Installation of a Senville Wall-Mounted Heat Pump in Baie-D'Urfé
Discover how AirGreen expertly installed a Senville Heat Pump in Baie-D'Urfé, ensuring client satisfaction and subsidy success. Choose expertise. Choose comfort.
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
A Step Towards Sustainable Comfort
In the picturesque community of Baie-D'Urfé, a recent installation by AirGreen, a leading HVAC company in Montréal, showcases the epitome of efficiency, comfort, and sustainability. This project not only exemplifies our expertise in handling medium-difficulty installations but also highlights our commitment to ensuring our clients benefit from local incentive programs, such as the Hydro-Québec LogisVert subsidy.
Client's Unique Request
Our journey began when a client, who had independently acquired a Senville 18,000 BTU Wall-Mounted Heat Pump, sought our professional expertise. The client's proactive approach was commendable, yet they were aware of the critical need for a certified company to undertake the installation to qualify for Hydro-Québec's subsidy. AirGreen stepped in to bridge this gap, ensuring the client could maximize their investment through the subsidy program.
The Installation Process
- Team Expertise: Our skilled team of two technicians embarked on this task, equipped with the necessary tools and knowledge to navigate the installation's unique challenges.
- Materials and Billing: It was understood from the onset that the client would provide the materials, with AirGreen supplementing additional materials as required. Transparency in billing and materials usage was paramount, ensuring the client was well-informed and satisfied every step of the way.
- Client Satisfaction: The hallmark of this project was not just the seamless installation but the joy and satisfaction of our client. Their gratitude towards having a professional, hassle-free installation that also qualified for the LogisVert subsidy was immense.
Senville Heat Pump: A Closer Look
Choosing a Senville Wall-Mounted Heat Pump is not just about selecting a heating and cooling solution; it's about investing in a lifestyle of comfort, efficiency, and environmental responsibility. Here are a few reasons why:
- Energy Efficiency: With an 18,000 BTU capacity, this heat pump is designed for optimal energy use, significantly reducing electricity bills and contributing to a greener planet.
- Comfort in Every Season: Whether it's the chill of winter or the heat of summer, the Senville heat pump maintains your home's comfort levels with ease.
- Quiet Operation: Known for its whisper-quiet operation, it ensures your home remains a peaceful sanctuary.
- Durability: Senville's reputation for durable and reliable HVAC solutions means investing in peace of mind for years to come.
Why Choose AirGreen for Your HVAC Needs?
AirGreen stands out in the HVAC industry for several reasons, each contributing to our reputation as the preferred choice for installations across Montréal, Laval, Longueuil, and the North and South Shores.
Certified Expertise
Our technicians are not just skilled; they are certified professionals who understand the nuances of HVAC systems and the requirements of subsidy programs like Hydro-Québec's LogisVert. This knowledge ensures that every installation we undertake is compliant, efficient, and tailored to meet our clients' needs.
Customer-Centric Approach
We believe in a customer-first philosophy. From the initial consultation to the final walkthrough of the installation, our team ensures transparency, communication, and satisfaction. Our clients' testimonials speak volumes of their trust and satisfaction in our services.
Commitment to Quality and Efficiency
Quality and efficiency are not just buzzwords for us; they are the pillars of our service delivery. We use only the best materials, coupled with the latest techniques, to ensure every installation is performed to the highest standards.
Join the AirGreen Family
Choosing AirGreen for your HVAC needs means choosing a partner committed to your comfort and satisfaction. Our portfolio of successful installations, including the unique project in Baie-D'Urfé, is a testament to our dedication to excellence. We invite you to explore our work, understand our ethos, and join the myriad of satisfied customers who have made AirGreen their go-to HVAC company.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).