Fantech ERV HERO 140E Air Exchanger | Montreal, Laval, Longueuil, South Shore and North Shore

In stock
SKU: HERO 140E
142 cfm net1,700 to 2,700 sq ft60% at −25 °C
Talk to an HVAC technician · 514 316-2973
Meets the Québec CodeCore warranty: 5 years
01 · Your home

Is it the right size for your home?

It delivers 142 cfm net, enough to ventilate 1,700 to 2,700 sq ft. Choose your home's living area.

It's the right size.

For a 1,500 to 2,500 sq ft home, about 105 cfm of air needs to be renewed continuously. This unit delivers 142 cfm net — enough for the house, with extra capacity to boost ventilation for the bathroom and kitchen.

Calculation: 0.35 air changes per hour over the living volume, with 9 ft ceilings. Our estimator sets the exact airflow room by room, following CSA F326.

02 · Performance

What it does, in numbers

Heat recovery
60%
At −25 °CCode: 54% minimum
79%
At 0 °CCertified at 47 cfm
Net airflowThe ducts cost it 17 cfm
0.2 in · test bench159 cfm
0.4 in · with ducts142 cfm

$53.68

Electricity per year

Less than a 60 W light bulb

Bulbs left on day and night. Same calculation for every line: wattage × 8,760 h × 11.142 ¢/kWh.

55W
Running continuously
482kWh
Per year
3months
Filter cleaning

Meets the Québec Construction Code everywhere in the province. The Code requires 54% at −25 °C below 6,000 degree-days (Montréal, Laval, Longueuil and both shores) and 60% above that. This unit is rated at 60% at 66 cfm.

Airflow and efficiency at 0 °C and −25 °C: HVI directory, Section III. Cost: 55 W over 8,760 h at Hydro-Québec's Rate D second tier (11.142 ¢/kWh).

03 · Good to know

What you should know about this one

Published, verifiable facts, not brochure claims.

90–210Balancing range of 90 to 210 cfm

The HERO 140E sheet publishes a balancing range of 90 to 210 cfm. If the required balanced airflow falls outside that range, Fantech recommends revisiting the selection to pick a properly sized unit.

12 in12 in deep counterflow enthalpy core

The HERO 140E's counterflow core measures 14 3/8 × 14 3/8 in with a 12 in depth. Its polymer membrane, highly permeable to water vapour, transfers heat and moisture; Fantech rates it freeze tolerant and water washable.

60%What it still recovers at −25 °C

The only efficiency figure that matters for a Québec winter, and the one the Code uses. An efficiency quoted without its temperature means nothing; this one is measured at a test airflow of 66 cfm.

DamperIt defrosts without depressurizing the house

In cold weather, a motorized damper closes the outdoor air intake and recirculates indoor air through the core to thaw it. The house doesn't go into negative pressure during the cycle: no cold air drawn in through leaks, and none of the imbalance manufacturers warn about when there's a fireplace or a combustion appliance.

ERVIt moves moisture too, not just heat

An ERV transfers some moisture between the two airstreams. Useful in a house that gets too dry in winter or takes on a lot of humidity in summer. The trade-off: it generally recovers less heat than a comparable HRV.

2005472Its HVI certification number

Listed in Section III of the Home Ventilating Institute's certified products directory. Anyone can check it.

−17 cfmWhat the ducts cost it

Between a nearly unrestricted test bench (0.2 in) and a real duct system (0.4 in), it drops from 159 to 142 cfm.

55 WMeasured at the airflow it actually runs at

Its 79% at 0 °C is certified at 47 cfm, the continuous airflow of a typical home. At that setting it draws 55 W, or about 482 kWh a year.

5 yearsThe core warranty

The core does the work and is the most expensive part to replace. Motors: 7 years. Parts: 5 years.

6 inWhat it needs on site

6 in ducts, top connection. It weighs 59 lb, and it needs enough clearance to slide the core out once a year.

Financial aid

Rénoclimat stopped funding HRVs and ERVs on October 1, 2026

Only files opened before that date, under the program's transition rules, remain eligible. This unit's HVI Section III certification (No. 2005472) remains the public proof of its performance: we balance it to the calculated airflow rather than running it at full speed.

04 · Installation

What it needs on site

6 in ductsCollar diameter
Top connectionTop ports
59 lbUnit weight
27.88 × 13.38 × 24.88 inLength × depth × height
120 VPower supply

In a condo with no floor drain, or with little ceiling clearance, we usually look at a side-port model instead. Our estimator checks the location, the drain and the duct route before ordering.

Complete spec sheetData and cited sources
Net airflow at 0.2 in. w.g.
159 cfm
Net airflow at 0.4 in. w.g.
142 cfm
SRE at 0 °C (47 cfm)
79%
SRE at −25 °C (66 cfm)
60%
ASE at 0 °C
86%
Power draw
55 W
Efficacy
0.9 cfm/W
Type
ERV
Connection
Top ports
Duct collars
6 in
Defrost cycle
Recirculation (motorized damper)
Filters
2 washable electrostatic MERV 3 panel filters (7 7/8 × 9 13/16 in); optional MERV 8 (428526) or MERV 13 (428548), not washable
Dimensions (L × D × H)
27.88 × 13.38 × 24.88 in
Weight
59 lb
Power supply
120 V
HVI certification (Section III)
2005472
Warranty — core
5 years
Warranty — motors
7 years
Warranty — parts
5 years
Spec sheet (French)
PDF
Spec sheet (English)
PDF

Net airflow, efficiency at 0 °C and −25 °C, and power draw: Home Ventilating Institute certified products directory, Section III (HVID 2005472). Annual consumption calculated at 55 W running continuously for 8,760 h, at Hydro-Québec's Rate D second tier (11.142 ¢/kWh), in effect since April 1, 2026.

05 · In the Fantech range

The next model down and up

Talk to an HVAC technician before you choose

We calculate the airflow room by room, check the location and the drain, and give you an installed price. Balancing is measured at commissioning, not estimated.

A counterflow-core ERV for the family home

The Fantech HERO 140E is the mid-size energy recovery ventilator (ERV) in the HERO series. It delivers a net airflow of 142 cfm at 0.4 in., and 159 cfm at 0.2 in. Fantech intends it for single-family homes as well as multi-unit buildings, including condos and apartments.

Fantech has published a detailed spec sheet for this model. It contains two pieces of information that help you choose it well: the size of its core and its balancing range.

An enthalpy core 12 in. deep

The counterflow core of the HERO 140E measures 14 3/8 × 14 3/8 in. with a 12 in. depth. Its polymer membrane, highly permeable to water vapour, transfers both heat and moisture. Fantech describes it as frost-tolerant and water-washable.

In practical terms, in winter, the fresh air comes in preheated and less dry. In summer, part of the outdoor humidity stays outside: the sheet gives a total efficiency of 72% at 47 cfm in cooling mode. For a home in Laval or on the South Shore where the air gets very dry in January, that is the main argument for an ERV over an HRV.

A balancing range of 90 to 210 cfm

The HERO 140E sheet states that it balances between 90 and 210 cfm. If the required balanced airflow falls outside this range, Fantech recommends revisiting the selection to choose a unit of the right size. It is a simple rule we apply: the airflow calculated for your home must fall within this window, otherwise we change models.

Balancing is done with Fantech's ECO-Touch programmable touchscreen wall control.

Efficiency and power consumption

According to HVI, the sensible recovery efficiency is 79% at 47 cfm and 0 °C, and the adjusted sensible efficiency is 86%. At −25 °C, it is still 60% (measured at 66 cfm), above the 54% threshold in section 9.32 of the Québec Construction Code for Greater Montreal.

At the 47 cfm test point, the unit draws 55 W, or 0.9 cfm/W. Running continuously, that comes to about 482 kWh per year, roughly $54 at Hydro-Québec Rate D (11.142¢/kWh). Its motors are conventional. If power consumption matters a lot to you, the HERO 160E-EC uses the same cabinet with EC motors.

Defrost works by internal recirculation. It activates below −5 °C and adjusts to conditions; it does not depressurize the house during the cycle, Fantech specifies.

Installation

  • Dimensions: 27.88 × 13.38 × 24.88 in. (L × D × H)
  • Weight: 59 lb
  • Connections: 6 in., round, metal with rubber gasket, on top
  • Power supply: 120 V
  • Drain: not required

The top connections and the absence of a drain make installation simpler. The unit mounts on the wall with the supplied bracket or hangs from the ceiling with chains. Fantech calls for 14 in. of free space in front of the door to remove the core. The manual recommends galvanized ducts to the main rooms, insulated flexible duct only where needed, and 45° elbows rather than 90° ones.

Maintenance

The unit comes with two washable electrostatic MERV 3 filters measuring 7 7/8 × 9 13/16 in. They wash in warm, soapy water. As options, Fantech offers MERV 8 (428526) or MERV 13 (428548) filters, which are replaced instead of washed. A finer filter adds static pressure: we take it into account in the airflow calculation.

Warranty

Fantech warrants the core for 5 years, the motors for 7 years and the electrical components for 5 years.

The HERO 140E is certified in Section III of the HVI directory (number 2005472): its airflows and efficiencies are published and anyone can check them. Note that since October 1, 2026, installing an HRV or ERV is no longer eligible for Rénoclimat assistance, except for files opened before that date under the transition rules.

Installation by AirGreen in Greater Montreal

Choosing the HERO 140E starts with a calculation: the CSA F326 standard sets the ventilation airflow room by room. If the total falls between 90 and 210 cfm, this unit is a fit. Otherwise, we choose another one.

After installation, we balance the unit with a manometer to the calculated airflow, and we show you how to maintain the filters. Our crews install in Montreal, Laval, Longueuil, the North Shore and the South Shore.

Ask for your free quote at 514 316-2973 or sales@airgreen.ca.