CONFORTO Hiboy KHE-02-G015-H3 Electric Furnace | 15 kW - 240V
Conforto’s 15 kW Hiboy electric furnace with an ECM motor: five fan speeds, three 5 kW elements and a multiposition cabinet ready for a heat pump.
Model numberKHE-02-G015-H3
514 316-2973 · sales@airgreen.ca
Quick facts
15 kW and a five-speed ECM motor: the Hiboy that gets ready for a heat pump
An electric furnace designed to work with cooling
The Conforto KHE-02-G015-H3 produces 15 kW, or 51,216 BTU/h at 240 V, with three 5 kW elements split into two stages: 10 kW on the first, 15 kW on the second. What sets it apart is its 1/2 HP Ecotech ECM motor with five speeds. Conforto publishes airflow from 600 CFM at MED-LOW speed, at 0.5 in of water column, up to 1,275 CFM at HIGH speed, at 0.2 in. That range lets the airflow be matched to the ductwork, then to the coil of an air conditioner or heat pump.
It is aimed at owners of a house with ductwork who want central electric heat today and a central heat pump now or in a few years.
With a central heat pump, who does what
The furnace accepts an air conditioner or heat pump coil of up to 3 tons, on the supply plenum or the return. DIP switch 3 tells the control where it is. Once the heat pump is in place, it carries most of the heating and the elements become the backup. During defrost, the control turns on one or more elements according to the chosen setting.
For the thermostat, the manual calls for a 1 or 2 stage heating and cooling model, 24 VAC, and Conforto lists the furnace as compatible with smart thermostats. One point to keep in mind: sold alone, the furnace is not a heat pump and does not qualify for the LogisVert grant. Eligibility of a central heat pump is checked separately, based on the model chosen.
Electrical and location
Conforto calls for a 240 V single-phase circuit with an 85 A minimum circuit ampacity, a breaker of no more than 90 A and 4 AWG wire. In a house in Longueuil or Laval whose panel already feeds a range, a dryer and a water heater, this check happens before any order.
The 20 x 21 in Hiboy cabinet is multiposition: upright, downflow (with a non-combustible base on a combustible floor) or lying on its right side only.
ComfortMax and QuietComfort, like the whole series
According to CONFORTO’s manuals for the series, ComfortMax, turned on with a switch on the furnace, energizes only the elements needed to satisfy the thermostat call within 13 to 18 minutes: if the call ends in under 13 minutes, the next cycle starts with one element fewer; after 18 minutes, one element is added. QuietComfort (DIP switch D, off from the factory) cycles one element at 4-minute intervals for up to 3 hours to deliver preheated air in continuous fan mode, unless the thermostat calls for heat.
Our installation, from estimate to commissioning
AirGreen is a family business established in Montreal for more than fifteen years. Our RBQ licence 5645-9605-01 covers ventilation, refrigeration and electrical work: the furnace, its circuit and any coil are handled by the same team.
- Free on-site estimate and written quote
- Installation in the right position, connection to the plenums
- 240 V circuit, thermostat and DIP switch 3 setting
- ECM motor speed selected from the pressure measured in your ducts
- Commissioning and installation of the supplied 20 x 20 x 1 in filter
We work in Montreal, Laval, Longueuil, on the North Shore and on the South Shore.
If you are planning a central heat pump or new electric heat, ask for a free estimate. You receive a written quote, and AirGreen’s financing lets you spread the payments.
The furnace that backs up a central heat pump
The KHE-02-G015-H3 heats air with three 5 kW elements in two stages and distributes it with a 5-speed ECM motor. Paired with a central heat pump, it becomes the backup heat and takes over during defrost.
- Homes with ductwork adding a central heat pump of up to 3 tons
- Replacing an old furnace with an electric model with an ECM motor
- Duct systems that call for fine airflow adjustment
- Upright, downflow or horizontal right-side installations
Specifications
From the manufacturer’s documentation. A value the manufacturer does not publish is not listed.
What to know before installing
- Dedicated 240 V, 60 Hz, single-phase circuit: 85 A minimum ampacity, breaker of no more than 90 A and 4 AWG wire, per the manual.
- The coil goes on the supply plenum or the return; DIP switch 3 is set according to that location.
- Horizontally, right side only. In downflow on a combustible floor, a non-combustible base is required.
- Sold alone, the furnace is not a heat pump: it does not qualify for the LogisVert grant.
- 1 disposable 20 x 20 x 1 in filter
Manufacturer documents
Explore the range
Electric furnacesSee allSame brand
CONFORTOSee all
Frequently asked questions
Why choose the ECM motor version?
The 1/2 HP Ecotech ECM motor offers five speeds, from 600 CFM (MED-LOW at 0.5 in w.c.) up to 1,275 CFM (HIGH at 0.2 in w.c.). That range lets the airflow be matched to the ductwork and to the coil of an air conditioner or heat pump.
With a heat pump, what are the elements for?
They become the backup heat. During heat pump defrost, the control turns on one or more elements according to the DIP switch 3 setting.
What electrical circuit does it need?
A 240 V single-phase circuit with an 85 A minimum circuit ampacity, a breaker of no more than 90 A and 4 AWG wire, according to Conforto. We check your panel during the free estimate.
Is my thermostat compatible?
The manual calls for a 1 or 2 stage heating and cooling thermostat, 24 VAC, with terminals G, W1, W2, R, Y1, Y2 and C. Conforto lists it as compatible with smart thermostats.
Does the furnace qualify for LogisVert if I add a heat pump?
The furnace alone does not: it is not a heat pump. Eligibility of a central heat pump is checked separately, based on the model chosen.
A 15 kW Conforto Hiboy ECM, installed by AirGreen
Tell us about your project: we check the sizing, confirm availability and send you a quote. Or let our technicians install it for you.
Specifications from the manufacturer’s documentation, checked on October 19, 2026.
