Shipping weight
Bradford White sheet C1412 lists an approximate shipping weight of 48 lb for the LE110U3.
Bradford White sheet C1412 lists an approximate shipping weight of 48 lb for the LE110U3.
The tank stands 17 1/2 in from floor to top with a 16 in jacket diameter.
It recovers 6 US gallons per hour at a 100 °F rise with its single 1,500 W element.
The tank is tested at 300 psi and rated for 150 psi working pressure.
It travels upright. Measure the ceiling at the spot and the narrowest door on the way.
Unit: 17.5 in tall (445 mm), 16 in across (406 mm), about 48 lb shipping weight. The clearances the manufacturer requires are checked on site.
The year it was made is on the tank’s rating plate. Enter it.
Manufacturers announce a 10 to 15 year life. Many insurers require replacement after 10 or 12 years and may refuse a water damage claim past that age (CAA-Québec). Check your policy.
AirGreenFree visit and quote, electrical connection (RBQ licence 5645-9605-01, subclass 16), start-up.
PlumberWater connections and relief valve by a master pipe-mechanic (CMMTQ).
YouA photo of the rating plate, the spot and the stairs saves us a trip.
Manufacturer data. Detailed sources at the bottom of the page.
No. Hydro-Québec’s LogisVert guide (version 1.10, September 15, 2026) lists no water heater among its eligible measures. At quote time we check other programs that could apply to your address.
To 60 °C, as the Québec government recommends, to limit bacterial growth. At shower and tub valves, the Construction Code caps the water at 49 °C: that is the job of the valve or a thermostatic mixing valve.
AirGreen does the visit, the electrical connection under its RBQ licence (subclass 16) and the start-up. The water connections are done by a master pipe-mechanic (CMMTQ).
Free on-site estimate, written quote. Send a photo of your current tank and its plate, and we prepare the visit.
Book my free estimateCosts shown are indicative estimates before tax.
When fitting out a staff kitchenette, a bar or a service counter, hot water is often the forgotten item. The main water heater is at the other end of the building, and extending a line all the way there takes time, opens walls and gives water that is slow to arrive. The Bradford White LE110U3-1NCL commercial electric water heater offers a more direct solution: a 10 US gallon tank (8 imperial gallons, 38 L) installed near the sink, producing its own hot water. AirGreen installs it in offices, businesses and restaurants in Montreal, Laval, Longueuil, the South Shore and the North Shore.
In a commercial renovation, every metre of piping has a price and every wall opening stretches out the work. A local tank avoids those detours. All it needs is a cold water supply, an electrical circuit and a discharge point for the relief valve. Hot water then travels a very short distance to the tap, which limits waiting and waste.
This solution also helps when a leased space simply has no hot water, or when the main water heater barely keeps up with existing demand and you do not want to overload it with a new fixture.
Two figures describe what the unit can deliver. First, its 10 US gallon reserve, available immediately. Second, its recovery: according to Bradford White, the 1,500 W element heats 6 US gallons per hour at a 100 °F rise. For a kitchenette or a bar sink, that is a good balance: the reserve covers filling a sink or a series of rinses, then the unit recovers during quieter moments.
If the sink is used to wash dishes without interruption, or if several fixtures must be supplied, a larger tank or a higher power rating will be preferable. We do that calculation with you based on actual use before recommending a model.
The LE110U3-1NCL runs on a single 1,500 W element, single-phase only. It is a modest load that connects easily to an existing commercial panel. For this series, the manufacturer’s limitations table provides for power ratings from 1,500 W to 6,000 W depending on voltage, and from 1,500 W to 3,000 W only at 120 V; conversion kits are listed for 120, 208, 240, 277, 380, 480 V.
The exact voltage of the unit delivered and the circuit that will supply it are confirmed in our written quote, after we check your panel. We make the electrical connections under our RBQ licence.
At 16 in. in diameter and 48 lb empty, the LE110U3-1NCL fits in a closet, under a sturdy shelf or in a utility room next to the sink. When space is tight, we confirm the unit’s exact height with the manufacturer before ordering. Once filled, the tank is considerably heavier: it must rest on a surface able to carry it and be firmly secured.
The relief valve, mandatory on every tank, must be connected to a compliant discharge, and the element must remain accessible for service. Those details, more than the size of the unit, often determine the right location.
The inside of the tank is lined with Vitraglas with Microban, an antimicrobial technology, and the factory-installed dielectric fittings limit corrosion between the piping and the tank. The standard element is copper; an INCOLOY-type element, more resistant to corrosion, is available on request. We recommend it when the building’s water is particularly hard.
According to Bradford White’s documentation, all models are ETL listed, and applicable models are CSA verified for energy performance in accordance with C191.1-M90. The "3" suffix in the model number corresponds to the 3-year limited tank warranty and 1 year on parts.
AirGreen is a family business established in Montreal, active for more than fifteen years in heating, ventilation and air conditioning and holder of RBQ licence 5645-9605-01 (ventilation, refrigeration and electrical). In a renovation project, we coordinate with your contractor so the water heater is planned at the right time. Our work includes:
We work in Montreal, from downtown to Griffintown and Mile End, in Laval, Longueuil, Saint-Bruno and throughout the South Shore and the North Shore.
Request your free on-site estimate for the Bradford White LE110U3-1NCL. You will receive a detailed written quote, and financing options are available for your project.