Lifebreath 730 ERV-ECM ERV Air Exchanger | Montreal, Laval, Longueuil, South Shore and North Shore

In stock
SKU: 730 ERV-ECM
ERV
01 · Good to know

What you should know about this one

Published, verifiable facts, not brochure claims.

680 cfm680 cfm at high speed in the 530 cabinet

Lifebreath lists 680 cfm at high speed for the 730 ERV-ECM, versus 550 cfm for the 530 ERV-ECM, in the same 35.5 × 29 × 32.25 in cabinet. Both use two 68-280 enthalpy cores and four rectangular 14 × 8 in connections.

ECMTwo 3-speed ECM motors, optional remote speed control

The -ECM suffix marks its two 1/3 HP electronically commutated motors, 3-speed, 120 V (15 A protection). A remote speed control is available as an option.

ExhaustIt defrosts by pausing the fresh air for a few minutes

In cold weather, the supply fan stops for a few minutes while the exhaust keeps running, so warm indoor air thaws the core. During the cycle the house is briefly under negative pressure; if you have a fireplace or a naturally vented combustion appliance, mention it to our estimator.

ERVIt moves moisture too, not just heat

An ERV transfers some moisture between the two airstreams. Useful in a house that gets too dry in winter or takes on a lot of humidity in summer. The trade-off: it generally recovers less heat than a comparable HRV.

5 yearsThe core warranty

The core does the work and is the most expensive part to replace. Motors and parts: 2 years.

02 · Installation

What it needs on site

Side connectionSide ports
260 lbUnit weight
35.5 × 29 × 32.25 inLength × depth × height
120 VPower supply

In a condo with no floor drain, or with little ceiling clearance, we usually look at a side-port model instead. Our estimator checks the location, the drain and the duct route before ordering.

Complete spec sheetData and cited sources
Type
ERV
Connection
Side ports
Defrost cycle
Exhaust only (supply fan off)
Filters
2 in pleated MERV 8 filters (exhaust and supply); MERV 13 upgrade (65-194R)
Dimensions (L × D × H)
35.5 × 29 × 32.25 in
Weight
260 lb
Power supply
120 V
Warranty — core
5 years
Warranty — motors
2 years
Warranty — parts
2 years
Spec sheet (French)
PDF
Spec sheet (English)
PDF

The manufacturer doesn't publish an efficiency at −25 °C for this model; we don't make one up.

Talk to an HVAC technician before you choose

We assess your needs on site, check the location and the drain, and give you an installed price. Balancing is measured at commissioning, not estimated.

Lifebreath 730 ERV-ECM: 680 cfm without a bigger cabinet

The Lifebreath 730 ERV-ECM moves more air than the 530 ERV-ECM in exactly the same cabinet. This commercial energy recovery ventilator, rated at 680 cfm on high speed, is meant for spaces whose fresh-air needs go beyond what the 530 delivers, without taking up more ceiling space: a clinic, a daycare or air-conditioned offices, for example. Lifebreath recommends it where summers are hot and humid and air conditioning runs a lot, because its cores send part of the moisture brought in by the fresh air back outside with the exhaust air, which takes load off the air conditioner.

Since it is not listed in the HVI directory, the 730 ERV-ECM has no certified net airflow that would allow a comparison with a residential model. Instead, we start from your space's ventilation needs to confirm that it fits.

680 cfm in the 530's Cabinet

Lifebreath lists the 730 ERV-ECM at 680 cfm on high speed and the 530 ERV-ECM at 550 cfm. Both models share a 35.5 × 29 × 32.25 in. cabinet weighing 260 lb (118 kg), two 68-280 enthalpy cores and four 14 × 8 in. collars. Each cross-flow, AHRI 1060 certified core transfers heat and water vapour from one airstream to the other, and comes out for cleaning.

ECM Motors and Power Use

Two 1/3 HP, 2,000 rpm electronically commutated motors, one per airstream, each drive a centrifugal blower and offer three speeds on 120 V. On high speed, at 0.5 in. of pressure, the 730's spec sheet gives 570 W, more than double the 240 W the 530's sheet lists under the same conditions. Protection is 15 A, and the unit's nameplate shows its amperage and minimum circuit ampacity. A remote speed control can be added as an option, and the three speeds let the airflow be set to the needs assessed at your site.

Efficiency

As with the 530, the 730's spec sheet presents efficiency as curves, sensible, total winter and total summer, plotted from 300 to 700 cfm, and gives no percentage at a specific airflow.

Installation: Weight, Connections and Clearance

For construction, Lifebreath uses 22-gauge prepainted G60 galvanized steel and foil-faced insulation where exterior condensation calls for it. The unit ships without brackets or threaded rods: the installer supplies them to hang it. Lifebreath notes that the 730 ERV-ECM is easily reversed in the field, and its electrical box can go on either side. Against frost, a temperature sensor periodically shuts down the fresh-air motor, with no drain needed. Lifebreath asks for 30 in. (760 mm) of clear space at the front access doors.

Controls and Access

Its microprocessor board has built-in interlock contacts, used to tie its operation to another unit in the building. For service, the blowers slide out of the unit, and doors give access at both the front and the back. Lifebreath states that the unit meets CSA and UL standards.

Filter Maintenance

The fresh air and the stale air pass through 2 in. pleated MERV 8 filters. These filters are washable: Lifebreath's manual calls for cold water and a mild detergent, sometimes after as little as one or two months of use, and at least once every six months. For finer filtration of the outdoor air, Lifebreath offers the MERV 13 upgrade, part 65-194R.

Warranty

Manufacturer's warranty: 5 years on the 730 ERV-ECM core, 2 years on replacement parts. For the motors, Lifebreath does not publish a separate warranty term.

Installation by AirGreen in Greater Montreal

Before settling on the 730 ERV-ECM, we assess the ventilation needs of the space on site and, in a home, those of the bedrooms, bathrooms, kitchen and basement. That assessment tells us whether the 730 fits or whether a smaller or larger Lifebreath model is called for.

Outdoors, our two hoods, the fresh-air intake and the stale-air exhaust, stay at least 10 ft (3 m) apart and 18 in. (46 cm) or more above the snow line or the ground, with mesh openings of at least 1/4 in., as Lifebreath's manual requires, so that the exhausted air does not come back into the unit. After installation, we measure the fresh air and the exhaust air on the ducts and balance them, since Lifebreath requires the volume of air coming in to equal the volume the unit exhausts.

Ask for a quote at 514 316-2973 or write to us at sales@airgreen.ca: we will call you back. AirGreen installs the 730 ERV-ECM in Montreal, Laval, Longueuil, the North Shore and the South Shore, with its team under RBQ licence 5645-9605-01.