Fantech ERV HERO 160E-EC Air Exchanger | Montreal, Laval, Longueuil, South Shore and North Shore
Is it the right size for your home?
It delivers 159 cfm net, enough to ventilate 1,900 to 3,000 sq ft. Choose your home's living area.
It's the right size.
For a 2,500 to 3,200 sq ft home, about 150 cfm of air needs to be renewed continuously. This unit delivers 159 cfm net — enough for the house, with extra capacity to boost ventilation for the bathroom and kitchen.
Calculation: 0.35 air changes per hour over the living volume, with 9 ft ceilings. Our estimator sets the exact airflow room by room, following CSA F326.
What it does, in numbers
$25.38
Electricity per year
Less than a 60 W light bulb
Bulbs left on day and night. Same calculation for every line: wattage × 8,760 h × 11.142 ¢/kWh.
Meets the Québec Construction Code everywhere in the province. The Code requires 54% at −25 °C below 6,000 degree-days (Montréal, Laval, Longueuil and both shores) and 60% above that. This unit is rated at 64% at 68 cfm.
Airflow and efficiency at 0 °C and −25 °C: HVI directory, Section III. Cost: 26 W over 8,760 h at Hydro-Québec's Rate D second tier (11.142 ¢/kWh).
What you should know about this one
Published, verifiable facts, not brochure claims.
ECMEC motors: 2.0 cfm/W versus 1.0
The HERO 160E-EC uses the HERO 140E cabinet with electronically commutated motors. Fantech's guide gives it 2.0 cfm/W fan efficacy at 0 °C, versus 1.0 for the HERO 140E, and 60 to 159 cfm at 0.4 in instead of 50 to 142.
14 inCore removal: 14 in free in front of the door
The HERO 160E-EC's core and filters come out through the front door, held by two latches under the unit. Fantech calls for 14 in (355 mm) in front of the door to remove the core, and 2 3/8 in above the electrical box for wiring.
64%What it still recovers at −25 °C
The only efficiency figure that matters for a Québec winter, and the one the Code uses. An efficiency quoted without its temperature means nothing; this one is measured at a test airflow of 68 cfm.
DamperIt defrosts without depressurizing the house
In cold weather, a motorized damper closes the outdoor air intake and recirculates indoor air through the core to thaw it. The house doesn't go into negative pressure during the cycle: no cold air drawn in through leaks, and none of the imbalance manufacturers warn about when there's a fireplace or a combustion appliance.
ERVIt moves moisture too, not just heat
An ERV transfers some moisture between the two airstreams. Useful in a house that gets too dry in winter or takes on a lot of humidity in summer. The trade-off: it generally recovers less heat than a comparable HRV.
2005474Its HVI certification number
Listed in Section III of the Home Ventilating Institute's certified products directory. Anyone can check it.
−17 cfmWhat the ducts cost it
Between a nearly unrestricted test bench (0.2 in) and a real duct system (0.4 in), it drops from 176 to 159 cfm.
26 WMeasured at the airflow it actually runs at
Its 81% at 0 °C is certified at 42 cfm, the continuous airflow of a typical home. At that setting it draws 26 W, or about 228 kWh a year.
5 yearsThe core warranty
The core does the work and is the most expensive part to replace. Motors: 7 years. Parts: 5 years.
6 inWhat it needs on site
6 in ducts, top connection. It weighs 59 lb, and it needs enough clearance to slide the core out once a year.
Rénoclimat stopped funding HRVs and ERVs on October 1, 2026
Only files opened before that date, under the program's transition rules, remain eligible. This unit's HVI Section III certification (No. 2005474) remains the public proof of its performance: we balance it to the calculated airflow rather than running it at full speed.
What it needs on site
In a condo with no floor drain, or with little ceiling clearance, we usually look at a side-port model instead. Our estimator checks the location, the drain and the duct route before ordering.
Complete spec sheetData and cited sources
- Net airflow at 0.2 in. w.g.
- 176 cfm
- Net airflow at 0.4 in. w.g.
- 159 cfm
- SRE at 0 °C (42 cfm)
- 81%
- SRE at −25 °C (68 cfm)
- 64%
- ASE at 0 °C
- 85%
- Power draw
- 26 W
- Efficacy
- 1.6 cfm/W
- Type
- ERV
- Connection
- Top ports
- Duct collars
- 6 in
- Defrost cycle
- Recirculation (motorized damper)
- Filters
- 2 washable electrostatic MERV 3 panel filters (7 7/8 × 9 13/16 in); optional MERV 8 (428526) or MERV 13 (428548), not washable
- Dimensions (L × D × H)
- 27.88 × 13.38 × 24.88 in
- Weight
- 59 lb
- Power supply
- 120 V
- HVI certification (Section III)
- 2005474
- Warranty — core
- 5 years
- Warranty — motors
- 7 years
- Warranty — parts
- 5 years
- Spec sheet (French)
- Spec sheet (English)
Net airflow, efficiency at 0 °C and −25 °C, and power draw: Home Ventilating Institute certified products directory, Section III (HVID 2005474). Annual consumption calculated at 26 W running continuously for 8,760 h, at Hydro-Québec's Rate D second tier (11.142 ¢/kWh), in effect since April 1, 2026.
The next model down and up
Talk to an HVAC technician before you choose
We calculate the airflow room by room, check the location and the drain, and give you an installed price. Balancing is measured at commissioning, not estimated.
The largest HERO ERV, with EC motors
The Fantech HERO 160E-EC takes the HERO 140E cabinet and puts electronically commutated motors in it. The result: an energy recovery ventilator (ERV) that delivers a net airflow of 159 cfm at 0.4 in., and 176 cfm at 0.2 in., with twice the fan efficiency of its cousin.
It is the model to look at for a two-storey house or a larger semi-detached home, when you want an air exchanger that also transfers moisture and operating cost matters.
EC motors: twice the efficiency
Fantech's selection guide gives the HERO 160E-EC a fan efficiency of 2.0 cfm/W at 0 °C, versus 1.0 for the HERO 140E. At 0.4 in., the airflow range rises from 50–142 cfm on the 140E to 60–159 cfm on the 160E-EC.
In HVI testing, it draws 26 W at 42 cfm, or 1.6 cfm/W at that point. Running continuously all year, that comes to about 228 kWh, roughly $25 of electricity at Hydro-Québec Rate D (11.142¢/kWh). An air exchanger runs day and night, twelve months a year: that is where EC motors pay off.
Recovery efficiency
According to HVI, the sensible recovery efficiency is 81% at 42 cfm and 0 °C, and the adjusted sensible efficiency is 85%. At −25 °C, it holds at 64% (measured at 68 cfm), above the 54% threshold in section 9.32 of the Québec Construction Code for Greater Montreal. In cooling mode, Fantech's guide gives it a total efficiency of 78%.
The core of an ERV transfers heat and moisture. In winter, you keep part of the house's humidity instead of sending it outside. In summer, less outdoor humidity comes in.
Defrost works by recirculation: an internal damper opens on the indoor side and house air clears the core. The unit does not draw in outdoor air during the cycle.
Core removal: 14 in. in front of the door
The core and filters come out through the front door, held by two latches at the bottom of the unit. Fantech calls for 14 in. of free space in front of the door to remove the core, and 2 3/8 in. above the electrical box for wiring. This clearance has to be planned when choosing the location, not afterward: a unit pushed up against a storage wall becomes impossible to maintain.
Installation
- Dimensions: 27.88 × 13.38 × 24.88 in. (L × D × H)
- Weight: 59 lb
- Connections: 6 in., round, on top (vertical connection)
- Power supply: 120 V
- Drain: not required
No drain to connect: Fantech reserves the drain line for HRVs. The unit mounts on the wall on the supplied bracket or hangs with chains. The 6 in. connections call for main ducts of the same diameter or larger, according to the manual. We favour galvanized ducts and 45° elbows, to keep static pressure low.
Filters
The unit comes with two washable electrostatic MERV 3 filters measuring 7 7/8 × 9 13/16 in., which wash in warm, soapy water. Options: MERV 8 (428526) or MERV 13 (428548), which are disposable: they are replaced instead of washed. The core comes out through the same door as the filters. Among the HERO ERVs with EC motors, it is the only one that accepts a MERV 13: the HERO 120E-EC does not have one.
Warranty
Fantech warrants the core for 5 years, the motors for 7 years and the electrical components for 5 years. Residential use only.
The HERO 160E-EC is certified in Section III of the HVI directory (number 2005474): its airflows and efficiencies are published and anyone can check them. On the financial assistance side, the rule changed on October 1, 2026: Rénoclimat no longer funds HRVs and ERVs, except for files already opened under the program's transition rules.
Installation by AirGreen in Greater Montreal
We determine the required airflow with the room-by-room calculation of the CSA F326 standard, from the plans or a visit. An oversized unit runs at low speed and costs more to buy; an undersized one is not enough. The HERO 160E-EC is the right fit when the calculation falls within its range.
At start-up, we balance supply and exhaust with a manometer, to the calculated airflow. We install throughout Greater Montreal: Montreal, Laval, Longueuil, the North Shore and the South Shore.
For a free quote, call 514 316-2973 or write to sales@airgreen.ca.
