BRADFORD WHITE RE250T6-1NCPP Electric Water Heater (47 gallons) | Montreal, Laval, Longueuil, South Shore & North Shore

In stock
SKU: RE250T6-1NCPP
178 L47 US gal of storage
6 yrstank warranty
Talk to an expert · 514 316-2973
6-year tank warranty, 6-year parts3/4 in NPT connections240 V
01 · Running cost

What it will cost you each year

Pick your household. The math follows your hot water use, at the current Hydro-Québec rate.

$528

per year with this tank, for 186 L of hot water a day

This tank$528
A heat pump water heater (UEF 3.44)$136

Over 10 years, the gap with a heat pump

This tankHeat pumpGap

Curious? See the AeroTherm 50 gal heat pump water heater.

How we calculate. Mains water at 7 °C heated to 60 °C (Québec.ca), 75 L per person per day (Natural Resources Canada) or 186 L for the average Québec household. This tank: the water’s energy plus its 63 W standby loss, published on the manufacturer’s spec sheet. Heat pump: energy ÷ UEF of 3.44 (Bradford White AeroTherm 50 gal). Price: 11.142 ¢/kWh, Rate D second tier in force since April 1, 2026, before tax. Indicative estimate.

02 · Why this model

What sets the Bradford White RE250T6 apart

47 US gal

Tall format

A 47 US gal (39 imp. gal, 178 L) tank in a tall, slim version.

20 in

Slim diameter

A 20 in diameter and 60 1/4 in height, handy in a plex closet.

63 W

Standby loss

Bradford White publishes a 63 W standby loss for this model.

Brass

Drain valve

The Bradford White parts book lists a brass drain valve for RE250T models.

03 · How it works

Cold water at the bottom, hot water on top

Cold watergoes down the dip tubeHot waterdrawn from the topUpper elementand its thermostatLower elementand its thermostatCold waterarrives at the bottom
  1. Cold water arrives at the bottom of the tank. Hot water, being lighter, stays on top, where it is drawn.
  2. The elements, each controlled by its thermostat, bring the water back to the set temperature.
  3. Foam insulation limits the heat lost while the water waits.
04 · Will it fit?

Check the height and the way in before our visit

It travels upright. Measure the ceiling at the spot and the narrowest door on the way.

in
in

Unit: 60.25 in tall (1530 mm), 20 in across (508 mm), about 130 lb shipping weight. The clearances the manufacturer requires are checked on site.

05 · Your current tank

How old is yours?

The year it was made is on the tank’s rating plate. Enter it.

Signs it is wearing out

  • Hot water runs out sooner than it used to.
  • The water comes out slightly reddish.
  • Rust shows at the bottom of the tank.
  • Moisture or drips around the unit.

Manufacturers announce a 10 to 15 year life. Many insurers require replacement after 10 or 12 years and may refuse a water damage claim past that age (CAA-Québec). Check your policy.

06 · Installation

What the spot needs, and who does what

240 V circuitA dedicated circuit, sized by our electrician.
3/4 in NPT waterCold inlet, hot outlet and an accessible shut-off valve.
T&P valveTemperature and pressure relief valve, with its discharge line.
Pan and detectorDrip pan under the tank and a leak detector: strongly recommended (CAA-Québec).
60 °C, 49 °CTank set to 60 °C against bacteria; 49 °C max at the shower and tub (Construction Code, art. 2.2.10.7).

AirGreenFree visit and quote, electrical connection (RBQ licence 5645-9605-01, subclass 16), start-up.

PlumberWater connections and relief valve by a master pipe-mechanic (CMMTQ).

YouA photo of the rating plate, the spot and the stairs saves us a trip.

07 · Maintenance

A few habits that make it last

  1. Start-up daySetting the temperature, with you.
  2. Every yearPartial drain to flush sediment, and a test of the relief valve.
  3. Depending on your waterAnode inspection: it wears so the tank steel does not. In hard water it goes faster.
08 · Spec sheet

Every figure, with its source

Capacity and performance
Model
RE250T6-1NCPP
Capacity
47 US gal · 178 L
Standby loss
63 W
Electrical
Supply
240 V, single phase
Element type
Screw-in
Dimensions and connections
Height
60.25 in · 1,530 mm
Diameter
20 in · 508 mm
Shipping weight (approx.)
130 lb · 59 kg
Water connections
3/4 in NPT
Build and warranty
Inner lining
Vitraglas with Microban
Drain valve
Brass
Limited warranty, tank
6 years
Limited warranty, parts
6 years

Manufacturer data. Detailed sources at the bottom of the page.

09 · Same family

The size below and above

47 US gal60.25 in tallYou are here
61 US gal60.25 in tallSee the larger one
10 · Questions

What people ask us most

Is there a LogisVert grant for this water heater?

No. Hydro-Québec’s LogisVert guide (version 1.10, September 15, 2026) lists no water heater among its eligible measures. At quote time we check other programs that could apply to your address.

Electric or heat pump: which should I choose?

An electric tank costs less up front, takes less room and needs no condensate drain or air volume around it. A heat pump water heater costs more but uses far less: the “Cost per year” section shows the gap for your household.

What temperature should the tank be set to?

To 60 °C, as the Québec government recommends, to limit bacterial growth. At shower and tub valves, the Construction Code caps the water at 49 °C: that is the job of the valve or a thermostatic mixing valve.

Can my insurer require me to replace it?

Often, yes. According to CAA-Québec, many insurers require replacement after 10 or 12 years and may refuse a water damage claim past that age. The manufacture date is on the rating plate.

Who does the installation?

AirGreen does the visit, the electrical connection under its RBQ licence (subclass 16) and the start-up. The water connections are done by a master pipe-mechanic (CMMTQ).

11 · AirGreen

We check the spot before we sell you anything

Free on-site estimate, written quote. Send a photo of your current tank and its plate, and we prepare the visit.

Book my free estimate
Sources checked November 2, 2026.
  1. Bradford White Canada, Upright Electric Residential spec sheet C1201-0926 CANADA · docs.bradfordwhite.com
  2. Bradford White Limited Residential Water Heater Warranty 238-39699-00ZAN · docs.bradfordwhite.com
  3. Bradford White Canada Residential Electric Replacement Parts Book 238-54105-00 · docs.bradfordwhite.com
  4. Hydro-Québec, rate grid, Rate D in force April 1, 2026 (7.065 ¢ and 11.142 ¢/kWh).
  5. Québec.ca, “Eau chaude”, updated November 5, 2025 (186 L/day, 7 °C water, 60 °C, volumes per use).
  6. Natural Resources Canada, water heater buying guide (75 L/person/day, first-hour rating).
  7. Québec Construction Code, Chapter III Plumbing, art. 2.2.10.7 (RBQ).
  8. CAA-Québec, “Chauffe-eau: quelle capacité choisir”, updated June 29, 2026.
  9. Hydro-Québec, LogisVert residential participation guide, version 1.10, September 15, 2026.

Costs shown are indicative estimates before tax.

A reliable 47 US gallon tank for rental units and plexes in Greater Montreal

In a duplex, a triplex or a small apartment building, each unit often has its own water heater. For the owner, a tank that gives out on a Saturday night means a tenant without hot water, possible water damage and an emergency call. The Bradford White RE250T6-1NCPP electric water heater is a solid choice for these replacements: a reserve of 47 US gallons (39 imperial gallons, 178 L), a tank protected by the Vitraglas with Microban lining and a 6-year limited warranty on the tank and on parts. AirGreen installs it in Montreal, Laval, Longueuil, on the South Shore and on the North Shore.

The water heater of a plex apartment

A five- or six-room apartment occupied by a family calls for a family-size reserve. With its 178 L, the RE250T6-1NCPP covers the everyday needs of a household of three or four, without the bulk of a large tank that would crowd the unit's closet or laundry room. Empty, it weighs 130 lb (59 kg), a weight that is easy to manoeuvre on the indoor staircases and narrow hallways typical of Montreal plexes.

Planning replacements in a building

When several units were equipped at the same time, their water heaters age together. Rather than waiting for failures one by one, many owners prefer to plan the replacements: one unit at a change of tenant, another during a renovation, starting with the oldest tanks. We can tour the building, note the age and condition of each unit, and propose a realistic schedule in a single written quote.

Manufacturer data

  • Capacity: 47 US gallons, 39 imperial gallons, 178 L.
  • Standby loss: 63 W.
  • Connections: 3/4 in. (19 mm) NPT for water and electrical; factory-installed dielectric fittings.
  • Lining: Vitraglas with Microban.
  • Elements: immersion, screw-in type.
  • Operation: non-simultaneous by default; simultaneous available, to be specified when ordering.
  • Voltages: 120 V, 208 V, 240 V, 277 V, 480 V; 120 V and 277 V single-phase only.
  • Weight: 130 lb (59 kg).
  • Listings: UL; approved for manufactured homes under CAN/CSA Z240 MH series.

A 63 W standby loss

Standby loss indicates the heat the tank loses on average when it is not being used. For the RE250T6-1NCPP, Bradford White publishes 63 W. In an apartment where hot water is used mostly in the morning and evening, this value determines how often the elements must restart during the day. When the tank is installed in an unheated closet or near an outside wall, we insulate the accessible hot water piping to limit losses.

A unit that is simple to maintain

For an owner, simplicity matters. The immersion elements of the RE250T6-1NCPP screw into the tank: a burnt-out element is replaced in a short visit, without changing the tank. The factory-installed dielectric fittings limit corrosion between the steel of the tank and the copper of the plumbing, a frequent cause of leaks at the fittings in older buildings. The Vitraglas with Microban lining protects the inside of the tank.

Protecting the unit below

In a plex, the water heater of an upper unit sits directly above another apartment. A leak, even a slow one, can then damage a ceiling and disturb two households at once. During the replacement, we install the tank on a drain pan when space allows, route the relief valve line to a safe discharge point and check the condition of the shut-off valves. These precautions are easy to include at installation time and avoid many claims later on.

Electrical supply in plexes

In a plex, each water heater is usually connected to the panel of the unit it serves, through a two-pole 240 V circuit. Some older panels have limited capacity; the default non-simultaneous configuration, where only one element heats at a time, helps keep demand reasonable. The exact element wattage of the unit ordered is confirmed with the order and written in the quote, and we check the breaker and conductors of each unit before installation.

Manufacturer's warranty

The RE250T6-1NCPP is covered by a 6-year limited warranty on the tank and 6 years on parts. For each unit, we give you the invoice and the serial number of the installed tank, which simplifies warranty follow-up in a building.

AirGreen replaces the water heaters in your units

AirGreen is a family-owned heating and cooling company established in Montreal, active for more than fifteen years and holding RBQ licence 5645-9605-01 (ventilation, refrigeration and electrical). After a free on-site estimate, you receive a written quote, per unit or for the building. For each unit, installation includes:

  • checking the location, the drain or drain pan and the access;
  • draining, disconnecting and removing the old tank;
  • connecting the cold and hot water in 3/4 in. NPT;
  • installing a new relief valve and its discharge line;
  • the electrical connection according to the confirmed wattage;
  • filling, purging air at the taps, powering up and setting the temperature;
  • maintenance recommendations: annual partial flush, relief valve test, anode inspection.

Coordinating with your tenants

A water heater replacement leaves the unit without hot water for only a few hours. We agree on a time slot with you, you can notify your tenants in advance, and we leave the premises clean. If several units are involved, we do them one after the other to limit trips and disruption.

Service area

We work in Montreal, including Rosemont, Villeray, Hochelaga, Saint-Henri and Verdun, as well as in Laval, Longueuil and everywhere on the South Shore and the North Shore. For a project involving several units, our financing lets you spread out the investment.

Request your free estimate for the Bradford White RE250T6-1NCPP. Tell us the number of units and send a photo of each tank's nameplate: we will prepare a clear quote for the building.