KINGHOME Ultra Heat R32 2-Zone Heat Pump | 48,000 BTU | Montréal, Laval, South Shore, North Shore
The Kinghome Ultra Heat 2 zones 48 000 multi-zone heat pump heats and cools 2 rooms with a single outdoor unit. ENERGY STAR cold-climate certified, it delivers 44,500 BTU/h at −8 °C, heats down to −30 °C and has an indicative LogisVert amount of $5,340 (only Hydro-Québec confirms the assistance granted). Installed by AirGreen in Montréal, Laval, Longueuil, the North Shore and the South Shore.
2 rooms, one outdoor unit.
Figures come from the manufacturer’s data and the AHRI certification.
The parts that make a multi-zone system.
Tap a part to learn more.
Outdoor unit
One compressor for the whole house. It supplies up to 5 heads.
Base pan heater
A heater keeps the outdoor unit’s base pan free of ice below 1 °C and during defrost (NEEP).
Refrigerant lines
One pair of lines per head.
Indoor heads
One head per room, each with its own remote and temperature. The combination is chosen in the “Zones” menu.
Control
Each zone is set separately, also from your phone.
Turn rooms on and off. Watch the power being shared.
One outdoor unit supplies every head: when several rooms call at once, they share its capacity. Pick an outdoor temperature.
Tell us your rooms. We tell you if this size is enough.
Pick the number of rooms and their size. The estimate targets a −15 °C day; it is a guide, the real calculation is done room by room at your home.
The whole series at a glance: find the box that fits you.
Each box is a product: the outdoor unit’s size, and the number of heads.
At −15 °C, it still delivers 78 % of its rated capacity.
Tap a temperature: capacity, efficiency and the cost of one hour of heating.
At every temperature, cheaper than baseboards.
Cost of one hour at full output, for the same heat delivered. Hydro-Québec Rate D, second tier: 11.142 ¢/kWh.
The official ratings, on the same scales as before.
SEER2, HSPF2 and EER2 come from the AHRI certification.
A grant you can calculate, not guess.
The capacity at −8 °C. $120 per 1,000 BTU/h is the rate for ENERGY STAR cold-climate heat pumps (guide v1.10).
One multi-zone or several wall units? Both sides, honestly.
We compare both options on your floor plan during the estimate.
What to know before installing a multi-zone system.
Dimensions, wiring and lines, drawn. Then our six steps.
The outdoor unit, dimensioned
One circuit for the whole house
Published sound levels, on one scale.
We use the outdoor figure to choose where the unit goes.
Every number, and where it comes from.
Each line carries its source; a line with no published value is not shown.
The manufacturer’s documentation, as PDF.
Everything we have written about this system.
Two zones with a heavy cooling load
This two-zone 48,000 BTU multi-zone heat pump is meant for a specific situation: two large spaces that suffer mostly from the heat. A full top floor under the eaves that gets unbearably hot in July, an open-plan area with a picture window or a south-facing patio door, a room with a cathedral ceiling and skylights. In these houses, it's cooling that sets the size of the equipment, and that's why we choose the KM48X6O outdoor unit rather than the lower-capacity model in the same range.
We install this configuration in houses in Laval, on the North Shore and on the South Shore where the top floor was built into the attic, and in houses in Montréal and Longueuil renovated into an open plan with large glass areas.
What the 48,000 BTU brings, and what it doesn't
We'd rather be upfront about something few sellers mention. The heating capacities listed on NEEP (AHRI No. 216772301) for this unit at -8.3 °C, -15 °C and -30 °C are identical to those of the lower-capacity model in the same series. The gain with the 48,000 BTU is in cooling, with a higher nominal capacity for large sun-exposed areas. If your house is mainly hard to heat, rather than to cool, we'll suggest the other model.
Two 24,000 BTU heads
This unit accepts the CHARMO wall-mounted heads KW09XQ19CDI (9,000 BTU), KW12XQ19CDI (12,000 BTU), KW18XQ19CDI (18,000 BTU) and KW24XQ19CDI (24,000 BTU). For two zones this size, the natural combination is two 24,000 BTU heads, which add up to the outdoor unit's 48,000 BTU. One head for the floor under the roof, one for the open-plan area on the ground floor. When one of the two zones is smaller, an 18,000 BTU head can take its place; the on-site assessment of heating and cooling needs, room by room, makes the call.
Each head has its own remote and set point. Wi-Fi is included: you can start cooling the top floor from the KINGHOME PLUS app an hour before bedtime, or by voice with Google Assistant and Amazon Alexa.
Why not a central ducted system
In a house heated with baseboards or hot water, there's no duct system at all. Installing one for a floor under the eaves means opening ceilings, giving up closets and running ducts through an attic that's already very hot in summer, where they lose part of their cool air before it even reaches the grilles. Two ductless wall-mounted heads avoid that work: only two pairs of lines and one cable go through the walls, and each head cools the room's air directly. For a homeowner who wants to fix the heat upstairs without turning the house into a construction site, it's usually the most direct solution.
Efficiency in peak heat
The system has a SEER2 of 21, which measures efficiency over the whole season, and an EER2 of 12, which measures efficiency during the hottest hours. For a floor under the eaves, it's the EER2 that counts: that's when the head runs at full output. The heads dehumidify while they cool, and a properly sized head removes more humidity than an oversized one that reaches the set point too quickly.
Winter, figures listed on NEEP
- At -8.3 °C: 44,500 BTU/h, COP of 2.4, or about 93% of nominal capacity.
- At -15 °C: 37,800 BTU/h, COP of 2.1, or about 79%.
- At -30 °C: 28,400 BTU/h, COP of 1.5, the heating operating limit.
The unit carries the ENERGY STAR cold climate designation and an HSPF2 of 10. A COP of 2.1 means it delivers a little more than twice the energy it uses, while an electric baseboard gives back one for one. The existing heating stays in place as backup for the coldest nights. Both heads share the same compressor: they both run in the same mode, heating or cooling.
What we check before installation
Electrical supply
The outdoor unit requires a 220 V supply, an MCA of 30 A and an MOP of 45 A. Both heads are powered through the interconnect cable from the outdoor unit, on a single circuit in the panel. We check the capacity of the electrical service before the quote.
Sound level and location
This is the point to watch with this model: the outdoor unit is rated at 69 dB(A), more than the lower-capacity model in the range. It measures 40.16 x 16.81 x 32.52 inches. We keep it away from bedroom windows, the deck and the property line, and we take into account municipal noise bylaws, which vary from one city and borough to the next. It's set on a wall bracket or a raised pad, above snow level, with vibration isolators, and defrost water must drain without freezing on a walkway.
Lines to the top floor
Each head has its own pair of lines, 1/4 and 3/8 inch. For the floor under the eaves, we run the lines under line covers on the outside wall or through the attic; in the latter case, they're insulated along their full length to prevent condensation in summer. Each circuit is vacuumed separately.
Drains
A 24,000 BTU head cooling a hot top floor produces a lot of condensate. The drain must keep a steady slope toward the outside; when the layout doesn't allow it, we install a condensate pump, listed in the quote.
LogisVert grant
This system has an indicative LogisVert amount of $5,340, calculated according to the LogisVert rule ($120 per 1,000 BTU/h of certified heating at -8.3 °C); eligibility is confirmed on the installation date. Only Hydro-Québec confirms the assistance granted. The references are AHRI 216772301 and ENERGY STAR ID 3995741.
Why choose AirGreen
- Salaried refrigeration technicians for the connection, the vacuum and the start-up.
- Civil liability insurance of $5,000,000.
- Warranty registration done by our team.
- After-sales service that knows your installation.
Request your free estimate: we assess the heating and cooling needs of your two zones on site and tell you honestly whether this model is the right one.
Warranty: 12 years on the compressor, 12 years on parts and 6 years on labour, directly from the distributor, on registered models.
What people ask us about multi-zone systems.
Can I heat one room and cool another at the same time?
No. On a multi-zone system like this one, every head works in the same mode, heating or cooling. Each room still keeps its own set temperature.
What happens when every room calls for heat?
They share the outdoor unit’s capacity: 44,500 BTU/h at −8 °C, 37,800 at −15 °C and 28,400 at −30 °C.
How many heads can I connect?
Up to 5 on this outdoor unit. This product is configured for 2 heads.
How much is the LogisVert grant?
$5,340. The grant never exceeds 100 % of the cost before taxes; apply within 9 months of installation.
Is it ENERGY STAR certified?
Yes, cold climate, ID 3995741.
Down to what temperature does it heat?
Down to −30 °C. At −30 °C, it still delivers 28,400 BTU/h with a COP of 1.5.
Is it noisy?
Indoors, the reference head goes down to 26 dB(A). Outdoors, 69 dB(A): we place the unit away from bedroom windows.
Why a multi-zone instead of several wall units?
One outdoor unit on the wall and one circuit. In return, the rooms share the capacity, and if the outdoor unit stops, every zone stops.
What does the warranty cover?
Our sheet lists 12 years on the compressor and 12 years on parts. AirGreen extended warranty: possible.
A multi-zone system is planned room by room. At your home.
We measure every room, draw the line route and choose the right head for each zone. The on-site estimate is free and the quote arrives within 24 h.
