Uniform Energy Factor
Bradford White's Canadian spec sheet lists a UEF of 3.44 for the RE2H50S10, based on the AHRI directory.
Pick your household. The math follows your hot water use, at the current Hydro-Québec rate.
per year in heat pump mode, for 186 L of hot water a day
How we calculate. Mains water at 7 °C heated to 60 °C (Québec.ca), 75 L per person per day (Natural Resources Canada) or 186 L for the average Québec household. This model: energy ÷ UEF of 3.44. Standard tank: the same energy plus 59 W of standby loss (Bradford White RE250S6). Price: 11.142 ¢/kWh, Rate D second tier in force since April 1, 2026, before tax. UEF is a lab rating: in a cold basement in winter the elements do more of the work, and part of the heat comes from the house heating. Indicative estimate.
A tank rarely runs out over a day. It runs out over an hour. Describe your busiest hour.
Method: the first-hour rating should equal or exceed the hot water of your busiest hour (Natural Resources Canada). CAA-Québec rule of thumb: 40 gal for 1 or 2 people, 60 gal for 3 or 4, 80 to 100 gal for 5 or more. Volumes: Québec.ca.
Bradford White's Canadian spec sheet lists a UEF of 3.44 for the RE2H50S10, based on the AHRI directory.
The manufacturer lists a first-hour rating of 65 US gallons (246 L).
The heat pump runs in ambient air from 2 to 49 °C (35 to 120 °F); outside that range the unit switches to electric mode.
The installation manual requires a room of at least 700 cu ft (19.8 m³), otherwise louvers or a ducting kit are needed.
The '10' suffix means a 10-year limited warranty on both the tank and component parts.
It travels upright. Measure the ceiling at the spot and the narrowest door on the way.
Unit: 59.19 in tall (1503 mm), 21.75 in across (552 mm), about 195 lb shipping weight. The clearances the manufacturer requires are checked on site.
The year it was made is on the tank’s rating plate. Enter it.
Manufacturers announce a 10 to 15 year life. Many insurers require replacement after 10 or 12 years and may refuse a water damage claim past that age (CAA-Québec). Check your policy.
AirGreenFree visit and quote, electrical connection (RBQ licence 5645-9605-01, subclass 16), start-up and mode setting.
PlumberWater connections and relief valve by a master pipe-mechanic (CMMTQ).
YouA photo of the rating plate, the spot and the stairs saves us a trip.
Manufacturer data. Detailed sources at the bottom of the page.
No. Hydro-Québec’s LogisVert guide (version 1.10, September 15, 2026) lists no water heater among its eligible measures. At quote time we check other programs that could apply to your address.
Yes, as long as the room air stays between 2.0 and 49.0 °C. In a heated basement, part of the heat it captures comes from the house heating. Outside its range, it switches to the electric elements.
To 60 °C, as the Québec government recommends, to limit bacterial growth. At shower and tub valves, the Construction Code caps the water at 49 °C: that is the job of the valve or a thermostatic mixing valve.
Often, yes. According to CAA-Québec, many insurers require replacement after 10 or 12 years and may refuse a water damage claim past that age. The manufacture date is on the rating plate.
It delivers 246 L of hot water in the first hour. CAA-Québec’s rule of thumb suggests 40 gal for 1 or 2 people, 60 gal for 3 or 4 and 80 to 100 gal for 5 or more; the “Your home” tool above accounts for your busiest hour.
AirGreen does the visit, the electrical connection under its RBQ licence (subclass 16) and the start-up. The water connections are done by a master pipe-mechanic (CMMTQ).
Free on-site estimate, written quote. Send a photo of your current tank and its plate, and we prepare the visit.
Book my free estimateCosts shown are indicative estimates before tax.
In most homes across Greater Montreal, hot water comes from an electric tank in the basement that heats water with resistance elements alone. The Bradford White RE2H50S10-1NCTT heat pump water heater, part of the AeroTherm range, keeps that familiar format, but it produces most of its heat with a built-in heat pump mounted on top of the tank. The electric elements stay in place to take over when needed. At AirGreen, we install it in Montreal, Laval, Longueuil, on the South Shore and on the North Shore, most often to replace an electric tank that has reached the end of its life.
This model is for homeowners who want to cut the share of hot water in their electricity use without changing their habits: the same morning shower, the same evening dishwasher load, with an appliance that works differently. It suits a detached house, a semi-detached or a condo that has a mechanical room. For a family of four, for example, a tank this size is the format already found in many basements, which keeps the replacement simple.
A heating element turns electricity into heat, nothing more. A heat pump moves heat that already exists. A fan draws room air across an evaporator, the refrigerant picks up the heat, the compressor concentrates it, and that heat then passes into the water in the tank. It is the same cycle as a wall-mounted heat pump or an air conditioner, applied to domestic water.
A direct result: the air leaving the unit is cooler and drier than the air it takes in. In summer, this slightly cools and dries the basement, something many homeowners appreciate in a damp basement. In winter, in a heated room, part of the captured heat comes from the house heating system. We factor that into our recommendations instead of promising you a catalogue result.
The control panel offers five modes, which we set with you on commissioning day:
The Uniform Energy Factor compares the energy delivered as hot water with the energy the unit consumes, in a standardized test. At 3.44, the RE2H50S10-1NCTT delivers, under those test conditions, more than three times the electrical energy it uses. A tank with elements alone cannot, by principle, deliver more energy than it receives. In your home, the real result will depend on the room temperature, the mode selected and your habits: that is exactly what we look at with you during the visit.
The RE2H50S10-1NCTT goes where the tank usually sits: a basement, a mechanical room or a laundry room. Because it draws its heat from the surrounding air, the location must meet the requirements of Bradford White’s installation manual, which we review point by point during the visit, before confirming the project.
Height matters too. At 59 3/16 in. tall, the unit fits under most basement ceilings, but the access needed to service the heat pump must also be planned. We measure the clear height, the stairs and the door frames before confirming the project: the water heater weighs 195 lb empty and its 21 3/4 in. diameter has to clear every passage to its final location.
Finally, room temperature affects performance. A finished, temperate basement offers good conditions all year. In a room that gets quite cold in winter, the elements take on a larger share of the work, and electric mode remains available to keep hot water flowing at all times.
This water heater connects like a conventional tank: cold water inlet and hot water outlet in 3/4 in. NPT, with dielectric fittings already installed at the factory to limit corrosion between dissimilar metals. The temperature and pressure relief valve is connected to a discharge pipe that complies with the Quebec Construction Code. The low-restriction brass drain valve makes maintenance flushing quicker.
On the electrical side, the unit runs on 240 V/208 V single-phase, like most residential tanks. Its two elements are wired interlocking: they never heat at the same time. In many homes, the existing circuit is adequate. We check it during the assessment and we make the electrical connections under our RBQ licence.
The inside of the tank is protected by Vitraglas vitreous enamel with Microban, an antimicrobial technology, and by a protective anode rod that wears instead of the steel. The backup electric elements are screw-in, so they can be replaced without removing the unit. According to Bradford White’s documentation, the model is ENERGY STAR certified, UL listed, meets NAECA requirements and is C.E.C. listed.
The "10" suffix in the model number designates the extended-warranty version: Bradford White gives the RE2H50S10-1NCTT a 10-year limited warranty on the tank and 10 years on parts. For an appliance that combines a tank, a compressor and control electronics, that parts coverage carries real weight. We hand you the manufacturer’s documentation with your invoice so you have it on hand.
AirGreen is a family business established in Montreal and active for more than fifteen years in heating, ventilation and air conditioning, holding RBQ licence 5645-9605-01 (ventilation, refrigeration and electrical). A heat pump water heater calls on the same know-how as the heat pumps we install every day: refrigerant, compressor, airflow and electrical work. Our installation includes:
Energy efficiency assistance programs change over the year. When we prepare your quote, we check which ones actually apply to your address and your project.
We install this water heater in Montreal, Laval, Longueuil, Brossard, Boucherville, Terrebonne, Repentigny and throughout the South Shore and the North Shore.
Request your free on-site estimate for the Bradford White RE2H50S10-1NCTT. You then receive a detailed written quote, and financing options are available to spread out your project.