Fantech HRV SHR 1200 Air Exchanger | Montreal, Laval, Longueuil, South Shore and North Shore

In stock
SKU: SHR 1200
HRV
01 · Good to know

What you should know about this one

Published, verifiable facts, not brochure claims.

1200 cfmSHR 1200 code: 1200 cfm class at 0.4 in

According to the Fantech manual, the number in the SHR code gives the airflow at 0.4 in and the S means side ducting. The brochure gives 1215 cfm at 0.4 in for the SHR 1200, on a 120 V circuit (11.2 A).

BPMRecirculation defrost available with the BPM module

Standard defrost shuts down the supply fan. With the optional BPM bypass module, offered on SHR models only, a motorized damper closes the fresh-air intake so indoor air circulates through the core without creating negative pressure.

ExhaustIt defrosts by pausing the fresh air for a few minutes

In cold weather, the supply fan stops for a few minutes while the exhaust keeps running, so warm indoor air thaws the core. During the cycle the house is briefly under negative pressure; if you have a fireplace or a naturally vented combustion appliance, mention it to our estimator.

HRVIt recovers heat, not moisture

Excess moisture leaves the house. In Québec, that's the right choice in most cases: in winter, a home almost always has too much humidity, not too little.

LifetimeThe core warranty

The core does the work and is the most expensive part to replace. Motors and parts: 3 years.

02 · Installation

What it needs on site

Side connectionSide ports
Condensate drainRequired
252 lbUnit weight
120 VPower supply

In a condo with no floor drain, or with little ceiling clearance, we usually look at a side-port model instead. Our estimator checks the location, the drain and the duct route before ordering.

Complete spec sheetData and cited sources
Type
HRV
Connection
Side ports
Condensate drain
Required
Defrost cycle
Exhaust only (supply fan off)
Filters
Washable MERV 3 filters (exhaust and supply); MERV 8 or MERV 13 upgrade
Weight
252 lb
Power supply
120 V
Warranty — core
Lifetime
Warranty — motors
3 years
Warranty — parts
3 years
Spec sheet (French)
PDF
Spec sheet (English)
PDF

The manufacturer doesn't publish an efficiency at −25 °C for this model; we don't make one up.

Talk to an HVAC technician before you choose

We calculate the airflow room by room, check the location and the drain, and give you an installed price. Balancing is measured at commissioning, not estimated.

Fantech SHR 1200: 1,215 cfm for restaurants and busy rooms

The Fantech SHR 1200 is designed for spaces where many people are present at the same time: dining rooms, meeting rooms, classrooms, busy shops. Fantech's brochure gives 1,215 cfm at 0.4 in. for this light commercial HRV, on a 120 V circuit.

This is a commercial unit: the Fantech SHR 1200 has no HVI rating, so no net airflow or efficiency certified in the residential sense. The ventilation calculation for your premises is what tells us whether it is the right size.

SHR 1200 code: the 1,200 cfm class

According to Fantech's manual, S stands for side connections (Side Ducting), H for heat recovery and R for the remote control option; the number gives the airflow class at 0.4 in. The SHR 1200 draws 11.2 A on 120 V: a dedicated circuit must be planned.

An example from Fantech's brochure

Fantech describes the case of a pub in Manitoba: the code required 7.5 cfm of outdoor air per person, so a full room of 150 people called for 1,125 cfm. The designers chose an HRV from the SHR series, connected so that it exhausts air from the washrooms and brings fresh air into the dining room. That is exactly the kind of calculation we do for your space.

Efficiency and power consumption

The brochure lists a sensible effectiveness of 55% in heating, based on the core's AHRI 1060 data, for a power draw of 1,340 W, or about 0.9 cfm per watt at 0.4 in. Setting the unit to the calculated airflow rather than to the maximum keeps that consumption down.

Defrost

By default, the SHR defrosts by stopping the fresh air fan. The BPM bypass module, offered as an option and available only on SHR units, changes the approach: from −5 °C, a motorized damper blocks the fresh air, the exhaust fan stops and the supply fan switches to high speed to circulate room air through the core. Fantech specifies that there is then no negative pressure in the building.

Installation: weight, connections and drain

The SHR 1200 weighs 252 lb according to the brochure. The Fantech documents we have do not give the cabinet dimensions: we confirm them before planning the installation. The manual specifies that a kitchen range hood must never be connected to it. For service, the motors and the core slide out on removable sliding rails, and the reversible door panels open on the accessible side. A drain is required. Condensate, including during defrost, must flow to a drain or a condensate pump, with a P-trap in the hose to keep odours from coming back up. The unit and its condensate hoses must be located in a heated space, above freezing.

Filter maintenance

Washable MERV 3 filters protect both airstreams of the Fantech SHR 1200. For better filtration of outdoor air, Fantech offers MERV 8 or MERV 13 filters; according to the brochure, the MERV 13 captures 50% of particles from 0.3 to 1 micron. A finer filter adds resistance: we take that into account when balancing.

Fantech's manual calls for checking and cleaning the filters once a month, or sooner if they look dirty. The motors are factory balanced and lubricated for life: they require no maintenance.

Warranty

Fantech warranty: core warranted for life, motor and electrical components warranted for 3 years. The manual points out that connecting a clothes dryer, a kitchen range hood or a central vacuum to the unit voids the warranty.

Installation by AirGreen in Greater Montreal

Choosing a commercial HRV starts with a calculation, not a catalogue. We assess the outdoor air required for the occupancy of your premises; in a large home, we follow the room-by-room calculation of the CSA F326 standard. The Fantech SHR 1200 is chosen only if that airflow falls within its operating range.

After installation, we set the speeds and dampers so that the fresh air and the exhaust air match the calculated airflow, then we give you the measured values. They then serve as a reference during maintenance visits: if the airflow drops, we know right away by how much.

Our teams work in Montreal, Laval, Longueuil, the South Shore and the North Shore. For a free quote, call 514 316-2973 or write to sales@airgreen.ca.