ARCOAIRE R4A4S Economy Central Air Conditioner | 2 Tons - 24000 BTU - R410A

In stock

The 2-ton R4A4S R-410A condensing unit: an economy replacement for an existing central air system, available while supplies last.

Model numberR4A4S24AKANA

2 tons24,000 BTU/h nominal size
13.4 to 16.0SEER2 depending on the matched indoor unit
74 dBAsound power
R-410AAvailable while supplies lastCooling onlyScroll compressor
Ask for a quote

514 316-2973 · sales@airgreen.ca

Quick facts

Model numberR4A4S24AKANA
ManufacturerICP
SeriesR4A4S
Size2 tons (24,000 BTU/h)
SEER2 range13.4 to 16.0, depending on match
Power supply208/230 V, 1 ph, 60 Hz

When the old 2-ton air conditioner gives out: an economy R-410A replacement

A direct replacement for a house that is already equipped

The scenario is common: the house has had central air for years, the electric furnace and the ducts are in good condition, but the condensing unit outside will not start again. There is not always a reason to redo everything. The R4A4S24AKANA, the 2-ton (24,000 BTU/h) outdoor unit of ICP's economy R4A4S series, replaces that part, on R-410A, with a single-stage scroll compressor. It is available while supplies last.

The key question is the indoor coil. It can be reused only if it is R-410A compatible and matched according to the manufacturer; this condensing unit's capacity tables use the ESD4X24M14A1E section. If the coil in place is not suitable, we include its replacement in the same quote, rather than pair two mismatched units.

The same logic applies to the refrigerant piping: this size has a 3/4 in vapor valve and a 3/8 in liquid valve, and we check the diameter and condition of the existing lines before reusing them. And if a reasonable repair is enough to get the old unit running again, we tell you that too.

The data published for this size

The spec sheet, published under the Maratherm brand, another ICP banner, gives a range of 13.4 to 16.0 SEER2 depending on the matched indoor section. There is no certified rating for the condensing unit alone. The published sound power is 74 dBA.

The compressor has an internal pressure relief valve and internal thermal overload, and the unit has a filter drier and a dense wire coil guard. For the electrical side, plan a 208/230 V single-phase circuit with a 15.1 A minimum ampacity and a 25 A maximum time-delay fuse or breaker.

This condensing unit does not heat and, sold alone, it is not eligible for the LogisVert grant. If the furnace is also nearing the end, a central heat pump may be worth comparing.

On installation day

AirGreen is a family business established in Montreal for more than fifteen years, holding RBQ licence 5645-9605-01 in ventilation, refrigeration and electrical work. After a free on-site estimate and a written quote, our technicians:

  1. recover the refrigerant from the old condensing unit and remove it;
  2. set the R4A4S24AKANA level on its pad;
  3. check or replace the indoor coil and the piping;
  4. evacuate, adjust the charge to the actual length and connect the power;
  5. commission the system and check its operation.

We work in Montreal, Laval, Longueuil, on the North Shore and on the South Shore.

Get your cool back

Ask for your free estimate: we assess the installation in place, confirm availability and give you a written quote. Financing is available.

01 · What it is for

Replacing a 2-ton condensing unit without redoing everything

The R4A4S24AKANA replaces the outdoor unit of a split central air conditioner. It works with a matched indoor section, a coil on an electric furnace or a fan coil; its capacity tables are built with the ESD4X24M14A1E section.

  • Replacing a 2-ton condensing unit at the end of its life
  • Single-storey and semi-detached houses already cooled through ducts
  • Projects where budget comes before maximum efficiency
  • Adding central air to an existing electric furnace
Compressor protectionsInternal pressure relief valve and internal thermal overload on the scroll compressor, plus a filter drier.
13.4 to 16.0 SEER2The range the spec sheet publishes for the 2-ton size, depending on the matched indoor section.
Up to 250 ft of pipingMaximum equivalent length allowed by the manufacturer, with no more than 200 ft actual.
Compatible with
ESD4X24M14A1E
Per the manufacturer. Send us the model number of your equipment and we confirm compatibility before ordering.
02 · Specifications

Specifications

From the manufacturer’s documentation. A value the manufacturer does not publish is not listed.

ManufacturerICP
SeriesR4A4S
Manufacturer documentationR4A4S spec sheet published under the Maratherm brand
TypeSplit central air conditioner outdoor unit, cooling only
Nominal size2 tons (24,000 BTU/h)
RefrigerantR-410A
CompressorScroll, single stage; internal pressure relief and thermal overload
Efficiency (manufacturer range)13.4 to 16.0 SEER2 depending on the matched indoor unit
Sound power74 dBA (tested to AHRI 270, not listed with AHRI)
Power supply208/230 V, single phase, 60 Hz (197 to 253 V operating)
Minimum circuit ampacity15.1 A
Max. time-delay fuse or breaker25 A
Compressor (RLA / LRA)11.70 A / 59.5 A
Liquid valve3/8 in
Vapor valve3/4 in
Rated piping3/4 in vapor, 3/8 in liquid, rated with 25 ft (7.6 m)
Factory charge4.00 lb (1.81 kg) of R-410A
Piping lengthUp to 250 ft (76.20 m) equivalent; 200 ft (61 m) actual maximum
Elevation difference200 ft (60.96 m) with the outdoor unit higher; 80 ft (24.4 m) with the indoor section higher
Low-ambient coolingDown to 0°F (-18°C) with the approved kits; pressure switch required below 55°F (12.8°C)
ConstructionSolid sheet metal, dense wire coil guard, filter drier
Indoor section in capacity tablesESD4X24M14A1E
StandardsUL
Model numberR4A4S24AKANA
03 · Before installing

What to know before installing

  • Available while supplies last.
  • Cooling only. Sold alone: not eligible for the LogisVert grant.
  • The existing indoor coil can be reused only if it is R-410A compatible and matched according to the manufacturer.
  • 208/230 V single-phase, 60 Hz circuit: 15.1 A minimum ampacity, 25 A maximum time-delay fuse or breaker.
  • The factory charge is topped up on site according to the actual piping length.
  • Spec sheet published under the Maratherm brand; dimensions and weight given only on a drawing.
04 · Documents

Manufacturer documents

05 · See also

Explore the range

Same category
Central air conditioners
See all
Same brand
ARCOAIRE
See all
06 · Questions

Frequently asked questions

Can I keep my current indoor coil?

Only if it is R-410A compatible and matched according to the manufacturer. This condensing unit's capacity tables use the ESD4X24M14A1E section. We check the coil in place before proposing to keep it.

What electrical circuit is needed?

A 208/230 V single-phase circuit with a 15.1 A minimum ampacity and a 25 A maximum time-delay fuse or breaker, according to the spec sheet.

Is it loud?

The spec sheet publishes a sound power of 74 dBA for this size, measured under the AHRI 270 test standard. The unit's location also matters: we choose it with you.

Why the Maratherm name on the spec sheet?

The R4A4S is made by ICP and its spec sheet is published under the Maratherm brand. The ICP limited warranty certificate covers the R4A4S series.

What is the manufacturer's warranty?

According to the ICP limited warranty certificate: parts for 10 years for the original owner with registration within 90 days of installation, otherwise 5 years; the certificate states that this registration condition does not apply in Quebec. Subsequent owners: 5 years. Labour is not covered by the manufacturer.

AirGreen · Montréal, Laval, Longueuil, South Shore, North Shore

A 2-ton central air conditioner, installed by AirGreen

Tell us about your project: we check the sizing, confirm availability and send you a quote. Or let our technicians install it for you.

RBQ 5645-9605-01Ventilation, refrigeration and electrical
Free estimateon site, for any installation
Quote in 24 hby phone or email
Bouchervilleshowroom

Specifications from the manufacturer’s documentation, checked on October 19, 2026.