BRADFORD WHITE LE340S3-3NCWW Commercial Electric Water Heater (40 gallons) | Montreal, Laval, Longueuil, South Shore & North Shore

In stock
SKU: LE340S3-3NCWW
151 L40 US gal of storage
4,500 Wper element
3 yrstank warranty
Talk to an expert · 514 316-2973
3-year tank warranty, 1-year parts3/4 in NPT connections240 V, three-phase
01 · Why this model

What sets the Bradford White LE340S3 apart

49 7/16 in

Overall height

Bradford White sheet C1410 lists the LE340S3 at 49 7/16 in floor to top with a 22 in jacket diameter.

114 lb

Shipping weight

Approximate shipping weight is 114 lb.

2 in

Foam insulation

2 in (51 mm) of non-CFC foam covers the sides and top of the tank.

Three-phase

Factory wiring

It ships wired 240 V three-phase with two non-simultaneous 4,500 W elements, field-convertible to single-phase or simultaneous operation.

02 · How it works

Cold water at the bottom, hot water on top

Cold watergoes down the dip tubeHot waterdrawn from the topUpper elementand its thermostatLower elementand its thermostatCold waterarrives at the bottom
  1. Cold water arrives at the bottom of the tank. Hot water, being lighter, stays on top, where it is drawn.
  2. The elements, each controlled by its thermostat, bring the water back to the set temperature.
  3. Foam insulation limits the heat lost while the water waits.
03 · Will it fit?

Check the height and the way in before our visit

It travels upright. Measure the ceiling at the spot and the narrowest door on the way.

in
in

Unit: 49.44 in tall (1256 mm), 22 in across (559 mm), about 114 lb shipping weight. The clearances the manufacturer requires are checked on site.

04 · Your current tank

How old is yours?

The year it was made is on the tank’s rating plate. Enter it.

Signs it is wearing out

  • Hot water runs out sooner than it used to.
  • The water comes out slightly reddish.
  • Rust shows at the bottom of the tank.
  • Moisture or drips around the unit.

Manufacturers announce a 10 to 15 year life. Many insurers require replacement after 10 or 12 years and may refuse a water damage claim past that age (CAA-Québec). Check your policy.

05 · Installation

What the spot needs, and who does what

240 V circuit4,500 W elements, three-phase. A dedicated circuit, sized by our electrician.
3/4 in NPT waterCold inlet, hot outlet and an accessible shut-off valve.
T&P valveTemperature and pressure relief valve, with its discharge line.
Pan and detectorDrip pan under the tank and a leak detector: strongly recommended (CAA-Québec).
60 °C, 49 °CTank set to 60 °C against bacteria; 49 °C max at the shower and tub (Construction Code, art. 2.2.10.7).

AirGreenFree visit and quote, electrical connection (RBQ licence 5645-9605-01, subclass 16), start-up.

PlumberWater connections and relief valve by a master pipe-mechanic (CMMTQ).

YouA photo of the rating plate, the spot and the stairs saves us a trip.

06 · Maintenance

A few habits that make it last

  1. Start-up daySetting the temperature, with you.
  2. Every yearPartial drain to flush sediment, and a test of the relief valve.
  3. Depending on your waterAnode inspection: it wears so the tank steel does not. In hard water it goes faster.
07 · Spec sheet

Every figure, with its source

Capacity and performance
Model
LE340S3-3NCWW
Capacity
40 US gal · 151 L
Recovery
18 US gal/h · 68 L/h
Electrical
Supply
240 V, three-phase
Element
4,500 W × 2
Element type
Screw-in copper (Incoloy on request)
Dimensions and connections
Height
49.44 in · 1,256 mm
Diameter
22 in · 559 mm
Shipping weight (approx.)
114 lb · 52 kg
Water connections
3/4 in NPT
Build and warranty
Inner lining
Vitraglas with Microban
Limited warranty, tank
3 years
Limited warranty, parts
1 year

Manufacturer data. Detailed sources at the bottom of the page.

08 · Same family

The size below and above

09 · Questions

What people ask us most

Is there a LogisVert grant for this water heater?

No. Hydro-Québec’s LogisVert guide (version 1.10, September 15, 2026) lists no water heater among its eligible measures. At quote time we check other programs that could apply to your address.

What temperature should the tank be set to?

To 60 °C, as the Québec government recommends, to limit bacterial growth. At shower and tub valves, the Construction Code caps the water at 49 °C: that is the job of the valve or a thermostatic mixing valve.

Who does the installation?

AirGreen does the visit, the electrical connection under its RBQ licence (subclass 16) and the start-up. The water connections are done by a master pipe-mechanic (CMMTQ).

10 · AirGreen

We check the spot before we sell you anything

Free on-site estimate, written quote. Send a photo of your current tank and its plate, and we prepare the visit.

Book my free estimate
Sources checked November 2, 2026.
  1. Bradford White Canada ElectriFLEX LD Upright spec sheet C1410-1024 CANADA · cdn.shopify.com
  2. Québec.ca, “Eau chaude”, updated November 5, 2025 (186 L/day, 7 °C water, 60 °C, volumes per use).
  3. Québec Construction Code, Chapter III Plumbing, art. 2.2.10.7 (RBQ).
  4. CAA-Québec, “Chauffe-eau: quelle capacité choisir”, updated June 29, 2026.
  5. Hydro-Québec, LogisVert residential participation guide, version 1.10, September 15, 2026.

Costs shown are indicative estimates before tax.

40 US gallons of commercial-grade design to replace the residential tank struggling to keep up in your business

Many small businesses have run for years on a household water heater. As long as demand stays light, it holds up. But as soon as activity picks up, it runs short of hot water, wears out faster and eventually gives out. The Bradford White LE340S3-3NCWW commercial electric water heater replaces that kind of unit with a 40 US gallon tank (33 imperial gallons, 151 L) designed for commercial use, with two 4,500 W elements and factory three-phase wiring that can be converted on site. AirGreen installs it in businesses in Montreal, Laval, Longueuil, the South Shore and the North Shore.

Residential or commercial: why the difference matters

A residential tank is designed for a family: peaks in the morning and evening, and an appliance that rests the rest of the time. A business uses its water heater differently, often all day long, and sometimes on a three-phase supply. The LE340S3-3NCWW is built for that context: factory three-phase commercial wiring, screw-in elements replaceable individually, factory-installed dielectric fittings, UL listing according to the manufacturer. It can also be converted to single-phase when the space has no three-phase power.

Moving from residential to commercial is often the time to review the whole installation: relief valve, discharge, electrical circuit. We take stock of all of it during the assessment.

Manufacturer data for the LE340S3-3NCWW

  • Capacity: 40 US gallons (33 imperial gallons, 151 L).
  • Recovery: 18 US gallons per hour (15 imperial gallons) at a 100 °F rise; 68 L/h at a 56 °C rise, in 4,500 W/4,500 W non-simultaneous operation.
  • Elements: two 4,500 W screw-in immersion elements, copper; INCOLOY-type element available on request.
  • Factory wiring: 240 V three-phase, interlocking (non-simultaneous); convertible on site to single-phase or simultaneous operation.
  • Conversion kits: listed for 120, 208, 240, 277, 380, 480 V.
  • Connections: electrical and water in 3/4 in. NPT (19 mm); factory-installed dielectric fittings; relief valve installed on top.
  • Tank: Vitraglas lining with Microban.
  • Diameter: 22 in. (559 mm). Weight: 114 lb (52 kg).

The businesses we recommend it for

  • The pet grooming salon, where baths follow one another all day.
  • The veterinary clinic, with its treatment sinks and frequent cleaning.
  • The yoga or training studio with one or two showers.
  • The repair shop or garage where hot water is needed for handwashing and cleaning parts.

In each of these cases, we assess the real demand before confirming the model. If consumption exceeds what a 40 US gallon tank can supply, we tell you from the start.

Recovery and simultaneous operation

In the factory configuration, the two 4,500 W elements take turns: only one heats at a time. According to Bradford White, that configuration provides a recovery of 18 US gallons per hour at a 100 °F rise. For a grooming salon whose baths follow one after another, the manufacturer provides for on-site conversion to simultaneous operation: both elements then heat together, which speeds up recovery, within the limits of the power table published for that mode. This option increases the load on the circuit; we propose it only if your panel allows it.

Electrical supply

The LE340S3-3NCWW is shipped as a standard three-phase model, wired at 240 V. If your space is supplied with single-phase power, which is common in small commercial spaces, the unit can be converted on site. Conversion kits are listed by the manufacturer for 120, 208, 240, 277, 380, 480 V. We check your supply and your panel before confirming the configuration in the written quote, and we make the electrical connections under our RBQ licence.

Installation: a 22 in. diameter and a relief valve on top

At 22 in. in diameter and 114 lb empty, the unit installs in a utility room or a good-sized closet. The relief valve is mounted on top, so space must be planned for the valve and for its discharge pipe, which runs down to a drain. We confirm the model’s exact height with the manufacturer before ordering and check the space available above the unit. Clear access to the elements will make service easier.

Components designed for commercial use

The tank is lined with Vitraglas with Microban, an antimicrobial technology. The factory-installed dielectric fittings limit corrosion between the piping and the tank. The standard elements are copper; an INCOLOY-type element, more resistant to corrosion, is available on request. In a grooming salon or a clinic where hot water runs a lot, this option can extend element life when the water is hard.

Listing, warranty and maintenance

According to Bradford White’s documentation, all models are UL listed. The "3" in the model number corresponds to the 3-year limited tank warranty and 1 year on parts. To preserve the unit, we recommend one visit a year: flushing the tank, checking both elements and their thermostats, and testing the relief valve.

Installation of the Bradford White LE340S3-3NCWW by AirGreen

AirGreen is a family business established in Montreal, active for more than fifteen years in heating, ventilation and air conditioning and holder of RBQ licence 5645-9605-01 (ventilation, refrigeration and electrical). When we replace a residential tank with a commercial unit, we bring the whole installation up to standard. Our work includes:

  • a free on-site assessment of demand, location and electrical supply;
  • a recommendation on the configuration (single-phase or three-phase, simultaneous or not), confirmed in a written quote;
  • draining and removing the old tank, then disposing of it;
  • connecting the cold and hot water in 3/4 in., the relief valve and its discharge;
  • the electrical connections, made under our RBQ licence;
  • commissioning, setting the thermostats and checking both elements;
  • maintenance advice suited to your activity.

Service area

We work in Montreal, Laval, Longueuil, Brossard, Saint-Jean-sur-Richelieu, Blainville, Terrebonne and throughout the South Shore and the North Shore.

Request your free on-site estimate for the Bradford White LE340S3-3NCWW. You will receive a detailed written quote, and financing options are available for your business.