Lifebreath 1200 FD HRV Air Exchanger | Montreal, Laval, Longueuil, South Shore and North Shore

In stock
SKU: 1200 FD
HRV
01 · Good to know

What you should know about this one

Published, verifiable facts, not brochure claims.

FDFD version: exhaust-air defrost, no damper

The FD suffix (Fan Defrost) marks the version without a damper: supply air is interrupted while exhaust air defrosts the cores. The 1200 DD, in the same cabinet, adds a damper and a defrost-air port to pass indoor air through the cores.

30 A120 V circuit with 30 A maximum protection

Its two 1/2 HP PSC motors draw 18.8 A in total at high speed. The sheet gives a minimum circuit ampacity (MCA) of 23.5 A and a maximum overcurrent protection (MOP) of 30 A, to plan at the electrical panel.

ExhaustIt defrosts by pausing the fresh air for a few minutes

In cold weather, the supply fan stops for a few minutes while the exhaust keeps running, so warm indoor air thaws the core. During the cycle the house is briefly under negative pressure; if you have a fireplace or a naturally vented combustion appliance, mention it to our estimator.

HRVIt recovers heat, not moisture

Excess moisture leaves the house. In Québec, that's the right choice in most cases: in winter, a house almost always has too much humidity, not too little.

15 yearsThe core warranty

The core does the work and is the most expensive part to replace. Motors and parts: 2 years.

02 · Installation

What it needs on site

Side connectionSide ports
Condensate drainRequired
253 lbUnit weight
33.25 × 42 × 32.25 inLength × depth × height
120 VPower supply

In a condo with no floor drain, or with little ceiling clearance, we usually look at a side-port model instead. Our estimator checks the location, the drain and the duct route before ordering.

Complete spec sheetData and cited sources
Type
HRV
Connection
Side ports
Condensate drain
Required
Defrost cycle
Exhaust only (supply fan off)
Filters
Washable MERV 6 filters (exhaust and supply); MERV 13 upgrade (65-195-6R)
Dimensions (L × D × H)
33.25 × 42 × 32.25 in
Weight
253 lb
Power supply
120 V
Warranty — core
15 years
Warranty — motors
2 years
Warranty — parts
2 years
Spec sheet (French)
PDF
Spec sheet (English)
PDF

The manufacturer doesn't publish an efficiency at −25 °C for this model; we don't make one up.

Talk to an HVAC technician before you choose

We assess your needs on site, check the location and the drain, and give you an installed price. Balancing is measured at commissioning, not estimated.

Lifebreath 1200 FD: three cores and defrost without a damper

The Lifebreath 1200 FD is aimed at premises that need a lot of fresh air but where the mechanical side has to stay simple: a warehouse with offices, a workshop, a multipurpose room or a big-box store. Lifebreath rates it at 1,200 cfm nominal at 0.5 in., with blowers of 1,200 cfm (566 L/s) free air delivery, three aluminum cores and a defrost that does without a damper. The manual does, however, require a heated space, with a surrounding temperature that never falls below 16 °C (60 °F): in a warehouse or a workshop, we therefore find it a heated room or area.

Not listed in the HVI directory, which rates residential units, the 1200 FD offers no certified net airflow that could be set against that of a home model. If the unit is to provide a dwelling's principal ventilation, article 9.36.3.9 of the Québec Construction Code requires it to be certified: CAN/CSA-C439 testing with certification by HVI or by another body accredited by the Standards Council of Canada, or ANSI/AHRI-1061 testing with certification by a body the Code designates. In a large home, we therefore check this point first.

FD version: defrost with exhaust air

FD stands for Fan Defrost. When the outdoor temperature drops below −3 °C (27 °F), the automatic defrost shuts off the supply fan, and the exhaust fan, which keeps running, melts the frost on the cores with the warm air leaving the building. The 1200 DD, in the same cabinet, adds a damper and a defrost-air port to pass indoor air through the cores.

During each defrost, air therefore keeps leaving with no fresh air to replace it; from the factory, Lifebreath programs a 4-minute defrost after each 30-minute run period. In a large space, it is a trade-off we judge case by case; in a newer, tight building, we look at the 1200 DD instead.

30 A protection to plan at the panel

Two double-shaft 1/2 HP PSC motors, at 1,625 rpm and 9.4 A each: 18.8 A in total on high speed. On 120 V, the 1200 FD spec sheet and Lifebreath's sales table both give 23.5 A as the minimum circuit ampacity and 30 A as the maximum overcurrent protection. The manual, for its part, has the circuit sized to the full load amperage shown on the nameplate: that is the value we note before preparing the circuit at the panel.

Efficiency and power use

Three 68-222 cores, AHRI 1060 certified and arranged in modular counter-flow sections, recover the heat from the exhaust air. On the spec sheet, Lifebreath gives the temperature effectiveness only as a curve, with no figure stated for a given airflow; only its sales table lists 58% at 0 °C, and with no associated airflow. On high speed, total power use reaches 2,256 W: the speed is therefore set to the airflow required, not to maximum.

Installation: connections, weight and drain

Four rectangular 20 × 8 in. connections (508 × 200 mm), a cabinet 33.25 in. wide, 42 in. deep and 32.25 in. high, and 253 lb on the scale (303 lb shipping): the installation needs planning. Brackets and threaded rods, used to hang it, are not included. The drain is required: two 1/2 in. OD outlets (12 mm), which the manual has connected through a P-trap. The 22-gauge prepainted galvanized steel (G60) gets foil-faced insulation where it is exposed to exterior condensation. Leave 30 in. (762 mm) in front of the unit for service.

Controls and access

The three speeds depend on the unit's microprocessor circuit board, whose built-in interlock contacts can tie it to another piece of equipment. The blowers slide out of the cabinet, and the front and back doors, with a movable electrical box, make the unit field reversible. On standards, Lifebreath states CSA and UL conformity.

The 1200 FD and the 1200 DD share the same cabinet, the same motors and the same 20 × 8 in. connections: only the defrost mode changes. The choice therefore comes down to how tight the building is and what shares the space, not to capacity.

Filter care

Each airstream has its own filtration: the Lifebreath 1200 FD filters the incoming fresh air and the outgoing stale air with washable MERV 6 filters. To clean them, Lifebreath wants only cold water and a mild detergent. If the outdoor air needs finer filtration, Lifebreath offers a MERV 13 upgrade (65-195-6R).

Warranty

The 1200 FD core is warranted for 15 years by Lifebreath. Replacement parts, motors included since the spec sheet does not list them separately, are warranted for 2 years.

Installation by AirGreen in Greater Montreal

Before proposing the Lifebreath 1200 FD, we assess on site how much outdoor air is needed: according to use and occupancy for commercial premises or, in a large home, according to the home's ventilation needs (bedrooms, bathrooms, kitchen, basement). We also check the space, the electrical supply and the duct route.

Outside, the two hoods need at least 10 ft (3 m) between them, and each must offer enough free area to keep the air below 1,000 ft/min (5.08 m/s): at 1,200 cfm, this limit from the manual weighs on the choice of hoods. Lifebreath also calls for inspecting ducts, hoods and grilles at least every six months, and never letting more than six months go by between two drain services.

The job ends with balancing: with the unit on high speed, we measure both airstreams and set the fresh air to match the exhaust air. We work in Montreal, Laval, Longueuil, the North Shore and the South Shore, under AirGreen's RBQ licence 5645-9605-01. Ask for a quote by calling 514 316-2973 or by writing to sales@airgreen.ca: we will call you back.