Fantech HRV HERO 120H Air Exchanger | Montreal, Laval, Longueuil, South Shore and North Shore

In stock
SKU: HERO 120H
110 cfm net1,200 to 2,000 sq ft64% at −25 °C
Talk to an HVAC technician · 514 316-2973
Meets the Québec CodeLifetime core warranty
01 · Your home

Is it the right size for your home?

It delivers 110 cfm net, enough to ventilate 1,200 to 2,000 sq ft. Choose your home's living area.

It's the right size.

For a 900 to 1,500 sq ft home, about 63 cfm of air needs to be renewed continuously. This unit delivers 110 cfm net — enough for the house, with extra capacity to boost ventilation for the bathroom and kitchen.

Calculation: 0.35 air changes per hour over the living volume, with 9 ft ceilings. Our estimator sets the exact airflow room by room, following CSA F326.

02 · Performance

What it does, in numbers

Heat recovery
64%
At −25 °CCode: 54% minimum
80%
At 0 °CCertified at 68 cfm
Net airflowThe ducts cost it 15 cfm
0.2 in · test bench125 cfm
0.4 in · with ducts110 cfm

$54.66

Electricity per year

Less than a 60 W light bulb

Bulbs left on day and night. Same calculation for every line: wattage × 8,760 h × 11.142 ¢/kWh.

56W
Running continuously
491kWh
Per year
3months
Filter cleaning

Meets the Québec Construction Code everywhere in the province. The Code requires 54% at −25 °C below 6,000 degree-days (Montréal, Laval, Longueuil and both shores) and 60% above that. This unit is rated at 64% at 72 cfm.

Airflow and efficiency at 0 °C and −25 °C: HVI directory, Section III. Cost: 56 W over 8,760 h at Hydro-Québec's Rate D second tier (11.142 ¢/kWh).

03 · Good to know

What you should know about this one

Published, verifiable facts, not brochure claims.

MERV 8Optional MERV 8 filter, but no MERV 13

The HERO 120H ships with two washable MERV 3 electrostatic filters. Fantech offers optional MERV 8 filters (428525), which are disposable and not washable, but no MERV 13 for this size, unlike the HERO models with 6 in connections.

1%Touchscreen balancing in 1% steps

Fantech has the HERO 120H balanced with its programmable touchscreen wall control and a manometer. Each press changes speed by 1%; both fans are set at high speed and the low and medium speeds follow automatically.

64%What it still recovers at −25 °C

The only efficiency figure that matters for a Québec winter, and the one the Code uses. An efficiency quoted without its temperature means nothing; this one is measured at a test airflow of 72 cfm.

DamperIt defrosts without depressurizing the house

In cold weather, a motorized damper closes the outdoor air intake and recirculates indoor air through the core to thaw it. The house doesn't go into negative pressure during the cycle: no cold air drawn in through leaks, and none of the imbalance manufacturers warn about when there's a fireplace or a combustion appliance.

HRVIt recovers heat, not moisture

Excess moisture leaves the house. In Québec, that's the right choice in most cases: in winter, a home almost always has too much humidity, not too little.

2505423Its HVI certification number

Listed in Section III of the Home Ventilating Institute's certified products directory. Anyone can check it.

−15 cfmWhat the ducts cost it

Between a nearly unrestricted test bench (0.2 in) and a real duct system (0.4 in), it drops from 125 to 110 cfm.

56 WMeasured at the airflow it actually runs at

Its 80% at 0 °C is certified at 68 cfm, the continuous airflow of a typical home. At that setting it draws 56 W, or about 491 kWh a year.

LifetimeThe core warranty

The core does the work and is the most expensive part to replace. Motors: 7 years. Parts: 5 years.

5 inWhat it needs on site

5 in ducts, top connection and a condensate drain. It weighs 41 lb, and it needs enough clearance to slide the core out once a year.

Financial aid

Rénoclimat stopped funding HRVs and ERVs on October 1, 2026

Only files opened before that date, under the program's transition rules, remain eligible. This unit's HVI Section III certification (No. 2505423) remains the public proof of its performance: we balance it to the calculated airflow rather than running it at full speed.

04 · Installation

What it needs on site

5 in ductsCollar diameter
Top connectionTop ports
Condensate drainRequired
41 lbUnit weight
23.25 × 11.5 × 24.25 inLength × depth × height
120 VPower supply

In a condo with no floor drain, or with little ceiling clearance, we usually look at a side-port model instead. Our estimator checks the location, the drain and the duct route before ordering.

Complete spec sheetData and cited sources
Net airflow at 0.2 in. w.g.
125 cfm
Net airflow at 0.4 in. w.g.
110 cfm
SRE at 0 °C (68 cfm)
80%
SRE at −25 °C (72 cfm)
64%
ASE at 0 °C
85%
Power draw
56 W
Efficacy
1.2 cfm/W
Type
HRV
Connection
Top ports
Duct collars
5 in
Condensate drain
Required
Defrost cycle
Recirculation (motorized damper)
Filters
2 washable electrostatic MERV 3 panel filters; optional MERV 8 (428525), not washable (no MERV 13)
Dimensions (L × D × H)
23.25 × 11.5 × 24.25 in
Weight
41 lb
Power supply
120 V
HVI certification (Section III)
2505423
Warranty — core
Lifetime
Warranty — motors
7 years
Warranty — parts
5 years
Spec sheet (French)
PDF
Spec sheet (English)
PDF

Net airflow, efficiency at 0 °C and −25 °C, and power draw: Home Ventilating Institute certified products directory, Section III (HVID 2505423). Annual consumption calculated at 56 W running continuously for 8,760 h, at Hydro-Québec's Rate D second tier (11.142 ¢/kWh), in effect since April 1, 2026.

05 · In the Fantech range

The next model down and up

Talk to an HVAC technician before you choose

We calculate the airflow room by room, check the location and the drain, and give you an installed price. Balancing is measured at commissioning, not estimated.

A lightweight HRV for small, humid homes

At 41 lb, the Fantech HERO 120H is the lightest unit in the HERO series. This heat recovery ventilator (HRV) delivers a net airflow of 110 cfm at 0.4 in., and 125 cfm at 0.2 in. It is aimed at condos, townhouses and small homes.

An HRV recovers heat from the stale air, but not its moisture: that goes out with the exhaust air. It is the right choice when the house tends to be too humid in winter, with condensation on the windows or a basement that smells musty. If your air is more on the dry side, an ERV such as the HERO 100E will be a better fit; we discuss it with you at the visit.

Precise balancing, in 1% steps

Fantech has the HERO 120H balanced with its programmable touchscreen wall control and a manometer. Each press of the button changes the speed by 1%. Both fans are adjusted at maximum speed only; the low and medium speeds follow automatically.

For you, that means a unit set to the airflow your home calls for, not to an approximate speed. A well-balanced air exchanger does not depressurize the house, which avoids drawing cold air in through cracks or interfering with the draft of a combustion appliance.

Filters: MERV 8 as an option, no MERV 13

The HERO 120H comes with two washable electrostatic MERV 3 filters. Fantech offers MERV 8 filters (428525) as an option, which are disposable and not washable. No MERV 13 exists for this format, unlike the HERO models with 6 in. connections. If finer filtration matters in your home, the HERO 150H accepts it.

Efficiency and power consumption

According to HVI, the sensible recovery efficiency of the HERO 120H is 80% at 68 cfm and 0 °C, and the adjusted sensible efficiency is 85%. At −25 °C, it is still 64% (measured at 72 cfm), above the 54% threshold in section 9.32 of the Québec Construction Code for Greater Montreal.

At the 68 cfm test point, it draws 56 W, or 1.2 cfm/W. Running continuously, count on about 491 kWh per year, roughly $55 of electricity at Hydro-Québec Rate D (11.142¢/kWh).

Defrost works by recirculation: an internal damper opens on the indoor side and house air clears the core. During that time, the unit does not draw in outdoor air.

Installation

  • Dimensions: 23.25 × 11.5 × 24.25 in. (L × D × H)
  • Weight: 41 lb
  • Connections: 5 in., round, on top (vertical connection)
  • Power supply: 120 V
  • Drain: required

Like any HRV, the HERO 120H must be connected to a drain: condensation forms in the core when warm house air meets cold air. Fantech supplies the drain tube with the unit. The location is therefore chosen near a floor drain or a drain stack.

The unit mounts on the wall on the supplied bracket or hangs with the included chains and springs. Fantech calls for 12 in. of free space in front of the door to remove the core and 2 3/8 in. above the electrical box. The manual recommends short ducts, 45° elbows, and Y fittings rather than T fittings.

Maintenance

The core and filters come out through the front door, held by two latches at the bottom of the cabinet. The MERV 3 filters wash in warm, soapy water; the MERV 8 filters are replaced. Also check that the drain tube is not clogged at the start of winter.

Warranty

Fantech warrants the core for life, the fan motors for 7 years, and the electrical components and the damper motor for 5 years. The unit is designed for residential use only.

The HERO 120H is certified in Section III of the HVI directory (number 2505423): its airflows and efficiencies are published and anyone can check them. Since October 1, 2026, Rénoclimat no longer funds the installation of an HRV or ERV; only files already opened under the program's transition rules remain eligible.

Installation by AirGreen in Greater Montreal

A small home does not mean a small calculation. We establish the required airflow room by room, under the CSA F326 standard, then check that the HERO 120H delivers it with a reasonable margin.

At start-up, we balance the unit with a manometer using the touchscreen control, to the calculated airflow. We install in Montreal, Laval, Longueuil, the North Shore and the South Shore.

Get a free quote at 514 316-2973 or sales@airgreen.ca.