Installation of a Gree FreeMatch Extreme 5 Zone Heat Pump in Ville-Marie, Montreal
Dive into AirGreen’s HVAC installation adventure in Ville-Marie! Uncover how the Gree FreeMatch Extreme became the hero in a clinic’s quest for comfort, efficiency, and a serene, professional atmosphere for its patrons.
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
A Symphony of Precision and Excellence: Our Latest HVAC Installation Journey in Ville-Marie
Embarking on a Challenge in Ville-Marie
In the bustling heart of Ville-Marie, Montreal, AirGreen recently undertook a project that was nothing short of a masterpiece. Our canvas? A newly inaugurated clinic, eager to offer unparalleled service to its patrons, with a need for a heating and cooling system as refined and reliable as the services it provides.
Selecting the Perfect Machine: Gree FreeMatch Extreme
Our journey began with selecting the ideal HVAC unit that could meet the unique demands of this clinic. After meticulous consideration, the Gree FreeMatch Extreme 5 Zone Heat Pump emerged as the undisputed choice. This model is not just a machine; it’s a silent guardian and a meticulous regulator of comfort, designed to operate efficiently under the most challenging conditions.
- Cooling Capacity: A robust 42,000 BTU
- Heating Efficiency: Unyielding even at -35°C
- Zones: Five distinct zones for precise control
- Connectivity: Integrated WiFi for smart operations
- Efficiency: An impressive SEER rating of 23.0
- Warranty: Comprehensive 10-10-10 warranty with an extended option included
- Sound Level: A whisper-quiet 62.0 dB(A) at its loudest
Crafting Solutions: The Installation Process
The installation in Ville-Marie was a tapestry of challenges and triumphs. With five rooms requiring individualized cooling and heating without compromising privacy, our team had to innovate at every step. The solution was a symphony of five 9,000 BTU heads, each installed with precision in separate rooms, all connected harmoniously to a powerful 42,000 BTU compressor perched on the rooftop.
Overcoming Obstacles: The Hard Part
This installation was not for the faint of heart. It demanded days of meticulous planning and execution, with each step carefully choreographed to ensure a seamless integration of the Gree FreeMatch Extreme into the clinic’s infrastructure. But in the face of challenges, AirGreen’s commitment to excellence and customer satisfaction never wavered.
Reaping Rewards: Federal Grant and Silent Operation
Beyond the immediate benefits of a comfortable and professional environment for the clinic’s patrons, this installation also brought tangible rewards. The Gree FreeMatch Extreme is eligible for a substantial $5,000 Federal Grant, a testament to its efficiency and performance. Moreover, its whisper-quiet operation ensures that the clinic’s atmosphere remains undisturbed and conducive to patient care and privacy.
A Testament to Excellence: AirGreen’s Commitment
This project in Ville-Marie is not just another installation; it’s a testament to AirGreen’s unwavering commitment to delivering HVAC solutions that are as innovative as they are reliable. From selecting the Gree FreeMatch Extreme to navigating the intricate installation process, every step was taken with the customer’s needs and expectations in mind.
Conclusion: A Tale of Triumph in HVAC Installation
In the end, the Ville-Marie installation was a tale of triumph over challenges, of precision over complexity, and of commitment over obstacles. It’s a story that reflects not just on the Gree FreeMatch Extreme’s capabilities, but also on the expertise, dedication, and customer-centric approach that defines AirGreen.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).