BRADFORD WHITE LE250LN3-3NCWW Commercial Electric Water Heater (45 gallons) | Montreal, Laval, Longueuil, South Shore & North Shore

In stock
SKU: LE250LN3-3NCWW
170 L45 US gal of storage
4,500 Wper element
3 yrstank warranty
Talk to an expert · 514 316-2973
3-year tank warranty, 1-year parts3/4 in NPT connections240 V, three-phase
01 · Why this model

What sets the Bradford White LE250LN3 apart

33 7/16 in

Overall height

Bradford White sheet C1411 lists the LE250LN3 at 33 7/16 in floor to top with a 26 in jacket diameter.

140 lb

Shipping weight

Approximate shipping weight is 140 lb.

2 in

Foam insulation

2 in (51 mm) of non-CFC foam covers the sides and top of the tank.

Three-phase

Factory wiring

It ships wired 240 V three-phase with two non-simultaneous 4,500 W elements, field-convertible to single-phase or simultaneous operation.

02 · How it works

Cold water at the bottom, hot water on top

Cold watergoes down the dip tubeHot waterdrawn from the topUpper elementand its thermostatLower elementand its thermostatCold waterarrives at the bottom
  1. Cold water arrives at the bottom of the tank. Hot water, being lighter, stays on top, where it is drawn.
  2. The elements, each controlled by its thermostat, bring the water back to the set temperature.
  3. Foam insulation limits the heat lost while the water waits.
03 · Will it fit?

Check the height and the way in before our visit

It travels upright. Measure the ceiling at the spot and the narrowest door on the way.

in
in

Unit: 33.44 in tall (849 mm), 26 in across (660 mm), about 140 lb shipping weight. The clearances the manufacturer requires are checked on site.

04 · Your current tank

How old is yours?

The year it was made is on the tank’s rating plate. Enter it.

Signs it is wearing out

  • Hot water runs out sooner than it used to.
  • The water comes out slightly reddish.
  • Rust shows at the bottom of the tank.
  • Moisture or drips around the unit.

Manufacturers announce a 10 to 15 year life. Many insurers require replacement after 10 or 12 years and may refuse a water damage claim past that age (CAA-Québec). Check your policy.

05 · Installation

What the spot needs, and who does what

240 V circuit4,500 W elements, three-phase. A dedicated circuit, sized by our electrician.
3/4 in NPT waterCold inlet, hot outlet and an accessible shut-off valve.
T&P valveTemperature and pressure relief valve, with its discharge line.
Pan and detectorDrip pan under the tank and a leak detector: strongly recommended (CAA-Québec).
60 °C, 49 °CTank set to 60 °C against bacteria; 49 °C max at the shower and tub (Construction Code, art. 2.2.10.7).

AirGreenFree visit and quote, electrical connection (RBQ licence 5645-9605-01, subclass 16), start-up.

PlumberWater connections and relief valve by a master pipe-mechanic (CMMTQ).

YouA photo of the rating plate, the spot and the stairs saves us a trip.

06 · Maintenance

A few habits that make it last

  1. Start-up daySetting the temperature, with you.
  2. Every yearPartial drain to flush sediment, and a test of the relief valve.
  3. Depending on your waterAnode inspection: it wears so the tank steel does not. In hard water it goes faster.
07 · Spec sheet

Every figure, with its source

Capacity and performance
Model
LE250LN3-3NCWW
Capacity
45 US gal · 170 L
Recovery
18 US gal/h · 68 L/h
Electrical
Supply
240 V, three-phase
Element
4,500 W × 2
Element type
Screw-in copper (Incoloy on request)
Dimensions and connections
Height
33.44 in · 849 mm
Diameter
26 in · 660 mm
Shipping weight (approx.)
140 lb · 64 kg
Water connections
3/4 in NPT
Build and warranty
Inner lining
Vitraglas with Microban
Limited warranty, tank
3 years
Limited warranty, parts
1 year

Manufacturer data. Detailed sources at the bottom of the page.

08 · Same family

The size below and above

37 US gal32.19 in tallSee the smaller one
45 US gal33.44 in tallYou are here
09 · Questions

What people ask us most

Is there a LogisVert grant for this water heater?

No. Hydro-Québec’s LogisVert guide (version 1.10, September 15, 2026) lists no water heater among its eligible measures. At quote time we check other programs that could apply to your address.

What temperature should the tank be set to?

To 60 °C, as the Québec government recommends, to limit bacterial growth. At shower and tub valves, the Construction Code caps the water at 49 °C: that is the job of the valve or a thermostatic mixing valve.

Who does the installation?

AirGreen does the visit, the electrical connection under its RBQ licence (subclass 16) and the start-up. The water connections are done by a master pipe-mechanic (CMMTQ).

10 · AirGreen

We check the spot before we sell you anything

Free on-site estimate, written quote. Send a photo of your current tank and its plate, and we prepare the visit.

Book my free estimate
Sources checked November 2, 2026.
  1. Bradford White Canada ElectriFLEX LD Lowboy spec sheet C1411-1024 CANADA · cdn.shopify.com
  2. Québec.ca, “Eau chaude”, updated November 5, 2025 (186 L/day, 7 °C water, 60 °C, volumes per use).
  3. Québec Construction Code, Chapter III Plumbing, art. 2.2.10.7 (RBQ).
  4. CAA-Québec, “Chauffe-eau: quelle capacité choisir”, updated June 29, 2026.
  5. Hydro-Québec, LogisVert residential participation guide, version 1.10, September 15, 2026.

Costs shown are indicative estimates before tax.

A 45 US gallon reserve in a tank 33 7/16 in. high, for low basements and mechanical mezzanines

In older commercial buildings in Montreal, the water heater is often in a basement where you can barely stand up, or on a mechanical mezzanine added during a renovation. Replacing the existing unit with a vertical tank of the same capacity then becomes impossible. The Bradford White LE250LN3-3NCWW commercial electric water heater solves that puzzle: it offers 45 US gallons (37 imperial gallons, 170 L) in a tank only 33 7/16 in. high, with two 4,500 W elements. AirGreen installs it in businesses, clinics and offices in Montreal, Laval, Longueuil, the South Shore and the North Shore.

Low-ceilinged commercial basements

A low basement is not only a question of height. The unit also has to be brought down, manoeuvred between columns and ducts, and then left with enough space for service. At 26 in. (660 mm) in diameter and 140 lb (64 kg) empty, the LE250LN3-3NCWW is handled by two people with the right equipment. Its low height leaves the room needed for connections and access to the elements, even under low joists.

During the assessment, we measure the stairs, the passages and the clear height at the planned location. We also check for a drain for the relief valve and flushing, a point often overlooked in old basements.

Manufacturer data for the LE250LN3-3NCWW

  • Capacity: 45 US gallons (37 imperial gallons, 170 L).
  • Recovery: 18 US gallons per hour (15 imperial gallons) at a 100 °F rise; 68 L/h at a 56 °C rise, in 4,500 W/4,500 W non-simultaneous operation.
  • Simultaneous operation: according to the manufacturer, recovery approximately doubles.
  • Elements: two 4,500 W screw-in immersion elements, copper; INCOLOY-type element available on request.
  • Factory wiring: 240 V three-phase, interlocking (non-simultaneous), unless otherwise specified.
  • Voltages provided: 120 V, 208 V, 240 V, 277 V and 480 V; 380 V in the kit table.
  • Water connections: 3/4 in. (19 mm) NPT, factory-installed true dielectric fittings.
  • Tank: Vitraglas vitreous enamel with Microban.
  • Dimensions: 33 7/16 in. (849 mm) high, 26 in. (660 mm) in diameter. Weight: 140 lb (64 kg).

A reserve for several fixtures

With 45 US gallons, the LE250LN3-3NCWW can supply several fixtures at once: the washbasins of a medical or dental clinic, the kitchenette and washrooms of an office, or the sinks of a small food business. The reserve covers the moments when everyone draws at the same time, and the recovery of 18 US gallons per hour, in non-simultaneous mode, rebuilds it between peaks.

If demand grows, the unit can be converted on site for simultaneous operation, which approximately doubles recovery according to Bradford White. This option does require a circuit able to supply both 4,500 W elements at the same time; we recommend it only after checking your panel.

Installing on a mezzanine or a platform

A mechanical mezzanine is a good way to free up floor space, but it must be designed for the load. Once filled, a 45 US gallon tank weighs far more than its 140 lb empty. We check the structure with you before confirming the location. Above an occupied space, we also recommend a drain pan connected to a drain: it is a simple precaution that can prevent water damage in the space below.

Factory wiring and electrical options

Bradford White ships this water heater in the standard three-phase configuration, wired at 240 V with two interlocked 4,500 W elements. The unit can be converted on site to single-phase, to simultaneous operation, or both. The manufacturer asks that wattage and voltage be specified when ordering; we therefore confirm the exact configuration in our written quote once the building’s supply has been checked. The electrical connections are made under our RBQ licence.

Components built to last

The tank is lined with Vitraglas vitreous enamel with Microban, an antimicrobial technology, and its true dielectric fittings, installed at the factory, limit corrosion at the joint with the piping. The standard elements are copper, screw-in immersion type; an INCOLOY-type element is available on request for hard or aggressive water. Each element is replaced individually, without taking the tank out of its location, a real advantage in a hard-to-reach basement.

Maintenance in a tight space

In a low basement or on a mezzanine, maintenance is easier when it was planned from the installation. We leave clear access to the drain valve, the elements and the relief valve. We then recommend one visit a year: flushing to clear sediment, checking the elements and their thermostats, and testing the relief valve.

Listing and warranty

According to Bradford White’s documentation, all models are UL listed. The "3" in the model number corresponds to the 3-year limited tank warranty and 1 year on parts. A 5-year warranty version exists under a different number; we can check its availability when preparing the quote.

Installation of the Bradford White LE250LN3-3NCWW by AirGreen

AirGreen is a family business established in Montreal, active for more than fifteen years in heating, ventilation and air conditioning and holder of RBQ licence 5645-9605-01 (ventilation, refrigeration and electrical). Difficult spaces are part of our everyday work: we plan every step before we start. Our work includes:

  • a free on-site assessment of access, clear height, structure and the electrical panel;
  • a recommendation on the electrical configuration, confirmed in a written quote;
  • draining and removing the old tank, then disposing of it;
  • connecting the cold and hot water in 3/4 in., the relief valve and its discharge;
  • the electrical connections, made under our RBQ licence;
  • commissioning, setting the thermostats and checking both elements;
  • maintenance advice suited to the location.

Service area

We work in Montreal, from Old Montreal to Outremont and from Saint-Henri to Rosemont, in Laval, Longueuil, Saint-Lambert and throughout the South Shore and the North Shore.

Request your free on-site estimate for the Bradford White LE250LN3-3NCWW. You will receive a detailed written quote, and financing options are available for your project.