Installation of a Sharp wall-mounted heat pump in Rosemont–La Petite-Patrie
AirGreen installed a Sharp ZU1 wall-mounted heat pump in Rosemont–La Petite-Patrie, providing efficient heating and quiet air conditioning in a Montreal residential home.
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
In this residential project carried out in Rosemont–La Petite-Patrie , our AirGreen team installed aSharp wall-mounted heat pump , a choice perfectly suited to the urban realities of Montreal: optimized interior spaces, masonry facades and the need for reliable performance in both summer air conditioning and winter heating.
A discreet and efficient wall-mounted system for a Montreal home
The installed system is a wall-mounted heat pump (mini-split) , a popular solution in central neighborhoods like Rosemont–La Petite-Patrie. This type of unit ensures optimal thermal comfort without major structural work on the building or a cumbersome duct network.
The Sharp brand , recognized for the quality of its components and the stability of its performance, was chosen to meet the customer's expectations: silence, energy efficiency and long-term reliability.
Installed model: Sharp ZU1 (R-32 series)
Although Sharp wall units have a clean and uniform design, the Sharp ZU1 model stands out here as a consistent and perfectly suited choice for this type of residential installation.
Why the Sharp ZU1 range?
-
Available capacity : 12,000 to 24,000 BTU
-
R-32 refrigerant , more environmentally friendly
-
Excellent heating performance , adapted to the Quebec climate
-
Quiet operation , ideal for open-plan living areas or bedrooms
-
A simple and modern design that blends harmoniously with interior walls.
Installation details can be observed on the project.
The indoor unit was installed high up on a brick wall , a very common situation in Rosemont's apartment buildings and condos. This type of wall requires precise and secure mounting to ensure the unit's long-term stability and prevent any vibration.
Key technical aspects of the installation:
-
Robust wall mounting on existing masonry
-
Strategic positioning at a height for even air distribution
-
Discreet routing of refrigeration lines , limiting visual impact
-
The perfectly aligned interior unit promotes a refined aesthetic.
-
Easy access for future maintenance
At AirGreen, every detail counts: a clean and well-thought-out installation contributes as much to the performance of the system as to the daily comfort of the occupants.
An ideal solution for Rosemont–La Petite-Patrie
The Rosemont–La Petite-Patrie neighbourhood is characterized by high residential density, brick buildings, and sometimes limited interior spaces. The Sharp wall-mounted heat pump is perfectly suited to these realities.
Concrete benefits for residents of the area:
-
Efficient heating in winter , even during periods of extreme cold
-
Stable and quiet air conditioning in summer , without aggressive drafts
-
No wasted space , unlike central systems.
-
Precise temperature control , room by room
-
Reduced energy consumption compared to traditional electrical systems
Four-season performance and lasting comfort
Thanks to Sharp technology and expert installation, this wall-mounted heat pump ensures consistent comfort year-round . The system automatically adjusts its output to actual needs, preventing unnecessary cycling and improving component longevity.
In winter, the Sharp ZU1 heat pump provides stable and economical heating, reducing reliance on electric baseboard heaters. In summer, it ensures gentle and even cooling, even during Montreal's heat waves.
Why entrust the installation to AirGreen?
At AirGreen , we don't just install equipment: we adapt each solution to the building, the neighborhood, and the lifestyle of the occupants.
Our added value:
-
Recognized expertise in residential HVAC in Montreal
-
In-depth knowledge of urban constraints (masonry, limited spaces, co-ownerships)
-
A rigorous selection of reliable brands like Sharp
-
Neat, durable installation compliant with standards
-
Support before, during and after the project
Each installation is designed to offer an optimal balance between performance, aesthetics and longevity .
A wise choice for uncompromising comfort
This Sharp wall-mounted heat pump installation in Rosemont–La Petite-Patrie perfectly illustrates our approach: choosing equipment that is consistent with the location, the architecture and the client's actual needs, and then installing it with precision and professionalism.
Whether for a condo, a duplex or a triplex in Montreal, the Sharp wall-mounted heat pump remains a reliable, efficient and durable solution.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).