GENERAL AIRSTAGE CENTAURI R32 Electric Furnace | 1.5 Tons - 18000 BTU

In stock
SKU: 217290593
16,100BTU/h of heat at −8 °C (certified)
−21 °Ccoldest published heating point
$1,932LogisVert grant (Hydro-Québec)
ENERGY STAR® · cold climateR-32Optional Wi-Fi12-year compressor warranty
Talk to a technician · 514 316-2973
Indoor unit (air handler)AMUH18KUAS
Outdoor unit (heat pump)AOUH18KUAS1
AHRI certificate217290593

GENERAL AIRSTAGE CENTAURI AMUH18KUAS 18,000 BTU electric furnace, installed in downflow in the closet of a house without a basement

When a house has no basement, the electric furnace is often in a ground-floor closet and blows downward, into the ducts under the floor. Its replacement has to do the same. The GENERAL AIRSTAGE CENTAURI 18,000 BTU (1.5-ton) electric furnace does it by heating first with a Heat Pump: the AMUH18KUAS air handler takes the old furnace’s place, and the AOUH18KUAS1 outdoor unit captures heat outside.

On the Fujitsu AIRSTAGE twin page, you will find exactly these two models. It is the same machine, described by the same manufacturer’s sheet and covered by the same warranty; only the manufacturer’s name changed on January 1, 2026, when Fujitsu General Limited became GENERAL Inc.

In this closet, two things make the difference. The manufacturer’s UTD-DFMSB1 downflow kit lets the air handler be mounted so it blows toward the floor, like the old furnace. And the unit has a built-in leak detection system: for a machine that lives in the middle of the house, a few steps from the rooms you live in, that is no small detail.

GENERAL or Fujitsu AIRSTAGE: the same machine

The company was founded in 1936 and so marks 90 years in 2026; as for the GENERAL name, it has used it as a brand since 1946. What is new is that it becomes the corporate name. The buyout dates from August 2025, and the buyer knows heating: Paloma Rheem Holdings, which has had Rheem in its fold since 1988. As of January 1, 2026, Fujitsu General goes by the name GENERAL Inc. The factories run as before, Kawasaki remains the head office and R&D hub in Japan, and each AIRSTAGE product retains its number and its warranty.

Since February 2026, Rheem Canada has been marketing the range from coast to coast; we, for our part, keep ordering from Groupe Master. Since the Fujitsu brand is leaving the market gradually, both names refer to the same machine for a while: that is why we publish both product pages, which the table compares without a single value differing.

SpecificationGENERAL AIRSTAGEFujitsu AIRSTAGE
Indoor unitAMUH18KUASAMUH18KUAS
Outdoor unitAOUH18KUAS1AOUH18KUAS1
AHRI certificate217290593217290593
Nominal capacity18,000 BTU18,000 BTU
RefrigerantR-32R-32
Power supply208/230 V208/230 V
SEER219.219.2
HSPF210.510.5
EER212.212.2
Heating capacity at −8 °C16,100 BTU16,100 BTU
COP at −8 °C2.912.91
Heating capacity at −15 °C17,300 BTU17,300 BTU
COP at −15 °C2.402.40
Heating down to (manufacturer operating range)−21 °C−21 °C
ENERGY STARYesYes
Cold climate (ENERGY STAR)YesYes
ENERGY STAR ID44289464428946
Indoor unit dimensions (W × D × H, in)17.5 x 21 x 4317.5 x 21 x 43
Outdoor unit dimensions (W × D × H, in)31.44 x 11.44 x 24.8831.44 x 11.44 x 24.88
Indoor sound level (min / max)33 / 44 dB(A)33 / 44 dB(A)
Outdoor sound level55.0 dB(A)55.0 dB(A)
Airflow600 CFM600 CFM
Dehumidification2.4 pints/h2.4 pints/h
Wi-FiOptionalOptional
LogisVert grant (Hydro-Québec, list of October 27, 2026)$1,932$1,932
Warranty (compressor · parts · labour, years)12 · 12 · 612 · 12 · 6
ManufacturerGENERAL Inc. (Kawasaki, Japan)GENERAL Inc. (Kawasaki, Japan)
Product pageThis pageFujitsu AIRSTAGE CENTAURI 18,000 BTU

The Fujitsu twin can be viewed here: the Fujitsu AIRSTAGE version of this CENTAURI 18,000 BTU electric furnace.

First of all, the closet. The AMUH18KUAS cabinet measures 17.5 × 21 × 43 in. in width, depth and height, and you have to allow space in front of it to open the panels and slide out the filter. We measure the usable width and depth, the clear height, the door and the floor opening that leads to the supply plenum. If the frame was built tight around the old furnace, the necessary modification is in the quote instead of being discovered on installation day.

The replacement then goes in this order:

  1. power shut-off and removal of the electric furnace;
  2. inspection of the floor opening and the plenum under the closet;
  3. installation of the air handler in downflow on the UTD-DFMSB1 kit, with the return air connected at the top;
  4. addition of the compatible manufacturer electric backup heat kit, sold separately, on its dedicated power supply;
  5. routing of the refrigerant line set (1/4 and 1/2 in.), the cable and the drain to the outside, then setting the outdoor unit on its pad or bracket;
  6. connection at 208/230 V and commissioning by a refrigeration technician, who sets the backup logic.

The drain deserves a closer look. An electric furnace produces no water; an air handler does. In summer, its coil removes 2.37 pints of water per hour from the air according to the manufacturer, and in a house without a basement, a floor drain is rarely close to the closet. We map out the drain route at the visit, with a condensate pump when there is not enough natural slope.

Leak detection makes full sense in this closet: the air handler shares the air of the neighbouring rooms, and the monitoring of its R-32 circuit comes standard, with no accessory to add. For service monitoring, a compatible controller is all it takes.

Next to the kitchen or the bedrooms, noise also weighs in the choice. The AMUH18KUAS stays at 33 dB(A) at its lowest speed and climbs to 44 dB(A) at its highest. Outside, the AOUH18KUAS1 unit is rated at 55.0 dB(A), which is why the wall it backs onto should be chosen with care.

Under-floor ducts in a house without a basement can be long and tight. The air handler delivers up to 600 CFM; on the external static pressure side, it handles 0.08 to 0.80 in. WC. The margin is there, but we do not reuse a duct system without measuring it. The number of grilles and the location of the return air are confirmed on site.

In heating, the heat pump carries most of the load: 21,600 BTU nominal at 8.3 °C, modulating from 3,100 to 24,000 BTU. The manufacturer also publishes 16,100 BTU with a COP of 2.91 at −8 °C, and 17,300 BTU with a COP of 2.4 at −15 °C; these values come from different test points and are each read on their own. The outdoor unit, compact and universal, compatible with all of the manufacturer’s non-wall single-zone systems, heats down to −21 °C, and the brochure speaks of “no lockout” at low temperatures. When the heat pump can no longer keep up with demand, the electric kit takes over according to the selected logic.

In cooling, the 18,000 BTU nominal modulates from 3,100 to 20,100 BTU. Under AHRI certificate 217290593, the system posts 19.2 SEER2, 10.5 HSPF2 and 12.2 EER2, and ENERGY STAR places it in the cold climate category (ID 4428946).

Without a basement, the refrigerant line set usually exits through the wall, close to the closet. The allowed length is between 16 and 98 ft (5 and 30 m), for a height difference of at most 49 ft (15 m) and a precharge covering 66 ft (20 m); the outdoor unit is placed to keep that run short and clean.

The old furnace’s thermostat is not necessarily suited to this system, and no control comes with the air handler. You choose between a KAGAMI wired controller (UTY-RVRU or UTY-RNRUZ5), the IR receiver kit and its wireless remote, Wi-Fi through the AIRSTAGE Mobile app, or a third-party 24 V thermostat connected through the UTY-TTRXZ1 interface.

For maintenance, the filter is reached through the closet door, and the manufacturer sells an optional filter base (16 × 20 in.). A tip from the field: a closet kept free of boxes and brooms is a filter that actually gets changed.

On the grant side, this system is listed in Hydro-Québec’s LogisVert program for $1,932 (list of October 27, 2026). The manufacturer’s warranty: compressor and parts, 12 years each; labour, 6 years. Its bilingual spec sheet, the GENERAL version prepared by AirGreen, comes with the product, along with dimensional drawings and complete performance data. You will also come across this system in our catalogue under the name “central heat pump”.

The target profile: a house without a basement heated by an electric furnace housed in a closet, with a load that matches 1.5 tons. If the closet turns out to be too narrow or the load higher, we will tell you at the visit.

Official brochures

The manufacturer's brochures are available as PDF files:

Saint-Amable and the South Shore: we start by opening the closet

In Saint-Amable, the visit starts in front of the furnace: closet measurements, condition of the floor opening, route of the drain and the refrigerant line set, location of the outdoor unit. The free quote comes after that visit and details the equipment, the downflow kit, the backup kit and the chosen control. As an AIRSTAGE Elite Plus installer and HVAC contractor, AirGreen goes everywhere on the South Shore and also serves Montreal, Laval, Longueuil and the North Shore.

Calling 514 316-2973 puts you in touch with our team to set the date.