Installation of a Gree Vita Wall-Mounted Heat Pump in Delson, South Shore
Discover how AirGreen's expert installation of the Gree Vita in Delson transforms home comfort—efficiency and control at your fingertips!
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
A Commitment to Quality and Comfort with Every Installation
AirGreen is proud to showcase our recent installation of the Gree Vita Wall-Mounted Heat Pump at a residential property in Delson on Montreal's South Shore. This installation not only demonstrates our commitment to delivering high-quality HVAC solutions but also highlights the cutting-edge technology and customer-focused service we provide.
Unveiling the GREE VITA: A Blend of Efficiency and Aesthetics
The GREE VITA model stands out for its remarkable features that cater specifically to the needs of modern homes and businesses. Here are some of the key characteristics of the GREE VITA 2024 model:
- Cooling and Heating Capacity: Rated at 9,000 BTU with the capability to heat efficiently down to -20°C, making it ideal for the Canadian climate.
- Energy Efficiency: With a 19.5 SEER rating, this model is designed for optimal energy use, reducing both your carbon footprint and utility bills.
- Operational Quietness: Engineered to operate quietly, the interior unit has a sound level of 26 dB in low mode, ensuring a disturbance-free environment.
- Smart Features: Equipped with WiFi connectivity, allowing users to adjust settings remotely via their smartphones, enhancing convenience and energy management.
- Eligibility for Subsidies: This model qualifies for a $300 LogisVert Grant by Hydro-Québec, making it an economically advantageous option for homeowners.
Installation Spotlight: Overcoming Challenges with Innovation
The recent installation in Delson posed unique challenges due to the specific layout of the home and the client’s need for a discreet yet powerful solution. Our skilled technicians ensured that the installation was seamless and tailored to the architectural nuances of the property. The outdoor unit was strategically placed to minimize visual impact while maximizing performance, and additional considerations were made to integrate the system aesthetically with the home's existing decor.
The indoor unit, featuring dimensions of 32.88 x 7.88 x 10.81 inches, was installed high on a living room wall to provide optimal air distribution without compromising the room’s aesthetic. The chosen location also allows for easy maintenance access, ensuring the longevity and reliability of the unit.
Why Homeowners Choose AirGreen for Their HVAC Needs
AirGreen stands apart in the HVAC industry not just for our technical expertise but also for our holistic approach to customer service and satisfaction. We understand that installing a heat pump is a significant investment for homeowners, which is why we provide:
- Detailed Consultation: Every installation begins with a thorough consultation to understand the specific needs and preferences of our customers.
- Customized Solutions: We customize every installation to maximize comfort, efficiency, and aesthetic appeal.
- Professional Service: Our certified technicians are equipped with the latest tools and training to ensure high-quality installation and maintenance services.
- Long-term Support: We offer comprehensive warranties and after-sales support to give our customers peace of mind.
Conclusion: The AirGreen Promise
Choosing the Gree VITA 2024 for your home is more than just an upgrade—it's a step towards smarter, more efficient, and more comfortable living. At AirGreen, we are dedicated to enhancing your indoor environments with our innovative solutions and expert installations. Trust us to bring you the best in HVAC technology with unmatched customer care.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).