Central Heat Pump ARCOAIRE QuietComfort Compact | 2.5 Tons - 30,000 BTU (Air Handler D5FUAA) - R454B
A central heat pump that keeps its capacity as the cold sets in
Most heat pumps lose capacity as the outdoor temperature drops. According to its certificate, the Central Heat Pump ARCOAIRE QuietComfort Compact | 2.5 Tons - 30,000 BTU (Air Handler D5FUAA) - R454B does better than hold on: at -15 °C, it delivers more than its nominal size. It pairs the D5CUHAH30AAK outdoor unit with the matching-size D5FUAAH30XAK cabinet, which replaces the furnace and distributes air through the existing ductwork.
Its certified ratings are 16.9 SEER2, 11.7 EER2 and 10.0 HSPF2. The system is ENERGY STAR certified with the cold-climate designation under ENERGY STAR ID 3560727, its certificate lists capacity down to -30 °C, and our product sheet shows an indicative LogisVert amount of $2,856.
More than its nominal capacity at -15 °C
The certificate lists 23,800 BTU/h at -8 °C (17 °F) with a COP of 2.76, then 32,600 BTU/h at -15 °C (5 °F) with a COP of 1.96. That second figure is about 109% of the 30,000 BTU/h nominal size. The two points are measured separately; we report each one as published, without extrapolating.
These figures come from certificate AHRI 215318890, published by NEEP. For a home in Laval or on the North Shore, where -15 °C mornings are nothing unusual in January, this means the heat pump keeps carrying most of the heating when another would already have left a large share to backup heat.
What this changes in choosing the size
When a heat pump loses a lot of capacity in the cold, it is tempting to choose a bigger size to cover winter. That choice takes its toll the rest of the year: an oversized unit short-cycles in spring and fall, and cools poorly in summer, because it chills the air too quickly without removing its moisture.
With winter capacity like this, it becomes possible to choose the size from the on-site assessment, with no upsizing for winter. In summer, the system then runs for long periods at low speed: air passing over the cold coil loses its moisture, the temperature stays steady, and the house is cool without being clammy. Condensate drains from the cabinet to a floor drain or a pump.
Down to -30 °C: the share of backup heat
At -30 °C, the certificate still lists 20,100 BTU/h with a COP of 1.55. Even on the coldest nights of a Montreal winter, the heat pump therefore still delivers one and a half times the heat it uses in electricity.
A house may still lose more heat than the outdoor unit supplies at those temperatures. Electric backup, usually housed in the cabinet, then supplements the heating. We size it from the on-site assessment and set the thermostat so it only comes on when needed. With a heat pump that keeps its capacity, those backup hours are fewer.
Which homes it suits
The 2.5-ton size, or 30,000 BTU/h, often suits a two-storey cottage, a large bungalow with a finished basement or a wind-exposed house on the outskirts, on the North Shore or the South Shore. It is a good choice for owners whose priority is heating and who want to reduce the role of electric backup.
The examples are only indicative: insulation, windows, airtightness and orientation change the needs from one home to the next. A room-by-room on-site assessment confirms the size before any quote.
Variable speed and R-454B refrigerant
The variable-speed (inverter) compressor adjusts its speed to demand. It is what lets the heat pump speed up as the cold intensifies, then slow down when demand drops, instead of switching between off and full power. The house keeps a steady temperature and the system spends most of the year at part load, where its efficiency is at its best.
The system runs on R-454B, the refrigerant manufacturers have adopted for their new central heat pumps; if it leaks, its effect on global warming is much lower than that of the refrigerant it replaces. It belongs to the A2L class, known as mildly flammable, and its installation follows specific requirements that our refrigeration technicians apply.
The D5FUAA cabinet and the ductwork
The D5FUAAH30XAK cabinet houses the indoor coil and the blower. It is installed where the old furnace stood and connects to the existing supply plenum and air return. A heat pump delivers air that is less hot than a furnace's, but for longer: the duct system has to keep up. We check the main ducts, branches, registers and air return, and list useful corrections in the quote.
We also take care with the cabinet's location in the mechanical room: clear access to the filter and service panels, a condensate drain that flows by gravity whenever possible, and a tight connection to the plenum. These details appear on no certificate, but they are what allow the system to keep its ratings year after year.
The certified ratings, one by one
- 10.0 HSPF2: efficiency over the whole heating season. It is the rating that weighs most on the annual bill of an electrically heated home.
- COP of 2.76 at -8 °C: at that temperature, the heat pump delivers more than two and a half times the heat it uses. An electric baseboard has a COP of 1.
- 16.9 SEER2: cooling efficiency over a typical summer.
- 11.7 EER2: cooling efficiency at full load, on a hot day.
Indicative LogisVert amount: $2,856
Our product sheet shows an indicative LogisVert amount of $2,856 for the owner of an existing home (Hydro-Québec program, according to the list in effect on the installation date). Only Hydro-Québec confirms the amount granted. The amount corresponds to the certified pairing of the D5CUHAH30AAK outdoor unit and the D5FUAAH30XAK cabinet.
We confirm eligibility before signing and prepare the detailed invoice, model numbers and proof of payment. Our page on the efficient heat pump grant summarizes the program's conditions.
Installation by AirGreen
Installation, step by step
- Visit: room-by-room on-site assessment, inspection of the ducts and air return, choice of the outdoor location.
- Written quote: size, backup heat, corrections to the duct system.
- Indoor unit: removal of the furnace, installation of the D5FUAA cabinet, connection to the plenum, air return and condensate drain.
- Outdoor unit: wall bracket or stand, above the snow line, away from roof drip and, as far as possible, from prevailing winds.
- Refrigerant circuit: insulated copper line set, brazing, pressure test and vacuum.
- Electrical: dedicated circuit, outdoor disconnect, thermostat.
- Commissioning: charge, airflow, defrost, backup heat settings and an explanation of the controls.
Maintenance
A heat pump that heats in deep cold spends a lot of time working in winter; its outdoor unit needs room to breathe. After a storm, clear the snow around the unit and check that no ice is blocking the coil, without ever covering it. Check the cabinet's filter every month in season and replace it according to its format. Annual HVAC maintenance cleans the coils and checks the condensate drain, the electrical connections and the backup heat. The white vapour the unit releases during defrost is normal.
Warranty
Warranty: 10 years on the compressor, 10 years on parts and 6 years on labor.
It applies to the pairing as installed. Keep the invoice and the commissioning report, which list the serial numbers of both units.
AirGreen, for the life of the installation
A family business active for more than fifteen years in Montreal, Laval, Longueuil, the North Shore and the South Shore, we hold RBQ licences for ventilation, refrigeration and electrical work and carry $5,000,000 in liability insurance. The in-home assessment is free, the quote is in writing, and our financing options let you choose the right unit rather than the cheapest one.
Request your free estimate for the Central Heat Pump ARCOAIRE QuietComfort Compact | 2.5 Tons - 30,000 BTU (Air Handler D5FUAA) - R454B. We assess the home room by room and confirm the right size and your grant eligibility before signing.
