EMERSON Blue Series 2" 1F86-0244 Thermostat | Montreal, Laval, Longueuil, South Shore & North Shore
In a rental unit or a basement, people want a thermostat they adjust with two arrows and never program: that is the 1F86-0244, on batteries or hardwired.
Quick facts
A unit you rent out, a finished basement, a cottage you head to on weekends: nobody there wants to learn how to program a thermostat. The Blue Series 2" 1F86-0244 (the White-Rodgers line from EMERSON) is set with two arrows and holds the temperature you choose, with no schedule behind it. Anyone can read it at a glance.
Pick a temperature and you’re done
- Non-programmable: you set the temperature, it maintains it.
- Large characters: 2 sq. in. blue backlit LCD.
- Display recalibration: to correct the reading if the location skews it.
- Adjustable differentials: 0.6 °F for heating and 1.2 °F for cooling on a single-stage system, 1.2 °F on a heat pump.
- Short-cycle protection and Cool Savings: compressor protection on one side, Cool Savings for cooling peaks on the other.
- Power: 2 AA batteries included, or hardwired at 20 to 30 VAC.
Where it can go
One heating stage, one cooling stage: a gas, oil or electric furnace, or a single-stage heat pump without backup heat. Running on batteries, the 1F86-0244 also works with millivolt systems. It does not handle dual fuel, which needs a backup stage, and it does not suit baseboards, electric floor heating, fan-forced heaters or wall or ducted heat pumps. The instructions also exclude 3-wire zoned hydronic systems and systems over 30 VAC and 1.5 A.
How it differs from its neighbours
In its 2025 cross-reference table, the brand lists the EMERSON 80 Series 1F83C-11NP to replace the 1F86-0244. Also non-programmable, it has RC and RH terminals, setpoints up to 37 °C and a 1.5 A per-terminal rating (1.0 A here), in a 6 in. wide housing. The EMERSON Blue Series 2" Easy Set 1F86EZ-0251 is the same size as the 1F86-0244; its sheet lists three one-touch settings, Home, Sleep and Away, and a sleep timer.
AirGreen handles the install
The 1F86-0244 does not need a C wire: without a common wire, it runs on its 2 AA batteries. We configure it for a single-stage furnace or a heat pump without backup and, if the wall throws off the reading, recalibrate the display before we leave. Ask for your free in-home estimate.
Manufacturer document: 1F86-0244 installation instructions (37-7010). Sold and installed by AirGreen. We serve Montréal, Laval, Longueuil, the North Shore and the South Shore.
Key facts: EMERSON Blue Series 2" 1F86-0244
Four things to know, then its ID card in twelve answers. “—” means the manufacturer does not publish it.
Is the EMERSON Blue Series 2" 1F86-0244 compatible with your heating?
Two steps, thirty seconds. The verdict takes your system and your wiring into account.
Full compatibility table
The terminals behind the thermostat
Tap an element to see what it does. A working diagram, not a substitute for the manufacturer’s installation guide.
Try the EMERSON Blue Series 2" 1F86-0244 before you buy
Raise the setpoint, change the mode: see how it responds.
Winter, Rate Flex D and rebates: what this thermostat changes
With Hydro-Québec’s Rate Flex D, electricity costs less most of the winter and more during a few peak hours. Turning the setpoint down a few degrees during those hours is what counts.
The EMERSON Blue Series 2" 1F86-0244 or its closest sibling?
The most useful comparison: the model right next to it in our catalogue.
The right thermostat in three questions
If this model is not the right one for you, the page says so and shows you which one is.
Installed and set up by our technicians, in five steps
What we do at your place, in order. The on-site estimate is free.
- 01InspectionEquipment, stages to control and existing wiring.
- 02C wireCommon wire added if the model needs it and it is missing.
- 03MountingWall base, terminal wiring, cover plate if needed.
- 04SettingsEquipment type, stages, dual energy and accessories.
- 05Start-upConnection, app, schedule and tests with you.
EMERSON Blue Series 2" 1F86-0244 specifications
From the manufacturer’s sheet. Type a word: the list filters as you write.
No line matches. Try another word.
Frequently asked questions about the EMERSON Blue Series 2" 1F86-0244
Short answers, no detours.
What does the EMERSON Blue Series 2" 1F86-0244 work with?
According to the manufacturer’s sheet: single-stage systems (gas, oil, electric, millivolt on batteries); single-stage heat pump with no backup heat.
Does it need a C wire?
Per the spec sheet, it can run on batteries; a common wire is still recommended when available.
Can it control electric baseboards?
No. It is a low-voltage (24 V) thermostat. 120/240 V baseboards need a line-voltage electronic thermostat.
Can it be controlled remotely?
Not directly: it has no built-in Wi-Fi.
Does AirGreen install it?
Yes. We sell and install this product in Montréal, Laval, Longueuil, the South Shore and the North Shore. The on-site estimate is free.
No question matches. Call us at 514 316-2973.
Your thermostat, installed and set up by our technicians
We check your system and wiring, install the thermostat, connect it and program it with you. One visit, one installed price.
