Project

Installation of a Gree Free Match Extreme Multi Zone Heat Pump in Côte Saint-Luc, Montreal

A residence with a distinct layout, a homeowner with a vision, and AirGreen's expertise. Dive into a tale of three zones and perfect installation in Côte Saint-Luc.

By AirGreen Climatisation & Chauffage Admin3 min read
Installation of a Gree Free Match Extreme Multi Zone Heat Pump in Côte Saint-Luc, Montreal
Installation of a Gree Free Match Extreme Multi Zone Heat Pump in Côte Saint-Luc, Montreal
–chapters in this story
3 minreading time
–type of installation
2023year published
The tour

Take a tour of the installation

Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

The job

The Art of Perfect Installation: A Tale of Three Zones

The Setting: Côte Saint-Luc, Montreal

Nestled in the heart of Côte Saint-Luc, Montreal, a unique challenge awaited the AirGreen team. A residence with a distinct layout, three separate floors, and a homeowner with a vision. The mission? To seamlessly integrate a Gree Free Match Extreme Multi Zone Heat Pump into the fabric of the home.

The Machine: Gree Free Match Extreme

Before diving into the intricacies of the installation, let's shed some light on the star of the show: the Gree Free Match Extreme. This Triple Zone Heat Pump is not just any machine. It boasts:

  • Heating Capacity: Even at a chilling -35°C, this machine doesn't break a sweat.
  • Efficiency: A remarkable 23.0 SEER.
  • Connectivity: WiFi included, ensuring you're always in control.
  • Warranty: A comprehensive 10-10-10 warranty, with an extended warranty included.
  • Sound: A subtle 62.0 dB(A) sound pressure level for the exterior unit.
  • Eco-friendly: Uses R-410A gas, ensuring a reduced carbon footprint.

The Challenge: Three Zones, One Vision

Our client envisioned three separate 12,000 BTU heads, one for each floor. While the basement and first floor presented a straightforward task, the second floor was a puzzle. The homeowner's dream was to have the head unit in the living room, ensuring even cooling and heating across the entire floor. But the layout of the second floor was the polar opposite of the other two.

The Solution: Craftsmanship and Collaboration

Our team, known for its dedication and expertise, took on the challenge head-on. We navigated through two separate rooms on the second floor, ensuring the head unit found its perfect spot in the living room. But our commitment didn't stop there. We collaborated with a professional plasterer who worked magic post-installation. With gyprock and fresh color-matched paint, the final result was nothing short of a masterpiece. It was as if the machines had always been there, waiting to breathe life into the home.

The Bonus: A Generous Federal Grant

Our client was not only thrilled with the installation but also with the financial benefits. The Gree Free Match Extreme model qualifies for a $5000 Federal Grant, making it a win-win situation. The cherry on top? The machine's ability to heat even at -35°C, ensuring comfort even in the harshest Montreal winters.

The Aftermath: Happy Neighbors and New Contracts

Our client's satisfaction echoed through Côte Saint-Luc. So much so, that a neighbor was quick to sign a contract with us, entrusting AirGreen with their central heat pump system installation.

Why Choose AirGreen?

Our recent installation in Côte Saint-Luc is a testament to our commitment, expertise, and the lengths we go to ensure customer satisfaction. From understanding unique requirements to collaborating with skilled professionals, we ensure every installation is a story worth telling.

The steps

The big day, step by step

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

What would it look like at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Going further

    Your own project, step by step

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Every house has its constraints. We see them before we install.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment