No stored potable water
Potable water runs through copper coils and is heated on demand: the 80 gal tank holds boiler water, not the water you drink.
A tank rarely runs out over a day. It runs out over an hour. Describe your busiest hour.
An indirect’s first-hour rating depends on the boiler; the test conditions are in the spec sheet. Method: the first-hour rating should equal or exceed the hot water of your busiest hour (Natural Resources Canada). CAA-Québec rule of thumb: 40 gal for 1 or 2 people, 60 gal for 3 or 4, 80 to 100 gal for 5 or more. Volumes: Québec.ca.
Potable water runs through copper coils and is heated on demand: the 80 gal tank holds boiler water, not the water you drink.
The copper coils provide 32.7 sq ft of exchange surface for a maximum domestic hot water flow of 15 gpm, per Thermo 2000.
Per Thermo 2000's spec sheet, 'A' models (80A and 120A) meet ASME Section VIII Div. 1, with a 50 psi relief valve.
The 80-5A has a 2 in potable water connection versus 1-1/2 in on the 80-5, with identical performance.
Thermo 2000 covers the tank and copper coils for 15 years in residential use (10 years commercial) and mechanical parts for 2 years.
It travels upright. Measure the ceiling at the spot and the narrowest door on the way.
Unit: 75.38 in tall (1915 mm), 24 in across (610 mm), about 317 lb shipping weight. The clearances the manufacturer requires are checked on site.
The year it was made is on the tank’s rating plate. Enter it.
Manufacturers announce a 10 to 15 year life. Many insurers require replacement after 10 or 12 years and may refuse a water damage claim past that age (CAA-Québec). Check your policy.
AirGreenFree visit and quote, coordination of the work.
HeatingBoiler connection by a hydronic heating contractor (RBQ 15.4).
PlumberWater connections and relief valve by a master pipe-mechanic (CMMTQ).
YouA photo of the rating plate, the spot and the stairs saves us a trip.
Manufacturer data. Detailed sources at the bottom of the page.
No. Hydro-Québec’s LogisVert guide (version 1.10, September 15, 2026) lists no water heater among its eligible measures. At quote time we check other programs that could apply to your address.
Yes. An indirect water heater has no element: it is heated by water from a boiler. The boiler connection is done by a hydronic heating contractor (RBQ 15.4) and the water connections by a master pipe-mechanic (CMMTQ).
To 60 °C, as the Québec government recommends, to limit bacterial growth. At shower and tub valves, the Construction Code caps the water at 49 °C: that is the job of the valve or a thermostatic mixing valve.
Often, yes. According to CAA-Québec, many insurers require replacement after 10 or 12 years and may refuse a water damage claim past that age. The manufacture date is on the rating plate.
It delivers 2,199 L of hot water in the first hour, with the boiler stated in the spec sheet. CAA-Québec’s rule of thumb suggests 40 gal for 1 or 2 people, 60 gal for 3 or 4 and 80 to 100 gal for 5 or more; the “Your home” tool above accounts for your busiest hour.
AirGreen does the visit and the quote and coordinates the work. The water connections are done by a master pipe-mechanic (CMMTQ) and the boiler connection by a hydronic heating contractor (RBQ 15.4).
Free on-site estimate, written quote. Send a photo of your current tank and its plate, and we prepare the visit.
Book my free estimateCosts shown are indicative estimates before tax.
In a café, a daycare, a clinic or a small new building heated by an electric boiler, hot water must circulate through a longer and busier network than in a home. The Thermo 2000 TurboMax 80-5A indirect water heater combines an 80 US gallon tank, a 32.7 sq. ft. copper coil system and 2 in male sweat potable water connections, suited to larger-diameter distribution. AirGreen installs it in Montreal, Laval, Longueuil, on the South Shore and on the North Shore.
The diameter of the potable water connections determines that of the piping leaving the tank. With 2 in connections, the TurboMax 80-5A connects directly to a commercial distribution of good diameter, without a reduction at the outlet. In a building where several sinks, a dishwasher and hand basins are supplied at the same time, properly sized piping limits pressure losses and temperature swings at the tap. The model’s maximum domestic hot water flow is 15 gpm; we design the network around that value and the fixtures to be served.
The consumption profile of a small business has nothing in common with that of a home. In a café, the pot sink and dishwasher run continuously at busy times. In a daycare, handwashing, dishes and cleaning are spread over the whole day, with peaks at lunch. In a clinic, the hand basins run from morning to night. The TurboMax 80-5A meets these profiles with an 80 US gallon reserve that absorbs the peaks and an exchanger that keeps production going as long as the electric boiler supplies the necessary heat.
Several commercial uses require hotter water than a shower. Thermo 2000’s table shows, for water at 140 °F, 581 US GPH in the first hour and 549 US GPH continuous; at 160 °F, 316 US GPH and 302 US GPH. The manufacturer specifies that these values must be reduced for high-temperature and continuous-flow applications. When water is produced at a high temperature, a thermostatic mixing valve brings the water delivered to hand basins and washrooms back to a safe temperature, which matters especially in a daycare.
The published flows assume that the boiler supplies the exchanger’s maximum exchange capacity, up to 645,000 BTU/h (189 kW) for water at 110 °F. With an electric boiler, the available capacity depends on the building’s electrical service, and it is that capacity that sets the real continuous output. We establish this capacity from the start, then tell you the expected output. If a gap remains with your needs, we discuss it before ordering rather than after commissioning.
In a new project, the best time to plan hot water is at the drawing stage. The TurboMax 80-5A is 74 3/4 in high and 24 in in diameter and weighs 317 lb empty. You need enough free height, taking the top fittings into account, a floor able to carry the filled tank, a nearby drain and clear access for service. The boiler connection is 1 1/2 in NPT male. The tank drain valve, supplied as standard, makes yearly maintenance easier.
In a business, a hot water outage is costly: a kitchen cannot open, a daycare has to make other arrangements. We recommend a yearly visit scheduled outside opening hours. It includes a test of the relief valve, a check of the circulator, the control and the mixing valve, an inspection of the fittings and a partial draining through the tank drain valve when the water carries sediment.
Thermo 2000 provides a 10-year commercial warranty, a 15-year residential warranty and a 2-year warranty on mechanical components. The warranty applicable to your building is confirmed in writing with the quote.
AirGreen is a family business established in Montreal and active in heating, ventilation and air conditioning for more than fifteen years, holding RBQ licence 5645-9605-01 in ventilation, refrigeration and electrical work. For this indirect water heater, our service includes:
We work with business owners, developers and property managers in Montreal, Laval, Longueuil, Brossard, Boucherville, Saint-Bruno, Mirabel, Terrebonne and the entire South Shore and North Shore. Free on-site estimate, written quote and financing available.
Request your free quote for the Thermo 2000 TurboMax 80-5A. Send us your drawings or a few photos of your mechanical room: we will propose a clear, compliant installation.