BRADFORD WHITE LE330S3-3NCWW Commercial Electric Water Heater (30 gallons) | Montreal, Laval, Longueuil, South Shore & North Shore

In stock
SKU: LE330S3-3NCWW
114 L30 US gal of storage
4,500 Wper element
3 yrstank warranty
Talk to an expert · 514 316-2973
3-year tank warranty, 1-year parts3/4 in NPT connections240 V, three-phase
01 · Why this model

What sets the Bradford White LE330S3 apart

48 15/16 in

Overall height

Bradford White sheet C1410 lists the LE330S3 at 48 15/16 in floor to top with a 20 in jacket diameter.

100 lb

Shipping weight

Approximate shipping weight is 100 lb.

2 in

Foam insulation

2 in (51 mm) of non-CFC foam covers the sides and top of the tank.

Three-phase

Factory wiring

It ships wired 240 V three-phase with two non-simultaneous 4,500 W elements, field-convertible to single-phase or simultaneous operation.

02 · How it works

Cold water at the bottom, hot water on top

Cold watergoes down the dip tubeHot waterdrawn from the topUpper elementand its thermostatLower elementand its thermostatCold waterarrives at the bottom
  1. Cold water arrives at the bottom of the tank. Hot water, being lighter, stays on top, where it is drawn.
  2. The elements, each controlled by its thermostat, bring the water back to the set temperature.
  3. Foam insulation limits the heat lost while the water waits.
03 · Will it fit?

Check the height and the way in before our visit

It travels upright. Measure the ceiling at the spot and the narrowest door on the way.

in
in

Unit: 48.94 in tall (1243 mm), 20 in across (508 mm), about 100 lb shipping weight. The clearances the manufacturer requires are checked on site.

04 · Your current tank

How old is yours?

The year it was made is on the tank’s rating plate. Enter it.

Signs it is wearing out

  • Hot water runs out sooner than it used to.
  • The water comes out slightly reddish.
  • Rust shows at the bottom of the tank.
  • Moisture or drips around the unit.

Manufacturers announce a 10 to 15 year life. Many insurers require replacement after 10 or 12 years and may refuse a water damage claim past that age (CAA-Québec). Check your policy.

05 · Installation

What the spot needs, and who does what

240 V circuit4,500 W elements, three-phase. A dedicated circuit, sized by our electrician.
3/4 in NPT waterCold inlet, hot outlet and an accessible shut-off valve.
T&P valveTemperature and pressure relief valve, with its discharge line.
Pan and detectorDrip pan under the tank and a leak detector: strongly recommended (CAA-Québec).
60 °C, 49 °CTank set to 60 °C against bacteria; 49 °C max at the shower and tub (Construction Code, art. 2.2.10.7).

AirGreenFree visit and quote, electrical connection (RBQ licence 5645-9605-01, subclass 16), start-up.

PlumberWater connections and relief valve by a master pipe-mechanic (CMMTQ).

YouA photo of the rating plate, the spot and the stairs saves us a trip.

06 · Maintenance

A few habits that make it last

  1. Start-up daySetting the temperature, with you.
  2. Every yearPartial drain to flush sediment, and a test of the relief valve.
  3. Depending on your waterAnode inspection: it wears so the tank steel does not. In hard water it goes faster.
07 · Spec sheet

Every figure, with its source

Capacity and performance
Model
LE330S3-3NCWW
Capacity
30 US gal · 114 L
Recovery
18 US gal/h · 68 L/h
Electrical
Supply
240 V, three-phase
Element
4,500 W × 2
Element type
Screw-in copper (Incoloy on request)
Dimensions and connections
Height
48.94 in · 1,243 mm
Diameter
20 in · 508 mm
Shipping weight (approx.)
100 lb · 45 kg
Water connections
3/4 in NPT
Build and warranty
Inner lining
Vitraglas with Microban
Limited warranty, tank
3 years
Limited warranty, parts
1 year

Manufacturer data. Detailed sources at the bottom of the page.

08 · Same family

The size below and above

30 US gal48.94 in tallYou are here
40 US gal49.44 in tallSee the larger one
09 · Questions

What people ask us most

Is there a LogisVert grant for this water heater?

No. Hydro-Québec’s LogisVert guide (version 1.10, September 15, 2026) lists no water heater among its eligible measures. At quote time we check other programs that could apply to your address.

What temperature should the tank be set to?

To 60 °C, as the Québec government recommends, to limit bacterial growth. At shower and tub valves, the Construction Code caps the water at 49 °C: that is the job of the valve or a thermostatic mixing valve.

Who does the installation?

AirGreen does the visit, the electrical connection under its RBQ licence (subclass 16) and the start-up. The water connections are done by a master pipe-mechanic (CMMTQ).

10 · AirGreen

We check the spot before we sell you anything

Free on-site estimate, written quote. Send a photo of your current tank and its plate, and we prepare the visit.

Book my free estimate
Sources checked November 2, 2026.
  1. Bradford White Canada ElectriFLEX LD Upright spec sheet C1410-1024 CANADA · cdn.shopify.com
  2. Québec.ca, “Eau chaude”, updated November 5, 2025 (186 L/day, 7 °C water, 60 °C, volumes per use).
  3. Québec Construction Code, Chapter III Plumbing, art. 2.2.10.7 (RBQ).
  4. CAA-Québec, “Chauffe-eau: quelle capacité choisir”, updated June 29, 2026.
  5. Hydro-Québec, LogisVert residential participation guide, version 1.10, September 15, 2026.

Costs shown are indicative estimates before tax.

A 30 US gallon commercial water heater with a narrow diameter that gets through where a standard tank gets stuck

In a small commercial space, the water heater often hides in a closet, behind a narrow door or in a cluttered corner of a stockroom. When it is time to replace it, the first obstacle is not technical: it is getting it through. The Bradford White LE330S3-3NCWW commercial electric water heater solves that with a 30 US gallon tank (25 imperial gallons, 114 L) only 20 in. (508 mm) in diameter. It includes two 4,500 W elements and factory three-phase commercial wiring. AirGreen installs it in businesses and offices in Montreal, Laval, Longueuil, the South Shore and the North Shore.

It suits neighbourhood businesses, commercial condo units, small professional offices and branches whose hot water use remains moderate: a few washbasins, a kitchenette, a service sink.

A 20 in. diameter: the advantage of getting through

A narrow tank is easier to carry down a staircase, slips through a door frame and leaves room around it in a utility closet. At 20 in. in diameter and 100 lb (45 kg) empty, the LE330S3-3NCWW is handled by two people without heavy equipment. Once in place, it leaves more space to move around, to reach the neighbouring electrical panel or to store maintenance supplies.

Height matters too: the relief valve is installed on top of the unit, and its discharge pipe must be able to run down to a drain. We confirm the model’s exact height with the manufacturer before ordering, then check the space available above the unit during the assessment.

Manufacturer data for the LE330S3-3NCWW

  • Capacity: 30 US gallons (25 imperial gallons, 114 L).
  • Recovery: 18 US gallons per hour (15 imperial gallons) at a 100 °F rise; 68 L/h at a 56 °C rise, in 4,500 W/4,500 W non-simultaneous operation.
  • Elements: two 4,500 W screw-in immersion elements, copper; INCOLOY-type element available on request.
  • Factory wiring: 240 V, three-phase, interlocking (non-simultaneous operation).
  • Conversion kits: listed for 120, 208, 240, 277, 380, 480 V.
  • Connections: all electrical and water connections are 3/4 in. NPT (19 mm); factory-installed dielectric fittings.
  • Relief valve: installed on top.
  • Tank: Vitraglas lining with Microban.
  • Diameter: 20 in. (508 mm). Weight: 100 lb (45 kg).

Two elements taking turns

In the factory configuration, the two 4,500 W elements are wired interlocking and never run together. This approach limits the electrical load while providing a recovery of 18 US gallons per hour at a 100 °F rise, according to Bradford White. For a small business, it is a good compromise: the 30 US gallon reserve covers the peaks, and the recovery is enough to bring it back up between them.

Single-phase or simultaneous conversion on site

The LE330S3-3NCWW is shipped from the factory as a standard three-phase, non-simultaneous model. The manufacturer provides that it can be converted on site to a single-phase model or for simultaneous operation. Single-phase conversion matters for the many spaces without three-phase power. Simultaneous operation lets both elements heat together for faster recovery, within the limits of the power table the manufacturer publishes for each mode.

These choices depend directly on your panel. We check the available supply and the remaining capacity, then confirm the selected configuration in the written quote. The electrical connections are made under our RBQ licence.

The businesses it suits

  • The neighbourhood business with a washroom and a service sink.
  • The commercial condo unit, where the water heater has to fit in a closet originally planned for a smaller appliance.
  • The professional office with a kitchenette and two washrooms.
  • The branch or service point whose consumption is steady but modest.

Copper or INCOLOY element

The standard elements are copper, screw-in immersion type. Bradford White offers an INCOLOY-type element on request, an alloy more resistant to corrosion, useful when the water is hard or aggressive. In both cases, the elements are replaced one at a time, without removing the tank.

Tank protection, listing and warranty

The tank is lined with Vitraglas with Microban, an antimicrobial technology, and the factory-installed dielectric fittings limit corrosion between the piping and the tank. According to the manufacturer’s documentation, all models are UL listed. The "3" in the model number corresponds to the 3-year limited tank warranty and 1 year on parts; a 5-year warranty version exists under a different number.

Recommended maintenance

One visit a year is generally enough for moderate commercial use: flushing the tank to clear sediment, checking both elements and their thermostats, and testing the relief valve on top of the unit. These simple steps extend the tank’s life and prevent breakdowns at the wrong moment.

Installation of the Bradford White LE330S3-3NCWW by AirGreen

AirGreen is a family business established in Montreal, active for more than fifteen years in heating, ventilation and air conditioning and holder of RBQ licence 5645-9605-01 (ventilation, refrigeration and electrical). For a replacement in a small space, we plan the job to keep the hot water shutoff to a minimum. Our work includes:

  • a free on-site assessment of the access route, the available space, the use and the electrical panel;
  • a recommendation on the electrical configuration, confirmed in a written quote;
  • draining and removing the old tank, then disposing of it;
  • connecting the cold and hot water in 3/4 in., the relief valve and its discharge;
  • the electrical connections, made under our RBQ licence;
  • commissioning, setting the thermostats and checking both elements;
  • maintenance advice suited to your use.

Service area

We work in Montreal, Laval, Longueuil, Brossard, Beloeil, Rosemère, Lachenaie and throughout the South Shore and the North Shore.

Request your free on-site estimate for the Bradford White LE330S3-3NCWW. You will receive a detailed written quote, and financing options are available for your business.