Hitachi CIW04H Wired Remote for airCore
Hitachi’s genuine wired wall controller for airCore systems.
AirGreen codeAG-AC-024
514 316-2973 · sales@airgreen.ca
Quick facts
The Hitachi CIW04H wired remote is an original wall control for airCore systems, Hitachi’s line of heat pumps for businesses and homes. Mounted on the wall, it connects to the indoor unit with a control cable.
A control that stays put
In an office, a store or a shared room, a wireless remote often ends up in a drawer. The wall control stays in the same place and gives everyone the same access to the indoor unit’s settings. It is also suitable for replacing an existing wall control.
Check before ordering
The airCore 700 technical catalogue we reviewed lists the CIW03-H as the wired remote. Before ordering the CIW04H, we check its compatibility with the model numbers of your indoor and outdoor units. Send us both numbers, shown on the nameplates.
Wiring
- Control cable between the indoor unit and the remote, according to the unit’s manual.
- For the CIW03-H, Hitachi requires a shielded twisted pair of at least 18 AWG.
- Connection with the unit powered off, by a technician.
Installed by AirGreen across Greater Montréal
We install the control, pull the cable and commission the system in Montréal, Laval, Longueuil, the South Shore and the North Shore. RBQ licence 5645-9605-01. For availability or a quote, call us at 514 316-2973 or email sales@airgreen.ca with your unit models.
A controller that stays on the wall
A wired controller stays put and runs the indoor unit through a cable.
- Wall control of an airCore indoor unit
- Commercial spaces, offices and stores where handheld remotes go missing
- Replacing an existing wall controller
- New airCore installations
Specifications
From the manufacturer’s documentation. A value the manufacturer does not publish is not listed.
What to know before installing
- Note the indoor and outdoor unit model numbers.
- Published airCore 700 catalogs list the CIW03-H controller: we confirm CIW04H compatibility with your equipment before ordering.
- Plan the control cable route between the indoor unit and the wall.
- Wiring is done with the unit powered off, by a technician.
Manufacturer documents
You may also need
Hitachi AIRCOREAHUKIT1 Control Box for airCore 700 Air Handler
Hitachi 5-Wire Adapter for 24 V Thermostat – C3STAT01
Hitachi 5-Wire Thermostat, Wi-Fi and BACnet/Modbus Adapter – C4STAT01
14/4 Communication Cable for Heat Pumps
Fujitsu Leak Detection System Accessory – UTYSGZU
GENERAL AIRSTAGE Leak Detection System Accessory – UTYSGZU
Hitachi C1STAT01 5-Wire Thermostat Adapter (airHome)
Hitachi Port Adapter for airHome RAM-G Multi-ZoneOriginal partsSee all
Frequently asked questions
Will it work with my unit?
Send us your indoor and outdoor model numbers. The airCore 700 catalog we reviewed lists the CIW03-H controller; we check CIW04H compatibility before any order.
What cable is needed?
A control cable between the indoor unit and the controller, per the unit manual. For the CIW03-H, Hitachi calls for shielded twisted pair, 18 AWG minimum.
Can I keep the wireless remote?
Depending on the unit setup, both controls can coexist. We confirm this at installation.
Can you install it?
Yes. We mount the controller, run the cable and commission the system, everywhere in Greater Montréal.
A genuine wall controller for your airCore
Tell us the size and the quantity: we confirm availability and send you a quote. Or let our technicians install it for you.
Specifications from the manufacturer’s documentation, checked on October 7, 2026.