THERMO 2000 VoltMax SCR VOLTSCR600180P3 Commercial Electric Boiler | 180 kW - 600V 3 Phase
The 600 V three-phase VoltMax SCR 180 delivers 614,160 BTU/h and sets the water from 50 °F to 200 °F: a commercial electric boiler for large buildings with radiators or radiant floors.
Model numberVOLTSCR600180P3
514 316-2973 · sales@airgreen.ca
Quick facts
614,160 BTU/h on 600 V to heat a large building with hot water
A commercial boiler that adapts to the emitters
The VoltMax SCR 180 is Thermo 2000’s 180 kW commercial electric boiler, here in its 600 V three-phase version. It delivers 614,160 BTU/h according to the manufacturer and modulates its output from 0 to 100% through solid-state relays (SCR), alongside relay stages. Its setpoint adjusts from 50 °F to 200 °F (10 °C to 93 °C): high enough for a radiator system, low enough for a radiant floor.
It is meant for owners and managers of large residential, commercial or mixed-use buildings, engineers preparing a replacement and contractors modernizing a mechanical room. Hydro-air coils and an indirect water heater, served by a second setpoint, are also among its possible uses.
In Quebec’s large buildings
Take a mixed-use building in Montreal, with shops on the ground floor and offices upstairs, heated by an old radiator system. On 600 V three-phase, the VoltMax SCR 180 draws 173.2 A there. The supplied outdoor sensor lets the controller lower the water temperature in mild weather and raise it when it is cold, and schedules turn heating down when the premises are closed.
In a newer building in Laval with a radiant floor, the same boiler runs at low temperature, still guided by the outdoor sensor. In both cases it stays compact: vertical, with 3 in of clearance on the sides and back, 24 in in front and 32 in above. It holds 30 US gal of water and weighs 550 lb (250 kg). The Schneider Electric controller displays in French or English, communicates over BACnet IP and MS-TP and sends its alarms by email.
Our work, from estimate to commissioning
The on-site estimate is free. We check the 600 V service, the condition of the system and the emitters, and the access to the mechanical room. The written quote that follows specifies the boiler, the circulating pump and the expansion tank, which Thermo 2000 does not count among the supplied items.
Our crews set the boiler in place, connect the system and the electrical circuit, fill and purge the loop, then set the setpoint, the outdoor reset curve and the schedules. The manufacturer, for its part, warrants the tank for 10 years, as a limited warranty for closed-loop heating, and the electrical and mechanical components for 2 years. A family business from Montreal established for more than fifteen years, AirGreen works under RBQ licence 5645-9605-01 (ventilation, refrigeration and electrical).
Your building, our quote
In Montreal, Laval, Longueuil, on the North Shore or the South Shore, have your building assessed for free. You will receive a written quote, and financing is available.
Heating a large building, from radiators to radiant floors
An older building with radiators and a newer building with radiant floors do not need the same water temperature. The VoltMax SCR 180 accepts a setpoint from 50 °F to 200 °F (10 °C to 93 °C), and its outdoor sensor adjusts the water to the weather.
- Large residential, commercial or mixed-use buildings on 600 V power
- Radiator systems in older buildings being modernized
- Radiant floors and hydro-air coils in newer buildings
- Domestic hot water through an indirect water heater, on the second setpoint
Specifications
From the manufacturer’s documentation. A value the manufacturer does not publish is not listed.
What to know before installing
- 600 V three-phase, 60 Hz power supply: 173.2 A. Overcurrent protection and conductors are sized by the engineer or the master electrician.
- In an older radiator system, the condition of the piping and emitters is checked before connecting a new boiler.
- The circulating pump and expansion tank are not among the items supplied by Thermo 2000: they are sized for the system.
- Clearances: 3 in on the sides and back, 24 in in front, 32 in above, none underneath. Weight: 550 lb (250 kg).
- Schneider Electric controller with backlit display
- Outdoor temperature sensor
- On/off control switch
- Control and power fuses and breakers
- SCR relays
- Two limit controls, automatic and manual reset
- Factory-installed relief valve
- Drain valve
- Low-water cutoff
Manufacturer documents
Explore the range
Electric boilersSee allSame brand
THERMO 2000See all
Frequently asked questions
Can it supply old radiators?
Its setpoint goes up to 200 °F (93 °C). Before connecting a new boiler to an older system, we check the condition of the piping, the radiators and the air vents.
What about a radiant floor?
Yes: the setpoint goes down to 50 °F (10 °C), and the outdoor sensor adjusts the water temperature to the weather. If the building combines radiators and a radiant floor, the system is designed accordingly with the engineer.
Is the boiler noisy?
Thermo 2000 describes it as quiet, clean and low-maintenance; its Incoloy immersion elements are replaceable.
Can it be controlled remotely?
The Schneider Electric controller links to a management system over BACnet IP or MS-TP, accepts a 0-10 Vdc signal for setpoint and output, and its Ethernet port provides a web page and email alarms.
Can you install it?
Yes. After a free estimate and a written quote, we install the boiler, connect it to the system and the 600 V circuit, then set the setpoint, the outdoor sensor and the schedules at commissioning.
A 180 kW, 600 V VoltMax SCR, installed by AirGreen
Tell us about your project: we check the sizing, confirm availability and send you a quote. Or let our technicians install it for you.
Specifications from the manufacturer’s documentation, checked on October 19, 2026.
