Lifebreath 2500ERV-EFD ERV Air Exchanger | Montreal, Laval, Longueuil, South Shore and North Shore

In stock
SKU: 2500ERV-EFD
ERV
01 · Good to know

What you should know about this one

Published, verifiable facts, not brochure claims.

EFDExterior rooftop version, connections under the cabinet

The 2500ERV-EFD installs on a roof, on an optional curb (53-2500). The two connections to and from the building are under the unit, and two 28 × 18 in hoods with screens are included. The 2500ERV-IFD is the indoor version.

42 inPanels on both sides, 42 in clear on the electrical side

Removable service panels are on both sides of the cabinet and the membrane core slides out of either side. Lifebreath calls for 42 in of clearance on the electrical-panel side.

ExhaustIt defrosts by pausing the fresh air for a few minutes

In cold weather, the supply fan stops for a few minutes while the exhaust keeps running, so warm indoor air thaws the core. During the cycle the house is briefly under negative pressure; if you have a fireplace or a naturally vented combustion appliance, mention it to our estimator.

ERVIt moves moisture too, not just heat

An ERV transfers some moisture between the two airstreams. Useful in a house that gets too dry in winter or takes on a lot of humidity in summer. The trade-off: it generally recovers less heat than a comparable HRV.

5 yearsThe core warranty

The core does the work and is the most expensive part to replace. Motors and parts: 2 years.

02 · Installation

What it needs on site

Condensate drainRequired
715 lbUnit weight
220 VPower supply

In a condo with no floor drain, or with little ceiling clearance, we usually look at a side-port model instead. Our estimator checks the location, the drain and the duct route before ordering.

Complete spec sheetData and cited sources
Type
ERV
Condensate drain
Required
Defrost cycle
Exhaust only (supply fan off)
Filters
4 pleated 4 in filters (18 × 24 in), 2 per airstream
Weight
715 lb
Power supply
220 V
Warranty — core
5 years
Warranty — motors
2 years
Warranty — parts
2 years
Spec sheet (French)
PDF
Spec sheet (English)
PDF

The manufacturer doesn't publish an efficiency at −25 °C for this model; we don't make one up.

Talk to an HVAC technician before you choose

We assess your needs on site, check the location and the drain, and give you an installed price. Balancing is measured at commissioning, not estimated.

Lifebreath 2500ERV-EFD: a rooftop ERV for large buildings

The Lifebreath 2500ERV-EFD is an energy recovery ventilator designed for outdoor use: it sits on the roof and exchanges heat and water vapour between the stale air going out and the fresh air coming in. It is aimed at buildings that need a lot of fresh air and whose mechanical room has no space left: schools, gyms, big-box stores, air-conditioned office buildings.

The HVI directory does not rate this commercial model: it publishes neither a certified net airflow nor a recovery efficiency measured by the residential method for it. The figures that follow come from the 2500ERV-EFD spec sheet, its product page and Lifebreath's 2500 series manual.

EFD: Exterior, Connections Under the Cabinet

The name sums up the spec sheet: a fan defrost unit designed for exterior installation. It rests on a roof curb sold as an option (part 53-2500), and its two air connections, to and from the building, are under the cabinet. Two 28 × 18 in. hoods with screens are supplied on the side of the unit; the 2500ERV-IFD is the indoor version.

The panels, made of 22-gauge powder-coated G60 galvanized sheet steel, are mounted on a 16-gauge galvanized frame insulated against condensation with 1.0 in. of fibreglass. At the bottom, two stainless steel drain pans with 1/2 in. (12 mm) NPT spouts collect the water.

Airflow and Efficiency

Lifebreath's spec sheet gives the 2500ERV-EFD 2,000 cfm at 1.0 in. of external static pressure, and its product page lists it at 2,500 cfm at 0.6 in. The sheet credits it with 58% efficiency at 2,500 cfm, without saying under what test conditions. Heat and water vapour are transferred through a single large cross-flow enthalpy core, AHRI certified (68-2501), which slides out of the cabinet from either side.

Power and Controls

Each airstream has its own direct-drive centrifugal blower, driven by a 1.0 HP single-shaft PSC motor; these motors have three speeds, two of them available. The manual explains that the high and medium settings are obtained by swapping, on each motor, the red low-speed wire and the blue medium-speed wire, and that low speed is then no longer available. The unit comes in 208 V and 240 V single-phase; the amperage, minimum circuit ampacity and protection are given on the nameplate of the unit ordered. Lifebreath states that a special inspection is required for the 208 V version. As an option, Lifebreath offers a two-speed remote control, and the built-in microprocessor board has interlock contacts.

Installation: Weight and Clearance

At 715 lb (324 kg), the unit calls for checking the roof structure, planning its curb and organizing the lift well before installation day. Lifebreath's curb tolerates no more than 1/16 in. of slope per linear foot in any direction; its perimeter is insulated but not its interior, so that heat from the building keeps the drain lines and pans from freezing. Removable service access panels open on both sides of the cabinet, and, on the electrical panel side, Lifebreath wants 42 in. of clear space.

A Rooftop ERV: What to Plan For

On a flat roof, the 2500ERV-EFD frees up the mechanical room and avoids cutting through walls for outdoor hoods, since its hoods are built in. It does, however, need a roof that can carry the unit on its curb and access for service, which is done through the side panels. When it drops below −3°C outside, a defrost timer kicks in: it cuts the supply motor while the stale air melts the frost off the core, and the meltwater drains from the pans through the bottom drain connections. According to Lifebreath, the units in this series meet CSA and UL standards.

Filters and Maintenance

In each airstream, two 4 in. thick pleated filters, each 18 × 24 in. (457 × 610 mm), catch the dust, for four in all; the spec sheet does not give their MERV rating. The manual calls for inspecting them and replacing them as needed, cleaning the hood screens, checking that the condensate drains freely and cleaning the core with a vacuum or a jet of low-pressure air, never washing it. According to Lifebreath, the service interval ranges from one to two months where the air is heavy with smoke to six months or a year for a meeting room ventilated for CO2.

Warranty

Lifebreath warrants the enthalpy core of the 2500ERV-EFD for 5 years and replacement parts for 2 years; the motors have no separate warranty on the spec sheet.

Installation by AirGreen in Greater Montreal

Before settling on the 2500ERV-EFD, we assess the building's ventilation needs on site, space by space. We then compare those needs with the airflow curves on its spec sheet and with the static pressure of the planned duct system.

On start-up day, the first adjustment is the balance between the two airstreams, because Lifebreath requires the volume of fresh air to equal the volume of exhaust air. We then show the person in charge of the building how to switch speeds and at what point to replace the filters.

Ask for a quote at 514 316-2973 or sales@airgreen.ca: we will call you back. AirGreen serves Montreal, Laval, Longueuil, the North Shore and the South Shore, with its team under RBQ licence 5645-9605-01.