KINGHOME Multi-Zone R32 One-Way Ceiling Cassette | 18,000 BTU

In stock
SKU: KM18XK1DI
18,000BTU/h · nominal capacity
Optional Wi-FiR-3212-yr compressor, 12-yr parts
Talk to a technician · 514 316-2973
Outdoor unitSUR MULTIZONE SEULEMENT
Cassette (indoor)KM18XK1DI
AHRISUR MULTIZONE SEULEMENT

For rooms laid out end to end, long open areas and narrow storefronts

The Montréal plex has a shape all its own: a living room at the front, a dining room in the middle, a kitchen at the back, all lined up over a depth that's often much greater than the width of the unit. The same layout shows up in street-front shops, meeting rooms and classrooms. For these long, open spaces, the KINGHOME one-way ceiling cassette, in its 18,000 BTU size, throws air along the length of the room, from one end to the other, with nothing installed on the walls.

It's the format we recommend when a wall-mounted head wouldn't reach the back of the room, and when a square cassette in the centre would waste part of its airflow against side walls that are too close together. We install it in Montréal in renovated apartments, ground-floor commercial spaces in plexes and open-plan offices.

An indoor head connected to an Ultra Heat outdoor unit

This cassette doesn't work on its own. It has no dedicated outdoor unit, no AHRI number and no efficiency rating of its own: it's a head for a KINGHOME Ultra Heat R-32 multi-zone heat pump, supplied with 220 V power and refrigerant by the outdoor unit. The certified performance and the operating range belong to the complete system.

The 18,000 BTU size is more demanding than the small heads. According to the manufacturer's compatibility table, it connects to the following outdoor units:

  • KM30X6O and KM36X6O, up to 4 zones;
  • KM42X6O and KM48X6O, up to 5 zones;
  • KM60X6O, up to 6 zones.

The KM18X6O and KM24X6O units don't accept this head size. The 30,000 to 48,000 BTU units carry the ENERGY STAR cold climate designation and heat down to -30 °C; the 60,000 BTU unit doesn't carry this designation. In a plex or a house, a typical setup pairs this cassette with the main open area and two or three smaller heads in the bedrooms, on a KM36X6O or KM42X6O unit.

The linear format, designed for length

The housing is the same for the entire one-way series: 38.86 in. long, 15.16 in. wide and only 7.01 in. deep. At 18,000 BTU, this slim housing really comes into its own: it offers the capacity of a large head in a ceiling where a thicker square cassette wouldn't fit, for example under an original hardwood floor that you don't want to lower any further.

We usually place it near the front wall or above the room's entrance, so the airflow travels the full depth of the space. The cross-flow blade and the internal air duct carry the air a long way, which brings a large volume up to temperature faster. The panel, with its closed air intake and wave texture, blends into a renovated ceiling, and the manufacturer offers several panel options.

Spec sheet figures

  • Nominal capacity: 18,000 BTU
  • Maximum airflow: 413 CFM
  • Indoor sound level: 35 dB(A) at low speed, 43 dB(A) at maximum speed
  • Dehumidification: 3.8 pt/h, or about 1.8 L/h
  • Housing dimensions: 38.86 x 7.01 x 15.16 in.

The 413 CFM airflow makes the difference in a deep room: it's this volume of air that lets the far end of the dining room, or the back of a shop, stay at the same temperature as the front. The 3.8 pt/h dehumidification suits busy rooms, like a meeting room or a shop where the door opens often in summer.

Choosing the right capacity

The 18,000 BTU isn't the answer for every large room. In a well-insulated open area with few windows, a 12,000 BTU may be enough and leave more capacity for the outdoor unit's other zones. On the other hand, a shop with a large storefront window or a very busy commercial space may need the 20,000 BTU from the same series. The housing is identical from one size to the next: the choice is based on the on-site assessment of heating needs and on the outdoor unit's remaining capacity, not on the space in the ceiling.

Controls

Infrared remote included; Wi-Fi available as an option through a Wi-Fi wired controller compatible with the KINGHOME app; wall-mounted or recessed wired controller available. In a commercial space or an office, we recommend the wired controller to keep the setpoint under control. The I-feel function, self-cleaning, forced defrost, soft start, low-voltage start-up and the frost-protection maintenance heating mode are included.

What we check before the installation

A large head in an old ceiling calls for serious preparation. Here's what we confirm during our visits in Montréal, Laval, Longueuil, on the North Shore and on the South Shore.

Ceiling structure

We check the clear space above the ceiling, the direction of the joists and any existing pipes or ducts. The cassette is hung from the structure with threaded rods, with the clearances specified by the manufacturer and a service access planned in drywall ceilings.

Electrical supply

The head is powered through the outdoor unit. The KM30X6O requires an MCA of 23 A and an MOP of 35 A; the KM36X6O and KM42X6O, an MCA of 30 A and an MOP of 45 A. In an older plex, each unit's electrical service is sometimes limited: we review the panel before confirming the outdoor unit.

The outdoor unit

We mount it on a wall bracket or on a flat roof depending on the building, always above the snow and away from the neighbours' windows. In Montréal laneways, the location is also chosen based on access for maintenance.

Piping and drain

The ports on the 30,000 to 48,000 BTU units are 1/4 and 3/8 in., and those on the KM60X6O are 1/4 and 1/2 in. The gas line of an 18,000 BTU head doesn't always match the outdoor unit's port: in that case we install the appropriate reducer, brazed or flared to code. The built-in condensate pump lifts the water to a drain point that we confirm ahead of time and test at start-up. The vacuum is pulled completely.

LogisVert assistance

This head doesn't appear by itself on Hydro-Québec's LogisVert assistance list; eligibility is confirmed on the installation date. The assistance is tied to the complete multi-zone system and the certified combination: its indicative amount is calculated using the LogisVert rule ($120 per 1,000 BTU/h of certified heating capacity at -8.3 °C, or $50 with the KM60X6O, which has no cold climate designation). The program is aimed at homes: for a commercial space, we check eligibility separately and state it clearly in the quote. Only Hydro-Québec confirms the assistance granted.

Why go with AirGreen

  • Salaried refrigeration technicians, used to plex ceilings and commercial spaces.
  • Civil liability insurance of $5,000,000.
  • Warranty registration handled by us.
  • After-sales service that knows your system.

Ask for your free estimate: we measure the depth of the room, check the ceiling and the electrical panel, and give you a precise quote for the complete multi-zone system.

Documentation

Warranty: 12 years on the compressor, 12 years on parts and 6 years on labour, directly from the distributor, on registered models; additional warranty available.