Project

Installation of a Sharp wall-mounted heat pump in Plateau-Mont-Royal

AirGreen installs a Sharp wall-mounted heat pump in Plateau-Mont-Royal: raised support, anti-vibration, external disconnect switch, and optimized cooling path. A clean and quiet urban integration for Greater Montreal.

By AirGreen Climatisation & Chauffage Admin6 min read
Installation of a Sharp wall-mounted heat pump in Plateau-Mont-Royal
Installation of a Sharp wall-mounted heat pump in Plateau-Mont-Royal
–chapters in this story
6 minreading time
–type of installation
2026year published
The tour

Take a tour of the installation

Each number is a point we check on site. Switch between summer and winter to watch air and heat move.

Generic diagram: wall-mounted heat pump, indoor and outdoor units

In summer, the outdoor unit rejects the house's heat outside.

Generic illustration of this type of installation, not a survey of this job site. Tap a number.

  1. Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.

  2. The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.

  3. Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.

  4. A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.

  5. The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.

  6. On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.

  7. The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.

The job

A neat urban installation that maximizes comfort and silence on Montreal balconies

At AirGreen , we have just installed a Sharp wall-mounted heat pump in a condo in Plateau-Mont-Royal . The outdoor condenser fits neatly onto the concrete balcony; the unit was designed to provide four-season comfort while respecting the constraints of a dense urban environment: limited space, close neighbors, co-ownership regulations and limited access.

Project context and comfort objectives

The client was looking for:

  • efficient supplementary heating in mid-season and light winter, combined with efficient cooling in summer;

  • lower consumption compared to existing electric convectors;

  • a very low noise level to preserve the peace and quiet of the neighborhood;

  • a discreet integration compatible with the rules of the co-ownership union.

Our recommendation was a Sharp Inverter wall-mounted heat pump , known for its temperature stability, precise modulation and excellent resistance to the Montreal climate.

Balcony installation details

  • Raised galvanized aluminum support : we fix the condenser on a raised frame, mechanically anchored to the concrete balcony. This elevation improves water drainage, limits the accumulation of blown snow and reduces vibration transmission .

  • Anti-vibration mounts : integrated under the chassis side members to mechanically decouple the device from the panel. Result: less buzzing perceived indoors and at neighbors.

  • External disconnect switch : a safety switch is installed within easy reach, protected by a waterproof enclosure (NEMA), to meet local electrical requirements and facilitate maintenance .

  • Compliant clearances : lateral and upper distances are respected to guarantee air flow and heat exchange efficiency, even in the glazed corner of the balcony.

  • Breakthrough Management : The wall penetration to the indoor unit is sealed with urethane and firestop where required, for a durable air barrier and prevention of water infiltration.

The Sharp unit for performance and silence

Sharp Eco Inverter units finely modulate compressor and fan speed. In the field, this translates to:

  • a soft start and smoothed power consumption;

  • a reduced exterior noise level , useful in an interior courtyard;

  • a stable indoor temperature without jolts.

Plasmacluster technology (found on several Sharp ranges) helps, when activated on the interior side, improve air quality by reducing certain particles and odors — a plus appreciated by sensitive occupants.

Refrigeration and finishing

Our team favors short refrigerated lengths when the layout allows it, to preserve seasonal efficiency. The copper connections are continuously insulated , then capped up to the wall for a clean finish and protection against UV rays . The connections are crimped/brazed according to our quality procedures, then subjected to:

  1. Nitrogen test and leak test ;

  2. High vacuum to the micron;

  3. Commissioning with verification of pressures, temperatures and intensities.

Condensate management and site cleanliness

On the interior side, the condensate drainage is arranged by gravity or via mini-pump depending on the configuration. On this urban site, the evacuation follows a discreet route so as not to mark the facades or disturb the neighborhood. At the end of the work, the balcony and the common areas are cleaned , and the fixings and seals are checked.

What the customer gains on a daily basis

  • Precise comfort : Inverter modulation maintains the right temperature without overheating or cold drafts.

  • Savings : The heat pump captures energy from the outside air; summer and mid-season electricity bills are lower compared to a window air conditioner and electric baseboard heaters alone.

  • Silence : the combination of support + silent blocks + adjustments significantly reduces the perception of noise.

  • Aesthetics : no window units; clear balcony , respected facade.

AirGreen Recommended HVAC Maintenance

To maintain performance:

  • Interior filter : regular cleaning by the occupant;

  • Exchangers : annual professional cleaning to remove dust and biofilm;

  • Checks : electrical tightening, current measurement, inspection of insulation and cover, verification of the crawl space of the connections if intervention;

  • Winterization : clearing the grids, checking the support before periods of prolonged frost.

We offer HVAC maintenance plans tailored to condominiums in Greater Montreal, with optimized appointment times to limit the impact on the occupants' lives.

Good practices and pitfalls to avoid in co-ownership

  • Validate the union regulations before installation (support height, appearance of the cover, work schedules).

  • Avoid supports placed directly on the ground of a balcony if it accumulates rainwater: favor raising it .

  • Respect the electrical routing : dedicated line, sized circuit breaker, accessible disconnector .

  • Anticipate maintenance : provide sufficient frontal clearance for washing coils and service measurements.

Why this solution on the Plateau-Mont-Royal?

The neighborhood's architecture combines bricks, exterior stairs, and narrow balconies . A Sharp wall-mounted heat pump is particularly suitable for this context:

  • low ground area ;

  • ductless installation;

  • high seasonal efficiency thanks to modulation;

  • clean integration on the balcony, without disfiguring the facade.

The AirGreen approach: methodical, local, responsible

  • Thermal study : BTU sizing based on the volume, orientation and actual insulation of the condo.

  • Clear proposal : layout options with sketches, choice of supports (wall, slab, raised), and realistic intervention schedule .

  • Execution : certified team, calibrated equipment, standardized commissioning procedures .

  • Follow-up : maintenance reminder, seasonal usage advice, priority assistance in the event of an alert.

Grants and Eligibility

Several assistance programs in Quebec promote high-efficiency wall-mounted heat pumps . Eligibility depends on the specific model, seasonal performance, and the building's file. We verify each case and assist our clients in preparing the required documents.


Do you live in Montreal, Laval, Longueuil, the North Shore or the South Shore and want an installation as clean, quiet and durable as the one carried out on the Plateau? At AirGreen, we place the same high standards on every project: accurate diagnosis, impeccable execution, rigorous maintenance .

The steps

The big day, step by step

The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.

Step 1 of 9The on-site estimate

We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.

  1. The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
  2. The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
  3. Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
  4. The wall openingA single opening, with the slope the drain needs to flow outside.
  5. The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
  6. Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
  7. The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
  8. Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
  9. The walkthroughRemote, modes, filters: we show you the essentials before we leave.
Your numbers

What would it look like at your place?

Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.

Size checkYour baseboards, in BTU/h
–BTU/h of installed electric heat

    Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.

    Mistakes avoided

    Four mistakes we do not make

    Flip each card to see what we do instead.

    Going further

    Your own project, step by step

    Through the seasons

    What to do, season by season

    Three habits per season for this unit. They take a few minutes and prevent many calls.

    • Clean the indoor unit's filters.
    • Clear leaves and debris left on the outdoor unit by winter.
    • Test cooling before the first hot days.
    At your place

    Is your home ready?

    Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.

    0 / 6 checked
    True or false

    Four statements: true or false?

    It all comes down to details you have just seen.

    1. In heating mode, the outdoor unit can produce water.

    2. You pick the capacity with a simple square-footage rule.

    3. A multi-zone connects several indoor heads to a single condenser.

    4. The disconnect can sit behind the patio furniture.

    Frequently asked questions

    What people ask us about this kind of work

    12 questions
    Does a wall-mounted heat pump heat in winter?
    Yes, it heats and cools. Its capacity drops in very cold weather; the operating range depends on the model and is listed on its spec sheet.
    Wall-mounted or multi-zone: how do I choose?
    One wall head and one condenser outside: the direct solution for a room or an open area. For two to five rooms, a multi-zone puts one head in each room on a single condenser.
    Where does the outdoor unit go?
    Where it stays above the snow, clear and accessible, away from walkways. We decide it with you during the estimate.
    Are there grants?
    Depending on the model and your situation, assistance programs may apply, including Hydro-Québec's LogisVert. AirGreen checks the model number before quoting an amount. See the grants.
    Do I need a permit?
    Rules vary from city to city: location, distances, noise. See permits and by-laws, and we check for your address.
    How cold can it heat?
    It depends on the model. According to Hydro-Québec, newer models work down to a temperature between −15 °C and −25 °C, and some cold-climate models are certified lower. The minimum temperature is on each unit's spec sheet.
    How much can I save?
    Hydro-Québec says a heat pump can be up to three times more efficient than baseboards for heating in the colder months. The result depends on the house, the climate and how it is used.
    How is the LogisVert assistance calculated?
    For ENERGY STAR cold-climate certified heat pumps, Hydro-Québec lists assistance of $120 per 1,000 BTU/h of heating capacity at −8 °C. AirGreen checks the exact model before quoting an amount; only Hydro-Québec confirms the assistance granted. See the grants.
    Is it noisy?
    The sound level depends on the model and is listed in decibels on each unit's spec sheet. Location matters too: when possible, we avoid putting the outdoor unit under a bedroom window.
    The outdoor unit is covered in ice: is that normal?
    Some frost is: the unit runs defrost cycles. Never hit the ice. If the unit stays iced up or stops heating, call us.
    Does AirGreen hold the required licences?
    Yes. AirGreen holds RBQ licence 5645-9605-01, subclasses 15.8 Ventilation, 15.10 Refrigeration and 16 Electricity.
    Is the estimate free?
    Yes. The on-site estimate is free and the quote follows within 24 hours. Book my free estimate.

    Could this job help a neighbour?

    Share
    Similar projects

    More jobs to see, near you

    By town, by equipment or by region: browse more than 4,700 published projects.

    Each dot: a town where AirGreen has published projects. The glowing dot: this job.

    All our projects

    Your project

    Every house has its constraints. We see them before we install.

    The on-site estimate is free and the quote follows within 24 hours.

    • RBQ licence5645-9605-01 · 15.8, 15.10, 16
    • EstimateOn site, free
    • QuoteWithin 24 hours

    Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).

    Leave a comment