
Why Choose AirGreen?
Opting for AirGreen means choosing a partner committed to providing high-quality, sustainable, and cost-effective HVAC solutions. We pride ourselves on our:
- Tailored Solutions: Every installation is customized to meet the unique needs and preferences of our clients.
- Expertise and Certification: Our team is highly trained and certified, ensuring that every installation is done right the first time.
- Comprehensive Service: We offer full-service solutions from consultation and installation to maintenance and support.
Conclusion
The successful installation of the Sharp ZU1 Mini Splits in Montreal serves as a testament to AirGreen's dedication to quality, innovation, and customer satisfaction. We are proud to offer advanced HVAC solutions that not only ensure comfort and efficiency but also contribute to a healthier environment.
The unit on this job, in figures
The range as published on airgreen.ca: pick a size to see its capacity in deep cold.
| Size | Heating at −8 °C | Heating at −15 °C | Coldest certified point | COP at −15 °C | SEER | HSPF | Indicative LogisVert aid |
|---|---|---|---|---|---|---|---|
| Sharp ZU1 12 000 | 14,500 | 12,000 | −27 °C: 7,200 | 2.11 | 22.0 | 11.0 | $1,740 |
| Sharp ZU1 15 000 | 18,100 | 15,300 | −27 °C: 10,100 | 2.1 | 24.0 | 11.0 | $2,172 |
| Sharp ZU1 18 000 | 22,000 | 18,000 | −27 °C: 11,500 | 2.2 | 24.0 | 11.0 | $2,640 |
| Sharp ZU1 24 000 | 22,400 | 19,000 | −27 °C: 12,300 | 2.2 | 22.0 | 11.0 | $2,688 |
According to NEEP, it delivers 14,500 BTU/h at −8 °C (17 °F), more than at 8 °C (14,000 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 7,200 BTU/h, 60% of its nominal 12,000 BTU size.
At 8 °C, its certified maximum capacity reaches 17,100 BTU/h, 42% more than its nominal 12,000 BTU size.
According to NEEP, it delivers 18,100 BTU/h at −8 °C (17 °F), more than at 8 °C (18,000 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 10,100 BTU/h, 67% of its nominal 15,000 BTU size.
At 8 °C, its certified maximum capacity reaches 21,800 BTU/h, 45% more than its nominal 15,000 BTU size.
According to NEEP, it delivers 22,000 BTU/h at −8 °C (17 °F), more than at 8 °C (21,600 BTU/h). It heats as hard in moderate cold as in mild weather.
According to NEEP, its COP at −27 °C is 1.88: the highest of the ZU1 line, which ranges from 1.79 to 1.82 at that temperature.
According to NEEP, its certified maximum capacity at −27 °C (−17 °F) is 11,500 BTU/h, 64% of its nominal 18,000 BTU size.
At −27 °C, its certified minimum capacity is 3,200 BTU/h (5,500 at 8 °C). It slows down instead of cycling on and off.
According to NEEP, its certified heating capacity at −15 °C (5 °F) is 19,000 BTU/h, 79% of its nominal 24,000 BTU size. Its COP there is 2.20.
Data read live from the airgreen.ca page of each size (NEEP / AHRI certified performance). When the title names the installed size, it is highlighted; otherwise the whole range is shown. The aid shown is today’s, using Hydro-Québec’s rule ($120 per 1,000 BTU/h at −8 °C); amounts quoted in the article date from its publication. Only Hydro-Québec confirms the assistance granted.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Baseboards and electric furnaces turn 1 kWh of electricity into 1 kWh of heat. A heat pump delivers more: that is its COP. At Hydro-Québec’s rate D (11.142¢/kWh above 40 kWh a day, since 1 April 2026):
Hydro-Québec: a heat pump can be up to three times more efficient than baseboards for heating in the colder months.
Estimate per kWh of heat, at the chosen temperature, using the certified COP from the product page. Taxes, access charge and backup heat not included.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).