Lifebreath 650 FD HRV Air Exchanger | Montreal, Laval, Longueuil, South Shore and North Shore

In stock
SKU: 650 FD
HRV
01 · Good to know

What you should know about this one

Published, verifiable facts, not brochure claims.

FDFD version: four connections, no defrost port

The FD suffix (Fan Defrost) marks the version without a damper: supply air is interrupted while exhaust air defrosts the core. It keeps four connections, whereas the 650 DD adds a 20 × 8 in port for indoor defrost air.

20 × 8 in20 × 8 in rectangular connections

Lifebreath gives a standard 20 × 8 in duct size, but its sheet also lists 26 × 8 in for the stale-air intake: we check that dimension on the unit before ordering the transitions. The low-profile cabinet is meant for installation above a suspended ceiling, on brackets and threaded rods (not included).

ExhaustIt defrosts by pausing the fresh air for a few minutes

In cold weather, the supply fan stops for a few minutes while the exhaust keeps running, so warm indoor air thaws the core. During the cycle the house is briefly under negative pressure; if you have a fireplace or a naturally vented combustion appliance, mention it to our estimator.

HRVIt recovers heat, not moisture

Excess moisture leaves the house. In Québec, that's the right choice in most cases: in winter, a house almost always has too much humidity, not too little.

15 yearsThe core warranty

The core does the work and is the most expensive part to replace. Motors and parts: 2 years.

02 · Installation

What it needs on site

Side connectionSide ports
Condensate drainRequired
270 lbUnit weight
54 × 42 × 24.75 inLength × depth × height
120 VPower supply

In a condo with no floor drain, or with little ceiling clearance, we usually look at a side-port model instead. Our estimator checks the location, the drain and the duct route before ordering.

Complete spec sheetData and cited sources
Type
HRV
Connection
Side ports
Condensate drain
Required
Defrost cycle
Exhaust only (supply fan off)
Filters
Washable MERV 6 filters (exhaust and supply); MERV 13 upgrade (65-195-6R)
Dimensions (L × D × H)
54 × 42 × 24.75 in
Weight
270 lb
Power supply
120 V
Warranty — core
15 years
Warranty — motors
2 years
Warranty — parts
2 years
Spec sheet (French)
PDF
Spec sheet (English)
PDF

The manufacturer doesn't publish an efficiency at −25 °C for this model; we don't make one up.

Talk to an HVAC technician before you choose

We assess your needs on site, check the location and the drain, and give you an installed price. Balancing is measured at commissioning, not estimated.

Lifebreath 650 FD: four connections and a low cabinet for the ceiling space

To ventilate an office floor without losing headroom, the Lifebreath 650 FD slips in above a suspended ceiling: Lifebreath designed its low, 24.75 in. cabinet for exactly this kind of installation. It is a commercial HRV whose blowers are rated at 950 cfm free air delivery, and which Lifebreath's commercial table lists at 630 cfm nominal. That same low height makes it useful in stores, clinics and community halls.

The Lifebreath 650 FD is not part of the HVI directory; you will therefore find neither net airflow nor recovery efficiency there for it, unlike residential HRVs. When the project is a home, we keep in mind article 9.36.3.9 of the Québec Construction Code, which calls for a unit certified to a recognized test standard for the principal ventilation of a dwelling.

FD version: four connections, no defrost port

FD stands for Fan Defrost: below −3 °C (27 °F) outside, the unit shuts off the fresh air and lets the exhaust air defrost the core, in cycles of 4 minutes every 30 minutes at the factory setting. The 650 FD therefore keeps four connections, whereas the 650 DD adds a 20 × 8 in. port to send indoor air through the core. Fewer ducts above the ceiling, fewer moving parts, a simpler installation layout.

The trade-off is that exhaust continues with no fresh air during each defrost cycle. In a very tight building, we therefore compare it with the 650 DD before deciding.

Watch the stale-air intake

Three of the connections are 20 × 8 in.; for the stale-air intake, the spec sheet shows 26 × 8 in., a dimension we check on the unit from the very start of the duct design. The front and back access doors, which make the unit field reversible, make it easier to route the ducts in a crowded ceiling space.

Efficiency and power use

Six counter-flow aluminum core sections, AHRI 1060 certified, handle the heat recovery. Lifebreath publishes the efficiency as a curve, with no figure tied to a specific airflow; only its commercial table puts forward a number, 84% at 0 °C, and it does not say at what airflow. On each airstream, a double-shafted motor drives two blowers positioned in suction.

According to the spec sheet, the two 1/4 HP PSC motors draw 912 W in total on high speed. Plan for a 120 V circuit: minimum circuit ampacity of 9.5 A, maximum overcurrent protection of 15 A. For the current drawn by the motors, go by the unit's nameplate: Lifebreath's documents do not agree on that figure.

Installation: dimensions, weight and drain

Dimensions: 54 in. wide, 42 in. deep, 24.75 in. high. Weight: 270 lb. The unit sits on support brackets hung from threaded rods, which Lifebreath does not supply. A drain is mandatory; its connections are 1/2 in. OD. Galvanized and prepainted (G60, 22 gauge), the cabinet steel is built to hold up against corrosion, and foil-faced insulation is fitted wherever the outer wall could sweat. Leave 30 in. of service clearance; the blowers slide out of the cabinet.

Controls and access

A microprocessor circuit board, with its interlock contacts, sets the three speeds and is used to interlock the unit with other equipment. The 650 FD and the 650 DD share the same cabinet and the same motors: defrost is what sets them apart. Lifebreath declares the unit compliant with CSA and UL standards.

Filter care

On this model, washable MERV 6 filters protect both airstreams of the Lifebreath 650 FD; you take them out, wash them, put them back: no cartridge to buy again. Lifebreath offers an optional MERV 13 filter, part number 65-195-6R; we recommend it for premises facing a busy street.

Warranty

Lifebreath warrants the heat recovery core of the 650 FD for 15 years and replacement parts for 2 years; the spec sheet gives no separate term for the motors, which therefore follow the parts warranty.

Installation by AirGreen in Greater Montreal

Before recommending the Lifebreath 650 FD, we assess on site the outdoor air your premises need, based on their use and occupancy, or, in a large home, the needs of the bedrooms, bathrooms, kitchen and basement. We also look at the clearance in the ceiling space, the electrical supply and the duct route.

The ceiling space has to remain a heated space: Lifebreath does not want the air around the unit to drop below 16 °C (60 °F), and the drain must also stay above freezing. We connect it to a separate circuit, as the manual recommends. Outside, the two hoods, one for fresh air and one for exhaust air, are kept at least 10 ft (3 m) apart and 18 in. (46 cm) or more above the ground or the snow.

The job ends with balancing: with the unit on high speed, we measure the fresh air and the exhaust air with a Pitot tube, the method the manual describes, and adjust them to the target airflows.

We work in Montreal, Laval, Longueuil, the North Shore and the South Shore, under AirGreen's RBQ licence 5645-9605-01. Ask for a quote at 514 316-2973 or write to sales@airgreen.ca: we will call you back.