BRADFORD WHITE CEHD80 24 to 36 kW Commercial Electric Water Heater (80 gallons) | Montreal, Laval, Longueuil, South Shore & North Shore

In stock
SKU: CEHD80 (24-36 kW)
303 L80 US gal of storage
24–36 kWof power, your choice
61.25 intall
Talk to an expert · 514 316-2973
1 1/2 in NPT connections
01 · Why this model

What sets the Bradford White CEHD80 24 to 36 kW apart

149 GPH

Recovery at 36 kW

Bradford White sheet C1401 lists 149 US gallons per hour at a 100 °F rise at 36 kW.

6 elements

Power range

The 6-element version can be set anywhere in the 24 to 36 kW range only, on the same tank.

335 lb

Shipping weight

The standard model ships at about 335 lb (378 lb with ASME construction).

3 in

Foam insulation

3 in (76 mm) of non-CFC foam covers the tank sides and top, and the tank has two anode rods.

02 · How it works

Cold water at the bottom, hot water on top

Cold watergoes down the dip tubeHot waterdrawn from the topUpper elementand its thermostatLower elementand its thermostatCold waterarrives at the bottom
  1. Cold water arrives at the bottom of the tank. Hot water, being lighter, stays on top, where it is drawn.
  2. The elements, each controlled by its thermostat, bring the water back to the set temperature.
  3. Foam insulation limits the heat lost while the water waits.
03 · Will it fit?

Check the height and the way in before our visit

It travels upright. Measure the ceiling at the spot and the narrowest door on the way.

in
in

Unit: 61.25 in tall (1556 mm), 26 in across (660 mm), about 335 lb shipping weight. The clearances the manufacturer requires are checked on site.

04 · Your current tank

How old is yours?

The year it was made is on the tank’s rating plate. Enter it.

Signs it is wearing out

  • Hot water runs out sooner than it used to.
  • The water comes out slightly reddish.
  • Rust shows at the bottom of the tank.
  • Moisture or drips around the unit.

Manufacturers announce a 10 to 15 year life. Many insurers require replacement after 10 or 12 years and may refuse a water damage claim past that age (CAA-Québec). Check your policy.

05 · Installation

What the spot needs, and who does what

Electrical circuit24 to 36 kW depending on the configuration ordered, three-phase.
1 1/2 in NPT waterCold inlet, hot outlet and an accessible shut-off valve.
T&P valveTemperature and pressure relief valve, with its discharge line.
Pan and detectorDrip pan under the tank and a leak detector: strongly recommended (CAA-Québec).
60 °C, 49 °CTank set to 60 °C against bacteria; 49 °C max at the shower and tub (Construction Code, art. 2.2.10.7).

AirGreenFree visit and quote, electrical connection (RBQ licence 5645-9605-01, subclass 16), start-up.

PlumberWater connections and relief valve by a master pipe-mechanic (CMMTQ).

YouA photo of the rating plate, the spot and the stairs saves us a trip.

06 · Maintenance

A few habits that make it last

  1. Start-up daySetting the temperature, with you.
  2. Every yearPartial drain to flush sediment, and a test of the relief valve.
  3. Depending on your waterAnode inspection: it wears so the tank steel does not. In hard water it goes faster.
07 · Spec sheet

Every figure, with its source

Capacity and performance
Model
CEHD80 (24-36 kW)
Capacity
80 US gal · 303 L
Recovery
149 US gal/h · 564 L/h
Electrical
Power
24 to 36 kW
Element type
Screw-in low watt density Incoloy
Dimensions and connections
Height
61.25 in · 1,556 mm
Diameter
26 in · 660 mm
Shipping weight (approx.)
335 lb · 152 kg
Water connections
1 1/2 in NPT
Build and warranty
Inner lining
Vitraglas with Microban
Drain valve
Brass

Manufacturer data. Detailed sources at the bottom of the page.

08 · Same family

The size below and above

09 · Questions

What people ask us most

Is there a LogisVert grant for this water heater?

No. Hydro-Québec’s LogisVert guide (version 1.10, September 15, 2026) lists no water heater among its eligible measures. At quote time we check other programs that could apply to your address.

What temperature should the tank be set to?

To 60 °C, as the Québec government recommends, to limit bacterial growth. At shower and tub valves, the Construction Code caps the water at 49 °C: that is the job of the valve or a thermostatic mixing valve.

Who does the installation?

AirGreen does the visit, the electrical connection under its RBQ licence (subclass 16) and the start-up. The water connections are done by a master pipe-mechanic (CMMTQ).

10 · AirGreen

We check the spot before we sell you anything

Free on-site estimate, written quote. Send a photo of your current tank and its plate, and we prepare the visit.

Book my free estimate
Sources checked November 2, 2026.
  1. Bradford White Canada ElectriFLEX HD spec sheet C1401-H-0823 CANADA · cdn.shopify.com
  2. Québec.ca, “Eau chaude”, updated November 5, 2025 (186 L/day, 7 °C water, 60 °C, volumes per use).
  3. Québec Construction Code, Chapter III Plumbing, art. 2.2.10.7 (RBQ).
  4. CAA-Québec, “Chauffe-eau: quelle capacité choisir”, updated June 29, 2026.
  5. Hydro-Québec, LogisVert residential participation guide, version 1.10, September 15, 2026.

Costs shown are indicative estimates before tax.

The balance between reserve and recovery for establishments that cannot run out of hot water

In a seniors’ residence, a childcare centre or a community kitchen, hot water is not a comfort: it is a condition for operating. Baths, cooking, laundry and hand hygiene all depend on a single appliance, and a breakdown is felt immediately. The Bradford White CEHD80 commercial electric water heater, in its six-element version offered from 24 to 36 kW, is designed for this kind of establishment. It combines an 80 US gallon tank (67 imperial gallons, 303 L) with enough power to rebuild the reserve quickly between peaks. AirGreen installs it in Montreal, Laval, Longueuil, on the South Shore and on the North Shore.

Why balance matters

A tank that is too small runs out during peaks; a tank that is too large but low in power takes a long time to catch up. In an establishment where needs follow one another all day, neither works. With an 80 US gallon reserve and six elements, the CEHD80 covers both situations: the reserve absorbs the morning peak, when toilets and baths follow one after another, and the installed power gets the water ready for lunch, the dishes and the afternoon laundry.

The establishments we recommend it for

  • Private seniors’ residences, where personal care is concentrated in the morning and the kitchen runs on a fixed schedule.
  • Childcare centres and daycares, with their many washbasins, their kitchen and their daily laundry.
  • Community kitchens and community organizations that prepare meals in large quantities.
  • School or workplace cafeterias, whose dish area and cleaning follow every service.

Choosing the power between 24 and 36 kW

The manufacturer offers the six-element version in the following power ratings: 24, 27, 30, 36 kW. According to Bradford White, six-element models "can be converted from 24 kW to 36 kW ONLY". That flexibility is valuable for an establishment planning to expand: the power can be increased later within that range without changing the unit.

The right choice depends on real demand and the capacity of the electrical service. During the visit, we take inventory of the fixtures and connected appliances, note the peak hours with the staff and check the panel. The selected power is then written into the quote.

Manufacturer data for the six-element CEHD80

  • Capacity: 80 US gallons (67 imperial gallons, 303 L).
  • Elements: six standard screw-in elements, Incoloy-sheathed, low watt density.
  • Power range: 24 kW to 36 kW.
  • Available voltages: 208 V, 240 V, 277 V, 380 V, 415 V, 480 V and 600 V; units shipped as standard three-phase; on 600 V models, only kW conversion is permitted.
  • Water connections: 1 1/2 in. (38 mm) NPT, factory-installed true dielectric fittings.
  • Tank: Vitraglas lining with Microban.
  • Drain valve: brass, low restriction, vandal-resistant design.
  • Height: 61 1/4 in. (1,556 mm). Diameter: 26 in. (660 mm).
  • Weight: 335 lb (152 kg), standard model.

1 1/2 in. connections to supply many fixtures

The 1 1/2 in. NPT water connections allow a high flow, which matters when several bathrooms, a kitchen and a laundry room draw at the same time. The true dielectric fittings, installed at the factory, electrically separate the tank from the piping and limit corrosion at that sensitive point. During installation, we adapt the connection to the building’s existing distribution and check the relief valve route to the drain.

Temperature and occupant safety

An establishment that welcomes children or seniors has to reconcile two requirements: keeping the tank water hot enough for good hygiene, and delivering water at the taps that does not pose a scalding risk. When designing the installation, we review with you the presence of mixing valves at the points of use and the setting to retain for the tank. These are simple decisions, but they are made before commissioning, not after.

Hygiene and tank protection

The tank is lined with Vitraglas with Microban, an antimicrobial technology. According to Bradford White’s documentation, NSF kits are offered for the CEHD, ASME construction is available and the design is UL certified for field conversion. For an establishment that is subject to inspections, these references simplify exchanges with the authorities and building professionals.

A preventive maintenance plan

In a care or service establishment, maintenance is planned rather than endured. We recommend one visit a year, at a time chosen with management: flushing through the low-restriction brass valve, checking the six screw-in elements and their connections, testing the relief valve and verifying the temperature setting. A worn element is replaced individually, without moving the 335 lb tank from its location.

What remains to be confirmed with you

The full model number of a CEHD specifies the power, voltage, phase and ASME option. Since the six-element version comes in several power ratings, that number is set with you and confirmed at ordering. The manufacturer’s warranty terms that apply to the selected unit are stated in the written quote.

Installation of the Bradford White CEHD80 (24 to 36 kW) by AirGreen

AirGreen is a family business established in Montreal, active for more than fifteen years in heating, ventilation and air conditioning and holder of RBQ licence 5645-9605-01 (ventilation, refrigeration and electrical). In an establishment occupied day and night, the hot water shutoff has to be as short as possible: we prepare the job in advance and coordinate the schedule with management. Our work includes:

  • a free on-site assessment of the mechanical room, access routes, demand and electrical service;
  • a recommendation on power and electrical configuration, confirmed in a written quote;
  • draining and removing the old tank, then disposing of it;
  • connecting the cold and hot water in 1 1/2 in., the relief valve and its discharge;
  • the electrical connections, made under our RBQ licence;
  • commissioning, temperature setting and a check of each element;
  • a maintenance schedule handed to management.

Service area

We work in Montreal, Laval, Longueuil, Brossard, Sainte-Julie, Mirabel, Saint-Eustache and throughout the South Shore and the North Shore.

Request your free on-site estimate for the Bradford White CEHD80, 24 to 36 kW. You will receive a detailed written quote, and financing options are available for your establishment.