Lifebreath 455 FD HRV Air Exchanger | Montreal, Laval, Longueuil, South Shore and North Shore
What you should know about this one
Published, verifiable facts, not brochure claims.
FDFD version: defrost without damper or indoor-air port
The FD suffix (Fan Defrost) marks the version without a damper: supply air is interrupted while exhaust air defrosts the core. The 455 DD, in the same cabinet, adds a damper and a defrost-air port that route indoor air to the core.
14 × 8 inFour rectangular 14 × 8 in duct connections
Ducts connect to four rectangular 14 × 8 in openings rather than round collars. Front and back access doors and an electrical panel that can be moved to either side let the installer choose the duct direction. Plan for 30 in of service clearance.
ExhaustIt defrosts by pausing the fresh air for a few minutes
In cold weather, the supply fan stops for a few minutes while the exhaust keeps running, so warm indoor air thaws the core. During the cycle the house is briefly under negative pressure; if you have a fireplace or a naturally vented combustion appliance, mention it to our estimator.
HRVIt recovers heat, not moisture
Excess moisture leaves the house. In Québec, that's the right choice in most cases: in winter, a house almost always has too much humidity, not too little.
15 yearsThe core warranty
The core does the work and is the most expensive part to replace. Motors and parts: 2 years.
What it needs on site
In a condo with no floor drain, or with little ceiling clearance, we usually look at a side-port model instead. Our estimator checks the location, the drain and the duct route before ordering.
Complete spec sheetData and cited sources
- Type
- HRV
- Connection
- Side ports
- Condensate drain
- Required
- Defrost cycle
- Exhaust only (supply fan off)
- Filters
- Washable MERV 6 filters (exhaust and supply); MERV 13 upgrade (65-195-6R)
- Dimensions (L × D × H)
- 33.25 × 29 × 28.75 in
- Weight
- 145 lb
- Power supply
- 120 V
- Warranty — core
- 15 years
- Warranty — motors
- 2 years
- Warranty — parts
- 2 years
- Spec sheet (French)
- Spec sheet (English)
The manufacturer doesn't publish an efficiency at −25 °C for this model; we don't make one up.
Talk to an HVAC technician before you choose
We assess your needs on site, check the location and the drain, and give you an installed price. Balancing is measured at commissioning, not estimated.
Lifebreath 455 FD: the 455 without a defrost damper
Same cabinet as the 455 DD, simpler mechanics: the Lifebreath 455 FD is a commercial HRV with no damper and no defrost air port. At free air delivery, in other words with no ducts to slow the air down, its centrifugal blowers reach 500 cfm (236 L/s); Lifebreath lists it at 437 cfm of nominal airflow in its commercial table. That is the airflow range of offices, neighbourhood shops, meeting rooms and large homes that need more fresh air than a residential air exchanger supplies.
The Lifebreath 455 FD is not in the HVI directory, where residential units are rated: HVI gives it no net airflow and no efficiency at −25 °C. Yet article 9.36.3.9 of the Québec Construction Code requires the principal ventilation of a dwelling to rely on an HRV or ERV tested to a recognized test standard and certified by a designated body; for a home, we confirm this point before choosing the 455 FD.
FD defrost, without a damper
FD stands for Fan Defrost. As soon as the outdoor air drops below −3 °C (27 °F), defrost kicks in: the unit interrupts the fresh air and lets the warmer exhaust air melt the ice. The 455 DD adds a motorized damper and a port that sends indoor air through the core during defrost.
At the factory setting, the cycle calls for 4 minutes of defrost for every 30 minutes of operation. During those 4 minutes, exhaust continues with no fresh air to make up for it. In a very tight building, or if combustion appliances share the space, we take this brief depressurization into account before choosing the FD over the DD.
14 × 8 in. connections and access from both sides
No round collars on the 455 FD: its ducts connect to four rectangular openings, each 14 × 8 in. (356 × 200 mm). Its access doors, at the front as well as the back, and its electrical box, which can be moved from one side to the other, let the ducts be oriented to suit the room. Lifebreath calls for 30 in. of service clearance.
Efficiency and power use
Lifebreath publishes the 455 FD's temperature effectiveness as a curve, for exhaust air at 40% relative humidity, with no figure tied to a specific airflow. Its commercial table adds a single value, 58% at 0 °C, without saying at what airflow it was measured. The aluminum core, modular in two counter-flow sections, combines two AHRI 1060 certified 68-222 HEX cores.
Its two three-speed 1/6 HP PSC motors draw 3.8 A in total on high speed, or 437 W according to the spec sheet. It runs on 120 V, with a minimum circuit ampacity of 4.8 A and a maximum overcurrent protection of 15 A.
455 FD dimensions, weight and drain
Its measurements: 33.25 in. wide, 29 in. deep, 28.75 in. high, for 145 lb. It hangs on support brackets held by threaded rods, which Lifebreath does not supply. On the condensate side, the drain is mandatory and the unit offers two 12 mm (1/2 in.) OD connections. Made of 22-gauge G60 prepainted galvanized steel, the cabinet stands up to corrosion, and its foil-faced insulation blocks exterior condensation where it could form. The blowers slide out of the cabinet and the microprocessor circuit board includes interlock contacts.
Filter care
In the Lifebreath 455 FD, the outdoor air coming in and the indoor air going out both pass through washable MERV 6 filters. To clean them, Lifebreath calls for cold water and a mild detergent, nothing more. Lifebreath also offers MERV 13 filters, part 65-195-6R, for finer filtration of the fresh air.
Warranty
The 455 FD core is warranted for 15 years by Lifebreath. Replacement parts, motors included since the spec sheet does not list them separately, are warranted for 2 years.
Installation by AirGreen in Greater Montreal
For commercial premises, we assess on site the outdoor air their occupancy requires; in a large home, we look at the bedrooms, bathrooms, kitchen and basement. The Lifebreath 455 FD is only chosen if those needs match what it delivers.
The drain deserves particular care. Lifebreath calls for a P-trap formed with the plastic tee connector, then 1/2 in. rigid tubing, with fittings and tubing not included. The trap and tubing sit below the bottom of the door, then slope down 1/4 in. per foot away from the unit; the whole condensate line must be protected from freezing. On the electrical side, the manual recommends a separate 15 A / 120 V circuit and a grounded outlet, with no extension cord, and wants the circuit sized to the full load amperage (FLA) shown on the nameplate.
At start-up, we balance the fresh air and the exhaust air to the target airflows, with the unit on high speed as Lifebreath requires. After that, the manual calls for core servicing anywhere from every one or two months to at least every six months depending on how the premises are used, and a drain check at least every six months; it also recommends keeping a maintenance log for the unit.
Our team, under AirGreen's RBQ licence 5645-9605-01, works in Montreal, Laval, Longueuil, the South Shore and the North Shore. Ask for a quote at 514 316-2973 or sales@airgreen.ca: we will call you back.
