Repair · Montréal

Repair of a wall-mounted heat pump in Montreal

10 min read
Réparation d’une thermopompe murale à Montréal
Job photo

A winter intervention on a residential balcony: restoring stable heating despite the cold and snow

In Montreal, wall-mounted heat pumps installed on balconies, flat roofs, or terraces of residential buildings are exposed to particularly demanding conditions: light snow, winds between buildings, vibrations transmitted to the structure, frequent defrost cycles, moisture accumulation, and sometimes limited space around the outdoor unit. During this service call, our AirGreen team worked on a mini-split type wall-mounted heat pump, installed outside on a wooden platform, behind a metal guardrail, in a typically Montreal environment.

The client contacted us after noticing a drop in heating performance, accompanied by an unusual noise coming from the outdoor unit. The heat pump was still running, but the heat produced inside seemed irregular. At times, the unit blew lukewarm air; at others, it cycled off more quickly than usual. Since the intervention took place during cold weather, the problem needed to be analyzed quickly to avoid a complete loss of heating.

At AirGreen, we handle this type of situation with a methodical approach: observe the installation, confirm the symptoms, check mechanical and electrical components, measure operating parameters, then fix the root cause rather than just restarting the unit.

A wall-mounted heat pump exposed to the challenges of a Montreal balcony

The outdoor unit visible on site corresponded to a common configuration for condos, plexes, and residential buildings in Montreal, but also in Laval, Longueuil, the North Shore, and the South Shore: a compact wall-mounted heat pump installed near the dwelling, with refrigerant lines and wiring directed toward the indoor unit.

Positioning on a wooden support had allowed the unit to be raised above the roof or balcony membrane. This elevation is important, especially in winter, as it reduces the risk of direct contact with snow, ice, or standing water. However, we immediately noted several elements to check:

  • the actual stability of the base under the outdoor unit;
  • the clearance space around the fan and exchange grille;
  • the possible presence of vibration transmitted to the structure;
  • the condition of visible refrigerant lines;
  • the device’s behavior during a heating cycle;
  • the drainage of water generated during defrost cycles;
  • the impact of wind and snow on the condenser’s operation.

In this specific case, the wall-mounted heat pump was functional, but its installation environment contributed to worsening an existing problem: a combination of vibration, reduced heat exchange, and defrost cycles misinterpreted by the client as an intermittent failure.

Reported symptoms: irregular heating, noise, and shorter cycles

The client described three main symptoms to us. First, less consistent heat inside, especially when the outside temperature dropped. Then, a louder noise from the outdoor unit, noticeable from inside when the compressor started. Finally, more frequent shutdowns, giving the impression that the heat pump was "struggling" or no longer able to maintain the requested temperature.

These symptoms can stem from several possible causes on a residential HVAC installation:

  • a partially blocked outdoor grille;
  • an unbalanced or dirty outdoor fan;
  • a poorly positioned or defective temperature sensor;
  • a refrigerant shortage caused by a micro leak;
  • an electronic board that poorly controls the defrost cycle;
  • a weakened fan motor;
  • an unstable base causing vibrations;
  • a restriction in the refrigerant circuit;
  • a dirty or iced-over outdoor heat exchanger;
  • poor drainage of defrost water.

The goal was therefore not to replace a part at random, but to determine why the device was losing efficiency under conditions where it should normally continue heating.

AirGreen Diagnosis: observation, measurements, and validation of the heating cycle

Our technician began by securing access to the outdoor unit. Installations on balconies or terraces require special attention: work must be done without damaging the membrane, without unnecessarily moving the ducts, and without compromising the stability of the device. A complete visual inspection was then carried out.

The first anomaly noted was the accumulation of fine dirt and deposits on the rear section of the outdoor heat exchanger. Even if the device appeared clean at first glance, a heat pump placed in an urban environment regularly collects dust, particles, light debris, pollen, moisture, and melted snow. This combination can gradually reduce heat exchange capacity. In heating mode, the outdoor unit must capture energy from the outside air. If the exchanger breathes poorly, the system works harder, defrosts more often, and may produce less stable heat.

We then checked the outdoor fan. The noise reported by the client was not due to a major compressor failure, which was good news. The vibration was instead caused by a slight imbalance amplified by the support base and balcony resonance. In a densely populated building, moderate vibration can seem much more significant because it transmits to the structure and railing.

Electrical readings were also taken to confirm that the power supply was stable. We checked the startup current, operating current, accessible connections, and the general condition of the wiring. No major overheating signs were observed, but some connections needed tightening and protection to prevent future issues related to freeze-thaw cycles.

Technical cleaning of the outdoor unit and vibration correction

Once the diagnosis was confirmed, we proceeded with a technical cleaning of the outdoor heat exchanger. This step is not just about removing visible snow. The fins must be cleared, deposits that hinder airflow removed, and it must be ensured that the fan can properly draw in and expel air.

On a mini-split wall-mounted heat pump, even a partial obstruction can cause:

  • reduced heating performance;
  • increased operating time;
  • more frequent defrost cycles;
  • higher electrical consumption;
  • premature compressor wear;
  • a feeling of unstable warmth in the room.

We also stabilized the device by adjusting the base support points and adding an anti-vibration correction suited to the existing setup. In this type of intervention, caution is necessary: the goal is not to modify the installation haphazardly, but to reduce vibrations while maintaining safety, clearance, and proper airflow.

The fan was inspected, cleaned, and tested at several operating speeds. No motor replacement was necessary. The noise mainly came from vibrational transmission, not an internal failure. This distinction is important because it saves the client from a costly and unnecessary replacement.

Defrost check: a critical point in winter

The defrost cycle is one of the most misunderstood elements by owners of wall-mounted heat pumps. In heating mode, it is normal for an outdoor unit to form frost at certain times. The device must then temporarily reverse its cycle to clear the exchanger. During this short interval, the indoor heating may seem to decrease. This behavior is not necessarily a malfunction.

In this case, the problem was that the unit had to defrost more often than necessary due to reduced heat exchange and less effective air circulation. After cleaning and stabilization, we observed the system’s operation over a full cycle. The blowing temperatures improved, shutdowns became more consistent, and the external noise significantly decreased.

We also checked the drainage of water produced by defrosting. On a balcony, this water can freeze around the base if it is not properly directed. In the long term, this can create an accumulation of ice under the unit, reduce the available air space, and even cause the device to operate in a less stable position.

Why this type of HVAC repair requires local expertise

The installations of wall-mounted heat pumps in Montreal are not all comparable. A unit installed in an open yard does not behave like a unit placed behind a guardrail, on a wind-exposed balcony, between two buildings. The diagnosis must take into account the building, height, exposure, snow, vibrations, and technical access.

This is also true in Laval, Longueuil, on the North Shore and on the South Shore, where many installations are found on side walls, wall mounts, flat roofs, rear balconies, and condo terraces. An effective repair must therefore combine refrigeration knowledge, field experience, and understanding of local residential realities.

In this intervention, the client feared a compressor failure. After our checks, we were able to reassure them: the device was not at the end of its life. The performance drop was due to a set of correctable factors. Cleaning, stabilization, electrical verification, and validation of the defrost cycle restored much more reliable operation.

Result: a quieter, more stable heat pump better prepared for winter

After the work, we restarted the wall-mounted heat pump and observed its behavior under real conditions. The difference was noticeable: the outside noise was reduced, vibrations no longer spread the same way, the air blown inside was more consistent, and the device no longer seemed to stop randomly.

The client especially appreciated that our team took the time to explain the difference between a normal defrost cycle and a sign of malfunction. This understanding greatly changes the experience of using a heat pump in winter. When an owner knows what is normal, they can better recognize what is not.

Practical advice given to the client after the intervention

At the end of the service call, we provided several simple but important recommendations:

  • keep sufficient clearance around the outdoor unit;
  • avoid stacking objects, bins, or balcony furniture near the condenser;
  • never break ice on the device with a hard object;
  • monitor for new noises or unusual vibrations;
  • have the outdoor unit cleaned before intensive use periods;
  • check that defrost water does not form a dangerous accumulation;
  • contact a professional if the device heats less, defrosts too often, or displays an error code.

We also recommended regular preventive maintenance, especially for devices installed in areas exposed to urban dust, snow, and rapid temperature changes. A well-maintained heat pump heats better, consumes less, and preserves its components longer.

Mistakes to avoid with a wall-mounted heat pump installed on a balcony

This intervention illustrates several common mistakes we encounter during our HVAC repair service calls:

Ignoring vibrations

A slight vibration may seem harmless, but it can worsen over time. It can loosen fastenings, fatigue supports, create noise in the housing, and affect occupant comfort.

Wait for the device to stop working completely

When the heat pump heats less effectively, makes more noise, or defrosts too often, it is better to intervene before a complete breakdown. A quick repair can prevent more costly damage.

Confusing normal defrosting with a technical problem

Defrosting is part of the normal operation of a heat pump in winter. However, if the cycles become too frequent or too long, a diagnosis is necessary.

Neglecting exterior cleaning

An outdoor condenser does not need to be fully visible to be clogged. Deposits can lodge in the fins and reduce efficiency without the client noticing.

Modifying the base or supports yourself

Moving an outdoor unit, even slightly, can affect the refrigerant lines, drainage, device level, and installation stability. This type of correction must be done carefully.

A representative intervention of our approach at AirGreen

At AirGreen, we know that a good service call is not just about temporarily eliminating a symptom. Our goal is to understand the overall system behavior and propose a lasting solution. In this case, the repair avoided an unnecessary replacement, restored the client’s comfort, and improved the device’s operation for the rest of the cold season.

Our teams regularly work on wall-mounted heat pumps, wall air conditioners, MultiZone heat pumps, central heat pumps, specialized indoor systems, and other HVAC equipment in Montreal, Laval, Longueuil, on the North Shore and the South Shore. Each building has its own constraints, and it is precisely this local experience that allows us to make the right diagnoses.

For this heat pump installed on a balcony in Montreal, the solution was not spectacular, but it was precise: fix the clogging, reduce vibrations, check the power supply, confirm the defrost cycle, and reassure the client with clear explanations. It is often in these details that the difference lies between a temporary repair and a system that regains reliable performance.

You made it to the end.Share it with someone it could help.
Near you

More AirGreen jobs in the area

Other jobs, not the one described above.

Keep reading

Latest published jobs

AirGreen Climatisation & Chauffage

The same service at your place?

Cleaning, repair or maintenance: tell us about your unit and we schedule the visit.

  • RBQ licence 5645-9605-01Subclasses 15.8, 15.10 and 16
  • $5M liability insuranceOn every job
  • 15+ yearsFamily-owned, based in Montréal