BRADFORD WHITE M3ST120R5 Hot Water Storage Tank (119 gallons) | Montreal, Laval, Longueuil, South Shore & North Shore

In stock
SKU: M3ST120R5
450 L119 US gal of storage
5 yrstank warranty
Talk to an expert · 514 316-2973
5-year tank warranty, 1-year parts2 in NPT connections
01 · Why this model

What sets the Bradford White M3ST120R5 apart

312 lb

Shipping weight

Bradford White sheet C407 lists an approximate shipping weight of 312 lb for the M-3-ST120R5.

2 in NPT front/top

Water connections

Water connections are 2 in NPT front/top plus 2 in NPT rear.

180 °F

Storage up to 82 °C

The tank is designed to store potable water up to 180 °F (82 °C) at 150 psi working pressure.

2 anodes

Tank protection

The Vitraglas with Microban lined tank is protected by two anode rods.

02 · How it works

A hot water reserve, not a water heater

Heating applianceboiler or water heaterhot waterreturnTo the fixturesStoragehot waterstays on top
  1. A boiler or a water heater heats the water.
  2. A pump circulates it to the tank, which keeps it hot.
  3. At peak times the reserve adds to production: more hot water available at once.
03 · Will it fit?

Check the height and the way in before our visit

It travels upright. Measure the ceiling at the spot and the narrowest door on the way.

in
in

Unit: 62.5 in tall (1588 mm), 28 in across (711 mm), about 312 lb shipping weight. The clearances the manufacturer requires are checked on site.

04 · Your current tank

How old is yours?

The year it was made is on the tank’s rating plate. Enter it.

Signs it is wearing out

  • Hot water runs out sooner than it used to.
  • The water comes out slightly reddish.
  • Rust shows at the bottom of the tank.
  • Moisture or drips around the unit.

Manufacturers announce a 10 to 15 year life. Many insurers require replacement after 10 or 12 years and may refuse a water damage claim past that age (CAA-Québec). Check your policy.

05 · Installation

What the spot needs, and who does what

A heat sourceA boiler or water heater sized for the demand, with its circulation pump.
2 in NPT waterCold inlet, hot outlet and an accessible shut-off valve.
T&P valveTemperature and pressure relief valve, with its discharge line.
Pan and detectorDrip pan under the tank and a leak detector: strongly recommended (CAA-Québec).

AirGreenFree visit and quote, coordination of the work.

HeatingBoiler connection by a hydronic heating contractor (RBQ 15.4).

PlumberWater connections and relief valve by a master pipe-mechanic (CMMTQ).

YouA photo of the rating plate, the spot and the stairs saves us a trip.

06 · Maintenance

A few habits that make it last

  1. Start-up daySetting the temperature, with you.
  2. Every yearPartial drain to flush sediment, and a test of the relief valve.
  3. Depending on your waterAnode inspection: it wears so the tank steel does not. In hard water it goes faster.
07 · Spec sheet

Every figure, with its source

Capacity and performance
Model
M3ST120R5
Capacity
119 US gal · 450 L
Dimensions and connections
Height
62.5 in · 1,588 mm
Diameter
28 in · 711 mm
Shipping weight (approx.)
312 lb · 142 kg
Water connections
2 in NPT (front and top) and 2 in NPT (rear)
Build and warranty
Inner lining
Vitraglas with Microban
Drain valve
Brass
Limited warranty, tank
5 years
Limited warranty, parts
1 year

Manufacturer data. Detailed sources at the bottom of the page.

08 · Same family

The size below and above

09 · Questions

What people ask us most

Is there a LogisVert grant for this water heater?

No. Hydro-Québec’s LogisVert guide (version 1.10, September 15, 2026) lists no water heater among its eligible measures. At quote time we check other programs that could apply to your address.

What is a storage tank for?

It does not heat water itself. It holds water heated by a boiler or a water heater, to meet the big peak demands of a business or a building.

Who does the installation?

AirGreen does the visit and the quote and coordinates the work. The water connections are done by a master pipe-mechanic (CMMTQ).

10 · AirGreen

We check the spot before we sell you anything

Free on-site estimate, written quote. Send a photo of your current tank and its plate, and we prepare the visit.

Book my free estimate
Sources checked November 2, 2026.
  1. Bradford White M-3 Storage Tank spec sheet C407-0526 CANADA · cdn.shopify.com
  2. Québec.ca, “Eau chaude”, updated November 5, 2025 (186 L/day, 7 °C water, 60 °C, volumes per use).
  3. Québec Construction Code, Chapter III Plumbing, art. 2.2.10.7 (RBQ).
  4. CAA-Québec, “Chauffe-eau: quelle capacité choisir”, updated June 29, 2026.
  5. Hydro-Québec, LogisVert residential participation guide, version 1.10, September 15, 2026.

Costs shown are indicative estimates before tax.

A 119 US gallon reserve for apartment buildings and commercial kitchens

In a building with several apartments, everyone showers between six and eight in the morning. In a restaurant, the dishwasher, the pot sinks and the closing clean-up all happen at the same time. In both cases, the challenge is not so much heating the water as having enough of it at the right moment. The Bradford White M3ST120R5 hot water storage tank keeps 119 US gallons (100 imperial gallons, or 450 L) of hot water in reserve for these peaks. AirGreen installs it in buildings in Montreal, Laval, Longueuil, on the South Shore and on the North Shore.

The M3ST120R5 does not heat water itself. It works with one or more electric water heaters, or with an electric boiler, which produce hot water continuously while the tank holds it.

Produce continuously, store for the peak

There are two ways to supply a lot of hot water in a short time: install very high-wattage electric heating units, or combine more modest production with a large storage volume. The second approach is often more reasonable for the electrical service of an existing building. The water heaters fill the reserve throughout the day and night; at peak time, the 119 stored US gallons add to their production.

This strategy also brings flexibility. If a water heater has to be replaced or repaired, the reserve keeps supplying the building for a while, which leaves room to work without cutting hot water to the tenants.

Manufacturer’s data

  • Capacity: 119 US gallons / 100 imperial gallons / 450 L
  • Working pressure: 150 psi (1,034 kPa)
  • Inner lining: Vitraglas with Microban
  • Insulation: 2 in (51 mm) CFC-free foam on the sides and top
  • Protection: two anode rods
  • Drain valve: brass, low-restriction, vandal-resistant design
  • Dimensions: height 62 1/2 in (1,588 mm), diameter 28 in (711 mm)
  • Weight: 312 lb (142 kg)
  • Standard: meets or exceeds ASHRAE 90.1b

The water connection size of this model is confirmed on the manufacturer’s submittal sheet before ordering, since we carry it into the piping design.

Apartment buildings: absorbing the morning peak

In a building where hot water is produced in a shared mechanical room, consumption follows the tenants’ rhythm: a strong peak in the morning, another in the evening, very little at night. A storage tank lets the water heaters rebuild the reserve during off-peak hours and deliver the peak without a drop in temperature. We calculate the volume needed from the number of units, bathrooms and washing machines in the building.

Commercial kitchens and restaurants

In food service, demand is more abrupt. A commercial dishwasher, a pot sink filled all at once and floor washing can empty a water heater in minutes. The M3ST120R5 provides a reserve that holds through these intense periods. When some appliances need hotter water than the hand sinks, we plan a thermostatic mixing valve to deliver the right temperature for each use.

Connection to electric heating units

The tank is connected to the heating unit by a circulation loop. A pump, controlled by a thermostat on the tank, circulates water between the commercial electric water heater or electric boiler and the reserve. With several water heaters, we balance the piping so they work evenly. The chosen layout and the choice of pump and controls are set out in the written quote.

Construction designed to last

The inside is lined with Vitraglas with Microban. Two anode rods protect the steel over the full height of the tank, an asset in a tank where large volumes of water are renewed every day. 2 in of CFC-free foam covers the sides and top to keep the stored heat. The low-restriction brass drain valve makes it easier to flush out sediment, and its vandal-resistant design suits mechanical rooms accessed by several trades.

Working pressure, ASME and safety

The working pressure of the M3ST120R5 is 150 psi (1,034 kPa). We check the building’s supply pressure and, if needed, install a pressure-reducing valve. A relief valve suited to the tank volume and a thermal expansion tank are part of a code-compliant installation. Bradford White offers ASME construction as an option in this series for buildings where it is required; we confirm this point with you and, where applicable, with the insurer or the building manager.

Handling and location

The tank weighs 312 lb empty and much more once filled. At 28 in in diameter and 62 1/2 in high, the route to the mechanical room must be planned: door widths, stairs, freight elevator if any. It must sit on a level concrete floor, near a drain, with service space in front of the drain valve and fittings.

Manufacturer’s warranty

The M3ST120R5 is covered by a 5-year limited tank warranty and a 1-year limited parts warranty.

Installation of the Bradford White M3ST120R5 tank by AirGreen

AirGreen is a family business established in Montreal and active in heating, ventilation and air conditioning for more than fifteen years, holding RBQ licence 5645-9605-01 in ventilation, refrigeration and electrical work. For a commercial storage tank, our service includes:

  • analysis of the building’s hot water demand and of the existing heating units;
  • assessment of the mechanical room, floor, drain and delivery route;
  • removal of the old tank or the equipment being replaced;
  • water connections, the circulation loop, isolation valves and balancing;
  • the relief valve, discharge pipe, expansion tank and, if needed, the thermostatic mixing valve;
  • the electrical connection of the circulating pump and its control;
  • commissioning, temperature settings and a yearly maintenance plan.

We work for building owners, property managers and restaurant owners in Montreal, Laval, Longueuil, Brossard, Saint-Laurent, Anjou, Terrebonne, Saint-Jérôme and everywhere on the South Shore and the North Shore. The on-site estimate is free, the quote is written and financing is available.

Request your free quote for the Bradford White M3ST120R5 tank. Describe your building and your current units: we will propose a clear configuration, production and storage included.