EMERSON 80 Series 1F85U-22NP Thermostat | Montreal, Laval, Longueuil, South Shore & North Shore
In a rental unit, tenants set the temperature but only within the limits you choose: no schedule, for a two-stage furnace or a heat pump with backup.
Quick facts
Own a rental unit heated by a central furnace? Your tenants want to adjust the heat without reading a manual, and you would rather not see the setpoint pushed to the top all winter. The 80 Series 1F85U-22NP (EMERSON’s White-Rodgers line) is non-programmable, takes setpoint limits and a keypad lock, and runs a two-stage furnace or a heat pump with backup.
What it does, with no schedule
- Two-stage furnace: up to 2 heat and 2 cool stages in conventional mode, gas, oil or electric.
- Heat pump and its backup: the thermostat runs up to 2 heat stages, with 1 cool stage.
- Setpoint limits: you limit the setpoint to a range you choose, within 7 to 37 °C (45 to 99 °F).
- Keypad lock: your settings stay put.
- Auto changeover: between heating and cooling.
- Power: batteries (mV to 30 VAC) or hardwired at 20 to 30 VAC with a C wire.
1F85U-22NP compatibility
It installs on gas, oil or electric furnaces, 24 V or millivolt, and on central heat pumps with backup. According to the spec sheet, 3-wire hydronic zone valves are covered too. Dual-fuel control, on the other hand, is not provided for this model in the manufacturer’s documents. It is not made for baseboards, convectors and radiant ceilings, or for fan-forced heaters, electric floor heating or wall and ducted heat pumps.
With or without a schedule, 2 or 4 stages
The EMERSON 80 Series 1F85U-22PR has the same stages and adds a 7-day or 5-1-1 schedule, with 4 periods per day. The EMERSON 80 Series 1F85U-42NP, also schedule-free, goes up to 4 heat and 2 cool stages on a heat pump: it is the pick if your heat pump calls for up to 4 heat stages.
Installation in a rental, by AirGreen
On a replacement, the technician records the old thermostat’s wiring, looks for a spare C wire and, failing that, sets the 1F85U-22NP up on batteries. They set conventional or heat pump mode and the number of stages, then the setpoint limits and keypad lock if you ask. An F61-2663 wall plate can hide the marks left by the old unit. Ask for a free in-home estimate for your rental unit.
Manufacturer document: 80 Series spec sheet (R-4461-5). Sold and installed by AirGreen. We serve Montréal, Laval, Longueuil, the North Shore and the South Shore.
Key facts: EMERSON 80 Series 1F85U-22NP
Four things to know, then its ID card in twelve answers. “—” means the manufacturer does not publish it.
Is the EMERSON 80 Series 1F85U-22NP compatible with your heating?
Two steps, thirty seconds. The verdict takes your system and your wiring into account.
Full compatibility table
The terminals behind the thermostat
Tap an element to see what it does. A working diagram, not a substitute for the manufacturer’s installation guide.
Try the EMERSON 80 Series 1F85U-22NP before you buy
Raise the setpoint, change the mode: see how it responds.
Winter, Rate Flex D and rebates: what this thermostat changes
With Hydro-Québec’s Rate Flex D, electricity costs less most of the winter and more during a few peak hours. Turning the setpoint down a few degrees during those hours is what counts.
The EMERSON 80 Series 1F85U-22NP or its closest sibling?
The most useful comparison: the model right next to it in our catalogue.
The right thermostat in three questions
If this model is not the right one for you, the page says so and shows you which one is.
Products that go with the EMERSON 80 Series 1F85U-22NP
Parts named in its spec sheet that we sell and install.
Installed and set up by our technicians, in five steps
What we do at your place, in order. The on-site estimate is free.
- 01InspectionEquipment, stages to control and existing wiring.
- 02C wireCommon wire added if the model needs it and it is missing.
- 03MountingWall base, terminal wiring, cover plate if needed.
- 04SettingsEquipment type, stages, dual energy and accessories.
- 05Start-upConnection, app, schedule and tests with you.
EMERSON 80 Series 1F85U-22NP specifications
From the manufacturer’s sheet. Type a word: the list filters as you write.
No line matches. Try another word.
Frequently asked questions about the EMERSON 80 Series 1F85U-22NP
Short answers, no detours.
What does the EMERSON 80 Series 1F85U-22NP work with?
According to the manufacturer’s sheet: gas, oil or electric (millivolt and 24 V); heat pump with backup; 3-wire hydronic zone valves.
Does it need a C wire?
Per the spec sheet, it can run on batteries; a common wire is still recommended when available.
Can it control electric baseboards?
No. It is a low-voltage (24 V) thermostat. 120/240 V baseboards need a line-voltage electronic thermostat.
Can it be controlled remotely?
Not directly: it has no built-in Wi-Fi.
What is the warranty?
5 years, per the manufacturer’s information.
Does AirGreen install it?
Yes. We sell and install this product in Montréal, Laval, Longueuil, the South Shore and the North Shore. The on-site estimate is free.
No question matches. Call us at 514 316-2973.
Your thermostat, installed and set up by our technicians
We check your system and wiring, install the thermostat, connect it and program it with you. One visit, one installed price.

