Installation of a Sharp TU Wall-Mounted Heat Pump in Rosemère, North Shore of Montreal
Dive into the details of AirGreen's latest Sharp TU Heat Pump installation in Rosemère! Quiet, purifying, and efficient, it’s the top choice for a fresh and pleasant kitchen environment.
Take a tour of the installation
Each number is a point we check on site. Switch between summer and winter to watch air and heat move.
In summer, the outdoor unit rejects the house's heat outside.
Generic illustration of this type of installation, not a survey of this job site. Tap a number.
Mounted level on a wall plate, high enough for the air to reach the whole room, with enough space around it to slide the filters out easily.
The refrigerant lines, the communication cable and the drain go through the wall in a single opening, sealed against water, cold air and insects.
Two insulated copper pipes connect the two units. Outside, a line cover can protect them from sun, knocks and weather.
A shut-off switch near the outdoor unit isolates it safely for service. It must stay accessible at all times.
The compressor and the fan. In heating mode it captures heat from the outdoor air, even in winter, and moves it inside.
On the ground or on the wall, it keeps the unit above accumulated snow. The unit stays clear and defrost water can drain away.
The fan needs to blow freely. Storage, a fence or a wall too close, and efficiency drops while noise goes up.
A Seamless Experience with AirGreen
Choosing the Perfect Location
In the picturesque town of Rosemère, located on the North Shore of Montreal, another successful installation was seamlessly executed by the proficient team at AirGreen. Our client had specific requirements: they sought a solution that wouldn’t encroach upon the valuable space of their balcony, yet it was imperative that the compressor was not situated too distantly from the head unit. After meticulous planning and consideration, the optimal location for the compressor was identified adjacent to the balcony on the first floor, with the head unit strategically placed within the kitchen approximately 15 feet away.
Why Sharp TU?
The Sharp TU Wall-Mounted Heat Pump was the ideal choice for this particular installation for a myriad of reasons:
- Quiet Operation: Perfectly suited for a kitchen setting due to its whisper-quiet functionality.
- Air Purification: Unique to the Quebec market, the Sharp TU boasts a true air purification feature, thanks to its innovative Plasmacluster function. This technology incorporates an ionizer within the head unit, effectively purifying the indoor air.
- Odor Elimination: When installed in a kitchen, the Sharp TU excels in neutralizing cooking odors, creating a fresh and pleasant environment.
Technical Specifications
- Cooling Capacity: 12,000 BTU
- Heating Capacity: Functional at temperatures as low as -20°C
- Energy Efficiency: With a 22.5 SEER rating, it’s an energy-efficient choice.
- Warranty: Comprehensive 10-10-10 warranty for compressor, parts, and labor.
- Dimensions: Compact design with interior dimensions of 36.22 x 9.44 x 11.41 and exterior dimensions of 30.72 x 10.59 x 21.25.
Installation Details
- Difficulty Level: The installation process was straightforward and simple.
- Grant Eligibility: The model qualifies for a Provincial Grant of $420.
- Serial Numbers: AY-XPC12TU (Interior), AE-X12TU (Exterior).
Customer Satisfaction: Our Priority
Our client was overjoyed with the clean and professional installation executed at an unbeatable price point. The AirGreen team ensured that the process was hassle-free and the results exceeded expectations, providing a solution that was not only efficient but also aesthetically pleasing and space-conserving.
Why Choose AirGreen?
At AirGreen, we pride ourselves on delivering top-notch HVAC services across Montreal, Laval, Longueuil, North Shore, and South Shore. Our portfolio, accessible on our website, showcases a variety of installations we have meticulously completed, reflecting our commitment to quality and customer satisfaction. Each project is executed with precision, and we invite you to explore the details of our recent installation in Rosemère to understand the AirGreen difference.
The big day, step by step
The main steps of this kind of job at AirGreen. Every house has its quirks: the estimate brings them out.
We look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
Model, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
Floors and furniture protected, wall plate position marked level, wall opening located.
A single opening, with the slope the drain needs to flow outside.
Set on a stand raised above the snow, with the clearances the manufacturer requires.
Connected, insulated and protected. The opening is then sealed against water, cold air and insects.
A dedicated circuit and an accessible disconnect near the outdoor unit.
Leak test, vacuum, then start-up and a check of heating and cooling.
Remote, modes, filters: we show you the essentials before we leave.
- The on-site estimateWe look at the room, the outside wall, the line route and where the outdoor unit will go. That is where the capacity gets chosen.
- The quoteModel, capacity and price, in writing. We also check whether the model qualifies for assistance programs.
- Getting readyFloors and furniture protected, wall plate position marked level, wall opening located.
- The wall openingA single opening, with the slope the drain needs to flow outside.
- The outdoor unitSet on a stand raised above the snow, with the clearances the manufacturer requires.
- Lines, cable and drainConnected, insulated and protected. The opening is then sealed against water, cold air and insects.
- The electrical workA dedicated circuit and an accessible disconnect near the outdoor unit.
- Tests and start-upLeak test, vacuum, then start-up and a check of heating and cooling.
- The walkthroughRemote, modes, filters: we show you the essentials before we leave.
What would it look like at your place?
Two quick checks with real numbers: what heat costs, and what your current heaters add up to in BTU/h.
Conversion: 1 W = 3.412 BTU/h. An indication, not a load calculation: baseboards and furnaces are often stronger than the real need, and they can stay as backup. AirGreen confirms the capacity on site.
Four mistakes we do not make
Flip each card to see what we do instead.
Your own project, step by step
What to do, season by season
Three habits per season for this unit. They take a few minutes and prevent many calls.
- Clean the indoor unit's filters.
- Clear leaves and debris left on the outdoor unit by winter.
- Test cooling before the first hot days.
- Clean the filters more often when the unit runs a lot.
- Keep plants away from the outdoor unit.
- Check that no water drips from the indoor unit.
- Rake the leaves around the outdoor unit.
- Test heating before the first cold days.
- Book periodic maintenance before winter.
- Keep snow away from the stand and the front of the unit.
- Let the unit defrost: it is normal.
- Never hit the ice on the fins; call us if the unit stays iced up.
Is your home ready?
Check what applies at your place. A "no" is not a refusal: it is what we sort out during the estimate.
Four statements: true or false?
It all comes down to details you have just seen.
1. In heating mode, the outdoor unit can produce water.
During defrost cycles. That water must drain away without forming ice.
2. You pick the capacity with a simple square-footage rule.
Windows, insulation, orientation and how the room is used all count. Capacity is chosen on site.
3. A multi-zone connects several indoor heads to a single condenser.
One head per room, all on the same condenser. Each room keeps its own temperature.
4. The disconnect can sit behind the patio furniture.
It must stay accessible: it is what shuts the unit off for service.
0 / 4 right answers
What people ask us about this kind of work
Does a wall-mounted heat pump heat in winter?
Wall-mounted or multi-zone: how do I choose?
Where does the outdoor unit go?
Are there grants?
Do I need a permit?
How cold can it heat?
How much can I save?
How is the LogisVert assistance calculated?
Is it noisy?
The outdoor unit is covered in ice: is that normal?
Does AirGreen hold the required licences?
Is the estimate free?
No question matches. Write to us: we answer.
More jobs to see, near you
By town, by equipment or by region: browse more than 4,700 published projects.
Each dot: a town where AirGreen has published projects. The glowing dot: this job.
Every house has its constraints. We see them before we install.
The on-site estimate is free and the quote follows within 24 hours.
Text and photo: a real AirGreen Climatisation & Chauffage job. The diagrams are generic illustrations of the type of installation, not a survey of this job site. Sources of the added figures: airgreen.ca product pages (NEEP / AHRI performance), Hydro-Québec (Heat pumps page, LogisVert, read on 13 October 2026), Régie de l’énergie (rate D as of 1 April 2026).