Installation of a Midea28 wall-mounted heat pump in Rosemont–La Petite-Patrie
At AirGreen, we installed a Midea28 wall-mounted heat pump in Rosemont–La Petite-Patrie. Comfort, economy, and aesthetics for this Montreal duplex. Professional HVAC installation in Montreal and the surrounding area.
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
Comfort, efficiency and discretion: an installation by AirGreen in a Montreal duplex
At AirGreen , we recently completed the installation of a Midea28 wall-mounted heat pump in a bedroom of a duplex located in the heart of Rosemont–La Petite-Patrie , an iconic area of Montreal where indoor comfort must adapt to Quebec's four seasons. This intervention perfectly illustrates our know-how: combining energy performance, discreet aesthetics and acoustic efficiency for absolute comfort, summer and winter.
An installation designed for the harmony of the place
The owner wanted to replace his electric baseboard heating with a more efficient and environmentally friendly solution. His goal: to improve the comfort of the room while reducing electricity costs.
We recommended the Midea28 wall-mounted heat pump , a latest generation model using R-454B refrigerant , known for its low carbon footprint and its ability to maintain stable performance down to −30°C .
The indoor unit was installed above a large south-facing window , ensuring even air distribution throughout the room without direct drafts onto the bed. This precise positioning optimizes the circulation of hot or cold air and maximizes the system's efficiency, while blending harmoniously with the room's refined decor.
The Midea28: an ideal cold weather solution for Montreal
The Midea28 is a high-efficiency wall-mounted heat pump designed for Quebec's harsh climates. Its intelligent inverter compressor adjusts power in real time according to thermal needs, maintaining a stable temperature and achieving up to 40% energy savings compared to a traditional heating system.
Main advantages of the Midea28 model:
-
Environmentally friendly R-454B technology (78% lower global warming potential compared to R-410A).
-
Quiet operation , perfect for bedrooms.
-
Extreme cold capacity down to −30°C , suitable for Montreal winters.
-
High density filters and ionizer for better indoor air quality.
-
Eco mode and smart standby to reduce nighttime consumption.
Technical details of the AirGreen installation
For this installation, our team favored a discreet and careful approach:
-
Direct wall drilling to the exterior with waterproof and insulated finish.
-
Refrigerant lines protected by a white cover perfectly integrated into the wall.
-
Gravity drainage without condensate pump, thanks to an angle calculated for natural flow.
-
Dedicated electrical connection with independent circuit breaker in accordance with building code.
-
Complete leak test and vacuum before start-up, ensuring optimal performance from the first use.
The installation was completed in one day, without any alteration to the interior decor. The owner immediately noticed the rapid heating and reduced ambient noise compared to his previous electric heaters.
A project eligible for current subsidies
Thanks to its high energy efficiency (Energy Star) and its efficient operation at very low temperatures, the Midea28 meets the criteria of Quebec financial assistance programs such as Chauffez vert and Rénoclimat .
Our advisors assist each client in preparing grant applications, simplifying administrative procedures while maximizing savings.
The result: a more comfortable room, summer and winter
At the end of the project, the room benefits from a perfectly regulated climate , a virtually zero noise level , and a refined aesthetic . The owner now benefits from a stable and uniform temperature , regardless of the season, while reducing his energy bills.
This installation clearly illustrates our commitment at AirGreen : to offer sustainable, efficient HVAC solutions adapted to the Montreal lifestyle .
Each project is custom-designed, combining precise engineering , quality materials , and impeccable installation .
Why choose AirGreen for your heat pump installation in Montreal?
Using AirGreen means benefiting from:
-
certified expertise in the installation of wall-mounted heat pumps from Midea, Fujitsu, Gree, Sharp, and several other recognized brands;
-
personalized and transparent customer service , from quote to commissioning;
-
comprehensive support for subsidies and maintenance;
-
and above all, lasting comfort guaranteed by an installation optimized according to the most demanding market standards.
At AirGreen , each project is an alliance between energy performance and daily comfort .
Whether you live in Montreal, Laval, Longueuil, the North Shore or the South Shore , our team is at your service to transform your living space with modern, ecological and perfectly integrated HVAC solutions.
The unit on this job, in figures
The range as published on airgreen.ca: pick a size to see its capacity in deep cold.
| Size | Heating at −8 °C | Heating at −15 °C | Coldest certified point | COP at −15 °C | SEER | HSPF | Indicative LogisVert aid |
|---|---|---|---|---|---|---|---|
| Midea Série 28 9 000 | 12,000 | 11,500 | −30 °C: 5,100 | 1.8 | 27.4 | 12.5 | – |
| Midea Série 28 12 000 | 12,000 | 11,500 | −30 °C: 5,900 | 1.8 | 25.4 | 10.5 | $1,440 |
| Midea Série 28 18 000 | 18,000 | 18,000 | −30 °C: 8,000 | 1.92 | 21.4 | 11.0 | $2,160 |
| Midea Série 28 24 000 | 22,200 | 24,200 | −30 °C: 11,900 | 2.34 | 21.0 | 13.5 | $2,664 |
| Midea Série 28 33 000 | 32,000 | 35,000 | −30 °C: 20,700 | 1.98 | 19.5 | 10.5 | $3,840 |
According to NEEP, it delivers 12,000 BTU/h at −8 °C (17 °F), as much as at 8 °C. It heats as hard in moderate cold as in mild weather.
At 8 °C, its certified maximum capacity reaches 16,000 BTU/h, 78% more than its nominal 9,000 BTU size.
According to NEEP, its certified heating capacity at −15 °C (5 °F) is 11,500 BTU/h, 128% of its nominal 9,000 BTU size. Its COP there is 1.80.
According to NEEP, it delivers 12,000 BTU/h at −8 °C (17 °F), as much as at 8 °C. It heats as hard in moderate cold as in mild weather.
At 8 °C, its certified maximum capacity reaches 16,000 BTU/h, 33% more than its nominal 12,000 BTU size.
At −30 °C, its certified minimum capacity is 2,000 BTU/h (3,800 at 8 °C). It slows down instead of cycling on and off.
According to NEEP, it delivers 18,000 BTU/h at −8 °C (17 °F), as much as at 8 °C. It heats as hard in moderate cold as in mild weather.
According to NEEP, its certified heating capacity at −15 °C (5 °F) is 18,000 BTU/h, 100% of its nominal 18,000 BTU size. Its COP there is 1.92.
According to NEEP, its COP at −15 °C is 2.34: the highest of the Série 28 line, which ranges from 1.80 to 1.98 at that temperature.
At −30 °C, its certified minimum capacity is 2,400 BTU/h (11,800 at 8 °C). It slows down instead of cycling on and off.
According to NEEP, its certified heating capacity at −15 °C (5 °F) is 24,200 BTU/h, 101% of its nominal 24,000 BTU size. Its COP there is 2.34.
According to NEEP, its certified maximum capacity at −30 °C (−22 °F) is 20,700 BTU/h, 63% of its nominal 33,000 BTU size.
At −30 °C, its certified minimum capacity is 4,200 BTU/h (19,700 at 8 °C). It slows down instead of cycling on and off.
According to NEEP, its certified heating capacity at −15 °C (5 °F) is 35,000 BTU/h, 106% of its nominal 33,000 BTU size. Its COP there is 1.98.
Data read live from the airgreen.ca page of each size (NEEP / AHRI certified performance). When the title names the installed size, it is highlighted; otherwise the whole range is shown. The aid shown is today’s, using Hydro-Québec’s rule ($120 per 1,000 BTU/h at −8 °C); amounts quoted in the article date from its publication. Only Hydro-Québec confirms the assistance granted.A dash in the aid column: amount to be confirmed for this model.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Baseboards and electric furnaces turn 1 kWh of electricity into 1 kWh of heat. A heat pump delivers more: that is its COP. At Hydro-Québec’s rate D (11.142¢/kWh above 40 kWh a day, since 1 April 2026):
Hydro-Québec: a heat pump can be up to three times more efficient than baseboards for heating in the colder months.
Estimate per kWh of heat, at the chosen temperature, using the certified COP from the product page. Taxes, access charge and backup heat not included.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).