Lifebreath 2000 IFD HRV Air Exchanger | Montreal, Laval, Longueuil, South Shore and North Shore
What you should know about this one
Published, verifiable facts, not brochure claims.
IFDI for interior: 18 × 22 in connections on the ends
The 2000 IFD is designed for indoor installation, set on the floor or hung from threaded rods (not included). Its four 18 × 22 in connections are on the ends, whereas the 2000 EFD, the rooftop exterior version, connects from underneath and comes with hoods.
575 VFive power supplies, from 208 V single-phase to 575 V three-phase
The 2000 IFD comes in 208 or 240 V single phase (SP) and 208, 460 or 575 V three phase (3P), depending on the order code. Its two belt-drive blowers have adjustable pulleys, and the sheet gives 2000 cfm at 1.0 in.
ExhaustIt defrosts by pausing the fresh air for a few minutes
In cold weather, the supply fan stops for a few minutes while the exhaust keeps running, so warm indoor air thaws the core. During the cycle the house is briefly under negative pressure; if you have a fireplace or a naturally vented combustion appliance, mention it to our estimator.
HRVIt recovers heat, not moisture
Excess moisture leaves the house. In Québec, that's the right choice in most cases: in winter, a house almost always has too much humidity, not too little.
15 yearsThe core warranty
The core does the work and is the most expensive part to replace. Motors and parts: 2 years.
What it needs on site
In a condo with no floor drain, or with little ceiling clearance, we usually look at a side-port model instead. Our estimator checks the location, the drain and the duct route before ordering.
Complete spec sheetData and cited sources
- Type
- HRV
- Connection
- Side ports
- Condensate drain
- Required
- Defrost cycle
- Exhaust only (supply fan off)
- Filters
- 4 pleated MERV 8 filters (16 × 25 × 2 in), 2 per airstream
- Dimensions (L × D × H)
- 66.75 × 57 × 39 in
- Weight
- 740 lb
- Power supply
- 220 V
- Warranty — core
- 15 years
- Warranty — motors
- 2 years
- Warranty — parts
- 2 years
- Spec sheet (French)
- Spec sheet (English)
The manufacturer doesn't publish an efficiency at −25 °C for this model; we don't make one up.
Talk to an HVAC technician before you choose
We assess your needs on site, check the location and the drain, and give you an installed price. Balancing is measured at commissioning, not estimated.
Lifebreath 2000 IFD: 2,000 cfm in the mechanical room
When the roof is not an option, the Lifebreath 2000 IFD brings the capacity of the 2000 indoors: this commercial heat recovery ventilator sits on the floor or hangs from the structure, and its spec sheet gives it 2,000 cfm (940 L/s) against an external static pressure of 1.0 in. It suits a school, an arena, an office building or a big-box store with a mechanical room.
The 2000 IFD does not appear in the HVI directory, which rates residential units: no rating lets it be compared, figure for figure, with a residential model. Where it would ventilate dwelling units, we first check that it holds the efficiency certification that article 9.36.3.9 of the Québec Construction Code requires for their principal ventilation system.
IFD: Interior, 18 × 22 in. Connections on the Ends
The I stands for interior. For mounting, it is installed on the floor or hung from threaded rods with brackets, which Lifebreath does not supply, and the manual requires it to be level so the pans drain properly. Its four 18 × 22 in. (457 × 558 mm) connections are on the ends, two at the inlet and two at the outlet, whereas the 2000 EFD, the rooftop version, connects from underneath. FD indicates defrost by shutting off the fresh-air motor while the exhaust air defrosts the core; below −3 °C (27 °F), the manual runs a one-minute pause, four minutes of exhaust only and 30 minutes of full operation, or 20 minutes with DIP switch 8 set to ON.
At this size, the ducts to the outdoors are large, and the 2000 IFD does not come with its hoods: the contractor supplies them. The manual calls for 10 ft (3 m) or more between the two hoods, a height of at least 18 in. (46 cm) above grade or the snow line and a 1/4 in. mesh screen, no finer, since a finer one would clog; air must not exceed 750 ft/min through them. We plan these ducts, with insulation of at least R-4 (RSI 0.75), from the technical visit onward.
Five Power Supplies by Order Code
The 2000 IFD is ordered in 208 or 240 V single-phase, or in 208, 460 or 575 V three-phase. The 208 and 240 V versions use two 2.0 HP ODP motors, the 460 and 575 V versions two 1.5 HP TEFC motors. Electrical values: per the nameplate of the unit ordered. We confirm your building's voltage with you before ordering.
Efficiency and Belt-Drive Blowers
Eight aluminum cores, mounted in cross-flow, handle heat recovery. Lifebreath lists an efficiency of 65% at 2,000 cfm, a figure its commercial sales sheet gives at 0 °C with no other measurement condition. Two belt-drive centrifugal blowers, one per airstream, each have an adjustable pulley: by changing the pitch of the motor pulley, the airflow of each airstream is adjusted separately. The manual then requires an amperage reading, with the doors closed and the ducts connected, to make sure no motor exceeds its rated amperage.
Installation: Weight, Cabinet and Drain
The unit weighs 740 lb (336 kg), and 870 lb shipping. Its 22-gauge steel cabinet, powder-coated against corrosion, has metal-lined sides and roof panels insulated with 1 in. of fibreglass. Two galvanized steel drain pans each have a 1/2 in. connection, and a drain is required: on the floor, the unit is raised enough for the drain lines to have their slope. To service the cores, the manual recommends at least 40 in. (1 m) clear on one side of the unit.
2000 IFD or 2000 EFD: Depending on the Space Available
The 2000 IFD and the 2000 EFD have the same eight cores, the same belt-drive blowers and the same airflow of 2,000 cfm at 1.0 in. The choice depends on location: in a mechanical room heated to at least 16 °C (60 °F), the IFD avoids roofing work; on a flat roof with no room inside, the EFD is the way to go. In both cases, we plan the lift and the structure before installation.
Controls
According to the spec sheet, a microprocessor board runs the unit, and its built-in interlock contacts let it be tied to other equipment, such as an air handler or a furnace. On standards, Lifebreath declares the series compliant with CSA and UL requirements.
Filter Care
Each airstream passes through two 16 × 25 × 2 in. pleated filters rated MERV 8, for four filters to replace. On each visit, we also check the belts and pulleys. The manual also provides for taking out the cores, which slide out of the unit, for routine maintenance.
Warranty
The heat recovery core of the 2000 IFD is covered for 15 years; replacement parts, for 2 years. The spec sheet does not set the motors apart from the other parts.
Installation by AirGreen in Greater Montreal
A commercial HRV is chosen from the building's actual needs: we assess on site the outdoor air your premises require, based on their occupancy. The Lifebreath 2000 IFD is the right fit when that need falls within its airflow range; otherwise, we steer the project toward another Lifebreath size.
Once the unit is connected, balancing is done with a Pitot tube: we work the pulleys and the duct dampers until the two airstreams match, and we leave you the airflows we measured. At the next maintenance visit, those figures serve as a point of comparison to spot any drop in airflow.
Ask for a quote at 514 316-2973 or sales@airgreen.ca: we will call you back. Our teams work in Montreal, Laval, Longueuil, the South Shore and the North Shore, under AirGreen's RBQ licence 5645-9605-01.
